Cleyton Alvarenga

Prof. Dr. Cleyton Alvarenga

Institute of Agrarian Sciences, Federal University of Uberlândia, Uberlândia, Minas Gerais, Brazil
orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 December 2024 in Agriculture
Verified
Journal Article
Open access
SBSérgio Basílio
Sérgio Basílio
MJMarconi Ribeiro Furtado Júnior
Marconi Ribeiro Furtado Júnior
CACleyton Alvarenga
Cleyton Alvarenga
Edney Leandro da VitoriaEdney Leandro da Vitoria
Edney Leandro da Vitoria
BVBeatriz Costalonga Vargas
Beatriz Costalonga Vargas
Giuseppe ManettoGiuseppe Manetto
Giuseppe Manetto
Adjuvants alter the physical–chemical properties of pesticide formulations, influencing either the droplet size or drift phenomenon. Selecting the appropriate adjuvant and understanding its characteristics can contribute to the efficiency of Plant Protection Product (PPP) application. This reduces drift losses and promotes better deposition on the crop. The objective of this study was to evaluate the effects of four commercial adjuvants based on mineral oil (Agefix and Assist), vegetable oil (Aureo), and polymer (BREAK-THRU) on the physical–chemical properties (surface tension, contact angle, volumetric mass, electrical conductivity, and pH), droplet size, and drift, using pure water as the control treatment (no adjuvant). Surface tension and contact angle were measured with a DSA30 droplet shape analyzer, while droplet size measurements were determined through a laser diffraction particle analyzer (Malvern Spraytec), using a single flat fan spray nozzle (AXI 110 03) operating at 0.3 MPa. Drift reduction potential was evaluated inside a wind tunnel with an air speed of 2 m s−1. All adjuvants reduced surface tension and contact angle compared to water. volumetric median diameter (VMD) increased for Aureo, Assist, and Agefix, generating coarse, medium, and medium droplets, respectively, while BREAK-THRU formed fine droplets, similar to those generated by water. Aureo had the greatest reduction in Relative Span Factor (RSF), with a reduction of 30.3%. Overall, Aureo, Assist, and Agefix adjuvants significantly reduced the percentage of droplets 500 µm. Drift reduction potential was achieved for all adjuvants, with Aureo showing the highest reduction of 59.35%. The study confirms that selecting the appropriate adjuvant can improve PPP application and promote environmental sustainability in agricultural practices.

1 January 2023 in Brazilian Journal of Biology
Verified
Journal Article
Open access
CACleyton Alvarenga
Cleyton Alvarenga
GMG. S. M. Mundim
G. S. M. Mundim
ESEdson Aparecido Dos Santos
Edson Aparecido Dos Santos
RGRodrigo Bezerra De Araujo Gallis
Rodrigo Bezerra De Araujo Gallis
RZR. Zampiroli
R. Zampiroli
JPJ. R. Prado
J. R. Prado
Water magnetization and geoprocessing are increasingly utilized tools in weed management. Our objective was to study the influence of water magnetization on herbicide efficiency and to verify whether there is a relationship between control scores and the normalized difference vegetation index (NDVI). In the laboratory experiment, water was subjected to magnetization and evaluated with respect to four characteristics. In the field experiment, plots of Brachiaria grass were subjected to treatments in a factorial scheme (6 × 2 + 1). Six herbicidal factors (doses of glyphosate and glyphosate + 2,4-D) and the magnetization or absence of magnetization of the spray solution were evaluated and compared against the control treatment (without spraying). Weed control assessments were carried out six times. Images were obtained using an embedded multispectral camera to determine the NDVI values. Data related to water characteristics were analyzed using the t test. Weed control and NDVI data were subjected to analysis of variance and are presented in regression graphs. Dispersion analysis of NDVI data was performed according to the control scores. The magnetization process decreased the pH of the water and increased the surface tension, but it did not influence the control scores or the NDVI. As the glyphosate dose was increased, the control scores were higher and the NDVI values were lower. Magnetized water did not affect the biological efficiency of the herbicides, and there was a strong correlation between the control scores and the NDVI values.

9 March 2022 in Acta Scientiarum. Agronomy
Verified
Journal Article
Open access
PDF file
RZRenan Zampiroli
Renan Zampiroli
MPMatheus Vilhena Parenti
Matheus Vilhena Parenti
CACleyton Alvarenga
Cleyton Alvarenga
FCFernando Juari Celoto
Fernando Juari Celoto
JCJoão Paulo Arantes Rodrigues da Cunha
João Paulo Arantes Rodrigues da Cunha
PRPaula Cristina Natalino Rinaldi
Paula Cristina Natalino Rinaldi
Chemical control is essential for efficient pest management in coffee crops. Application technologies should safely deliver insecticides to the target whilst protecting the environment, insecticide applicators, and consumers. To achieve these goals, application volumes, hydraulic nozzles, and application techniques should be evaluated. This study assessed the biological efficiency of different spray volumes and spray nozzles used to apply insecticides to control coffee berry borer (Hypothenemus hampei) populations. We applied insecticides using a hydropneumatic sprayer with and without an electrostatic spraying system. The experiment followed a randomized block factorial design (2 × 2 + 1) and included two types of spray nozzles [a hollow cone spray nozzle (JA1) and a hollow cone spray nozzle with air induction (TVI)], two spray volumes (200 and 400 L ha-1), one additional treatment (SPE2 nozzle with a 200 system 200 L ha-1), and six replicates. We assessed the control efficiency of the different application methods by evaluating the percentage of fruits damaged 20 and 40 days after the date of application. The spray volume did not affect the biological efficiency of pest control, and the lower spray volume (200 L ha-1) was effective in the control of coffee berry borers. Application of insecticides using coarse droplets was more efficient than the application using very fine and fine droplets. The TVI hydraulic spray nozzle effectively controlled coffee berry borers at 200 and 400 L ha-1. The electrostatic application system performed similarly to the conventional system in terms of the control of the coffee berry borers, and was less efficient than the conventional system under some operational conditions.

23 July 2024 in Agriengineering
Verified
Journal Article
Open access
PDF file
JCJoão Paulo Arantes Rodrigues da Cunha
João Paulo Arantes Rodrigues da Cunha
LLLuana de Lima Lopes
Luana de Lima Lopes
CACaio Oliveira Rodrigues Alves
Caio Oliveira Rodrigues Alves
CACleyton Alvarenga
Cleyton Alvarenga
Remotely piloted aircraft (RPAs) have been increasingly used for crop protection in coffee plantations. However, the applications can result in low spray deposition on leaves and higher product losses between rows compared to ground airblast sprayers. This study aimed to evaluate the spray deposition on the coffee canopy and potential losses to the soil during application with an RPA and an airblast sprayer at varying spray volumes. The experiment comprised four spray treatments: RPA at 10 L ha−1 and 20 L ha−1, and airblast sprayer at 200 L ha−1 and 300 L ha−1. Leaf deposition was quantified by measuring a tracer on leaves from the lower and upper parts of the coffee canopy using spectrophotometry. Spray losses to the soil were measured by analyzing tracer residues on Petri dishes positioned within the inter-rows and beneath the coffee canopy. Statistical process control was used to analyze spray deposition quality in the study area. Ground-based airblast spraying resulted in the highest overall canopy deposition, while RPA spraying led to greater losses within the inter-rows. No significant difference was observed in spray runoff beneath the canopy between ground-based and aerial applications. Leaf deposition exhibited random variability across all application methods. Therefore, application stability, control, and spray quality standards were maintained.

10 April 2025 in Agriengineering
Verified
Journal Article
Open access
PDF file
CSCaroline Lemes Silva
Caroline Lemes Silva
JCJoão Paulo Arantes Rodrigues da Cunha
João Paulo Arantes Rodrigues da Cunha
CACleyton Alvarenga
Cleyton Alvarenga
RZRenan Zampiroli
Renan Zampiroli
The process of droplet formation during spraying is influenced by several factors, including the nozzle type and the use of adjuvants. This study aimed to investigate the effect of adding adjuvants to spray solutions using different nozzles, with a focus on droplet spectra, and to examine the impact of the contact angle and the surface tension on this process. The surface tension and contact angle were evaluated using a droplet shape analyzer. The experiment was conducted in a completely randomized design (CRD) using four treatment solutions: water alone and water mixed with three different types of adjuvants, including fatty acid esters (vegetable oil-based), polyether–polymethyl, and polydimethyl-siloxane. The droplet spectra (volume median diameter, relative amplitude, and droplets smaller than 100 µm) were assessed using a particle size analyzer. A CRD with a 4 × 2 factorial scheme was used to assess the effects of the four treatment solutions and two flat-fan nozzles (ULD 120-02 with air induction and LD 110-02 without air induction technology). The polyether–polymethyl considerably reduced the contact angle and surface tension (226% and 180%, respectively, in relation to water). However, it did not homogenize the droplet spectra or reduce the drift risk. The vegetable oil-based adjuvant increased the droplet size when the standard flat-fan nozzle was used. No significant correlation was found between the surface tension and contact angle regarding the droplet spectra parameters. The effect of adjuvants on the droplet spectra was found to be dependent on the nozzle type, which prevents generalizations about the implications of their use.

5 June 2024 in Agriengineering
Verified
Journal Article
Open access
PDF file
JCJoão Paulo Arantes Rodrigues da Cunha
João Paulo Arantes Rodrigues da Cunha
LLLuana de Lima Lopes
Luana de Lima Lopes
CACleyton Alvarenga
Cleyton Alvarenga
The application of pesticides using unmanned aerial vehicles (UAVs) has grown, but there is a lack of information to support more efficient applications. Using a DJI AGRAS-MG-1P octocopter equipped with different spray tips, this study sought to explore spray deposition (leaves and fruit) and efficacy of chlorpyrifos on control of coffee berry borer at different spray volumes and flight heights. The study was conducted in an Arabica coffee plantation. The study consisted of eight treatments and four replications in a 2 × 2 × 2 factorial scheme: two flight heights (1.5 and 3.0 m), two spray tips (hollow cone and flat fan), and two spray volumes (10 and 15 L ha−1). Deposition was assessed by detecting a tracer in the coffee leaves and fruit using spectrophotometry. The coffee berry borer-control efficacy trial was conducted in two areas by evaluating the percentage of damaged fruit 60 days after two insecticide applications. The flight height of 1.5 m promoted higher spray deposition on leaves and fruit and a lower incidence of damaged fruit. Flat fan spray tips resulted in higher spray deposition on the leaves, not interfering with the deposition on fruit or the coffee berry borer control. Increasing the spray volume from 10 to 15 L ha−1 did not increase spray deposition on coffee leaves and fruit. Chlorpyrifos applied via UAVs reduced the incidence of coffee berry borer.