A practical model to forecast the removal of micropollutants and other chemical Contaminants of Emerging Concern (CECs) in Activated Sludge (AS) systems was developed. Full-scale campaigns were carried out in three AS-WWTPs to evaluate the influence of the Mixed Liquor Suspended Solids (MLSS), Hydraulic Retention Time (HRT), and nitrification conditions. The previously observed sigmoidal correlation between CEC removal and biodegradation rate (kbio) was validated and a pseudo-first-order kinetic model was adapted to include, in addition to MLSS, HRT, kbio, a lumped-correction factor ‘a’. The transferability of the approach was further assessed using data from two WWTPs analysed in a previous study. The “a” value ranged from 0.19 (oxidation ditch at a nitrification rate of 5.8 g N-NH4/(kg VSS·d)) to 0.61 (A2O with 27 g N-NH4/(kg VSS·d)), suggesting a potential influence of reactor configuration and nitrification activity. This model allows WWTP managers optimizing AS performance and assessing its combination with advanced treatments needed to comply with the 80% removal efficiency for micropollutant indicators set by the revised Urban Wastewater Treatment Directive. Increasing MLSS from 2 to 5 g/L, increases AS removal from 23% to 45% and thus decreases ozone dose from 20 to 12 g/m3.
Environmental protection is increasingly critical in urban drainage management. While treated wastewater discharges are routinely monitored, the detection of unexpected or unauthorized drainage inflows into surface waters remains a challenge - especially as discharge points are often undocumented, irregular in time and space, occur under highly variable conditions, and monitoring conditions are far from standard. This is one of the emerging challenges of the 2024 European Directive on Urban Wastewater Treatment. Spectrophotometric techniques, more common in wastewater treatment plants, but less common in drainage systems and water bodies, allow for real-time, in-situ water quality monitoring, even for low-pollution discharges like treated effluents. This paper presents a novel, stepwise methodology for using spectroscopic techniques to locate and characterize urban discharges into water bodies, proposes a new Water Quality Label index, and comprehensively guides their use. Based on UV-Vis absorbance and Fluorescence spectroscopy, the application of visual data mining, differential spectra, isosbestic points, PCA, PLS and PARAFAC was demonstrated for this purpose. The methodology was applied in a case study of a treated wastewater discharge, with lower contaminant concentrations than those typically associated with unregistered illicit drainage discharges. By detecting subtle changes in river water composition, spectrophotometry helps to locate unknown discharges and support treatment plant operation. This approach improves the understanding of the interactions between urban drainage dynamics, treated wastewater discharges and receiving water quality and supports monitoring and control efforts and integrated urban water management, in line with the new EU Directive and paving the way to discharge limits based on receiving water quality.
A practical model to forecast the removal of contaminants of emerging concern (CECs) in activated sludge (AS) wastewater treatment plants (WWTPs) was developed. Eight full-scale campaigns were conducted in three AS-WWTPs (seven reactor datasets); 57 CECs were analyzed, 22 quantified in influent, and 13 CECs used for model calibration. The previously observed sigmoidal correlation between CEC removal and biodegradation rate (kbio) was validated and a pseudo-first-order kinetic model was adapted to include a lumped correction factor ‘a’ in addition to Mixed Liquor Suspended Solids (MLSS), Hydraulic Retention Time, and a CEC biodegradation constant (kbio). Model transferability was assessed using two WWTPs from a previous study. A global ‘a’ value provided a first approximation, while site-specific calibration improved R2 from 0.71–0.83 to 0.90–0.95. ‘a’ ranged from 0.19 (oxidation ditch; nitrification rate 5.8 g N-NH4/(kgVSS·d)) to 0.61 (anaerobic/anoxic/oxic AS system; 27 g N-NH4/(kg VSS·d)). The model supports AS operational scenario analysis and integration with advanced treatments to meet the 80% CEC (micropollutant) removal target of the revised Urban Wastewater Treatment Directive. In an illustrative ForecastTool scenario, increasing MLSS from 3 to 5 g/L increased AS removal of six CECs (from the twelve listed in the directive) from 32% to 45%, reducing the modeled ozone dose from 16 to 12 g/m3. The model requires site-specific calibration of ‘a’.