Regulations R(EC)661/2009 and R(EC)1222/2009 established environmental requirements for new tires and their labeling, not applicable in principle to retreaded tires. However, in anticipation of future revisions, different studies were promoted, mainly oriented to truck tires, the main market for retreading. Two lines of research were opened at UMH, focused respectively on the study of rolling resistance and rolling noise. Los Reglamentos R(CE)661/2009 y R(CE)1222/2009, establecieron requisitos medioambientales para los neumáticos nuevos y su etiquetado, no aplicables en principio a los neumáticos recauchutados. No obstante, en previsión de futuras revisiones, se promovieron diferentes estudios orientados fundamentalmente a los neumáticos de camión, principal mercado del recauchutado. En la UMH se abrieron dos líneas de investigación centradas respectivamente en el estudio de la resistencia a la rodadura y el ruido de rodadura.
This study addresses the status and proposes key aspects relevant to refining of the procedure for the Spanish National Inspection of Vehicles relative to tractor service brakes, specifically focusing on obtaining the average deceleration. The current inspection method lacks a clear definition of the calculation process for average deceleration in the Spanish Official Manual of Procedures of Inspection of Vehicles. This lack of clarity results in varying outcomes and potential acceptance or rejection of the inspection based on the selected equipment and procedure. To address this issue, a comprehensive series of tests were conducted on different vehicles, using various equipment and calculation methods. The objective was to derive meaningful conclusions regarding the calculation method, measuring equipment, and other relevant factors. This study reveals the inadequacy of the current average deceleration calculation method as outlined in the official inspection manual. The findings highlight the crucial role of accurate equipment selection, appropriate calculation methods, and skilled personnel experience in ensuring reliable and consistent results. To address this, a new standardized procedure is proposed to streamline the process of obtaining the average deceleration in the inspection of tractor service brakes. The recommended procedure encompasses the use of a secure, well-defined track, clearly marked acceleration and braking points, a GPS decelerometer, a portable or on-track speedometer, and data processing that excludes the initial and final sections of the deceleration curve. Furthermore, this study highlights the need to update the acceptance thresholds for the inspection, as the current thresholds may no longer align with the proposed procedure. A revision of these thresholds is suggested to establish new criteria that are more appropriate and in line with the proposed method and for tractors manufactured after 01/01/2016. Keywords: Tractors, brake testing, vehicle inspection, road safety.
Highly deformable adhesive materials are increasingly employed in engineering applications where flexibility, energy dissipation and damage tolerance are required. The mechanical characterisation of these materials, however, presents significant challenges due to their pronounced non-linear behaviour, large deformations, and, in many cases, time-dependent effects. This paper provides a critical review of experimental, constitutive and numerical approaches used for the characterisation of highly deformable adhesive materials, considered here as bulk materials independently of a specific joint configuration. The review covers mechanical testing methods under large strains, hyperelastic and visco-hyperelastic constitutive models, and the application of fracture mechanics concepts and numerical techniques as exploratory tools for material analysis and comparison. Particular attention is given to the capabilities and limitations of the different approaches, their domains of applicability and the assumptions involved in their use. By highlighting current practices, open challenges and recent developments, this work aims to support the selection of appropriate characterisation methodologies and modelling strategies for highly deformable adhesive materials.