Electrochemical and Chemical Technologies Laboratory, National Institute for Research and Development in Electrochemistry and Condensed Matter – INCEMC, Timişoara, Timiş, Romania
Dr. Dan Cristian Tanasie
Electrochemical and Chemical Technologies Laboratory, National Institute for Research and Development in Electrochemistry and Condensed Matter – INCEMC, Timişoara, Timiş, Romania
The present study investigates the potential of a new lignocellulosic adsorbent material obtained from mature coltsfoot (Tussilago farfara) leaves for the removal of methylene blue from aqueous solutions. The material was obtained after minimal processing of the leaves, without chemical or thermal treatment. The material was first characterized using several specific techniques (FTIR, color analysis). Then, the mechanism of the adsorption process was investigated through studies related to adsorption equilibrium, kinetics, and thermodynamics. The adsorption process is described by the Sips isotherm and the general kinetic model, while the thermodynamic parameters suggest that physical adsorption is the primary mechanism responsible for dye retention. The Taguchi method was used to optimize the adsorption conditions and to identify the most influential controllable factor. ANOVA was used to calculate the percentage contribution of each controllable factor to the dye removal efficiency. pH had the greatest influence on the process (87.78%), while temperature had the least effect (0.16%). The maximum adsorption capacity determined was 278.1 mg/g, being higher than other similar adsorbents. All the results show that coltsfoot (Tussilago farfara) leaves are a very cheap, environmentally friendly, and effective adsorbent for the removal of methylene blue dye from aqueous solutions.
This research evaluates the feasibility of using a lignocellulosic biosorbent prepared from mature leaves of Asplenium scolopendrium (produced through simple mechanical processing of the leaves, without applying any chemical modification or heat treatment) for the removal of methylene blue from water. Before and after adsorption the material was characterized using SEM technique and color analysis. Subsequently, the adsorption behavior was analyzed by examining equilibrium, kinetic, and thermodynamic aspects of the process. The equilibrium data were best represented by the Sips isotherm model, while the adsorption rate followed the Avrami model. Thermodynamic evaluation indicated that the retention of the dye occurs predominantly through a physical adsorption mechanism, while a minor contribution from chemisorption may be present, slightly enhancing the overall dye uptake. Process optimization was performed using the Taguchi experimental design, which also allowed the identification of the most significant operational variable. In addition, analysis of variance (ANOVA) was applied to quantify the contribution of each factor affecting dye removal efficiency. Among the investigated variables, time showed the strongest influence (72.65%), whereas temperature had a negligible effect (1.33%). The maximum adsorption capacity reached 174.1 mg/g, surpassing the performance of several comparable biosorbents reported in the literature. Overall, the findings demonstrate that Asplenium scolopendrium (hart’s-tongue fern) leaves represent an inexpensive, sustainable, and efficient material for eliminating methylene blue from aqueous solutions.