We report observations of saturation effects in a Ce:LuAG and Eu-doped nitride ceramic phosphor for conversion of blue laser light for white light generation. The luminous flux from the phosphors material increases linearly with the input power until saturation effects limit the conversion. It is shown that the temperature of the phosphor layer influences the saturation power level and the conversion efficiency. It is also shown that the correlated color temperature (CCT), phosphor conversion efficiency and color rendering index (CRI) are dependent both on the incident power and spot size diameter of the illumination. A phosphor conversion efficiency up to 140.8 lm/W with CRI of 89.4 was achieved. The saturation in a ceramic phosphor, when illuminated by high intensity laser diodes, is estimated to play the main role in limiting the available luminance from laser-based lighting systems.

We have theoretically investigated the influence of antireflective sub-wavelength structures on a monolithic white light-emitting diode (LED). The simulation is based on the rigorous coupled wave analysis (RCWA) algorithm, and both cylinder and moth-eye structures have been studied in the work. Our simulation results show that a moth-eye structure enhances the light extraction efficiency over the entire visible light range with an extraction efficiency enhancement of up to 26 %. Also for the first time to our best knowledge, the influence of sub-wavelength structures on both the color rendering index (CRI) and the correlated color temperature (CCT) of the monolithic white LED have been demonstrated. The CRI of the monolithic white LED could be improved from 92.68 to around 94 by applying a cylinder structure, and the CCT could be modified in a very large range with appropriate design of the cylinder structure.

We explored an alternative light emitting diode (LED) - based solution to replace the existing yellow fluorescent light tubes (YFT) used in photolithography rooms. A no-blue LED lamp was designed and a prototype was fabricated. For both solutions, the spectral power distribution (SPD) was measured, the colorimetric values were calculated, and a visual comparison using Gretagmacbeth colorcharts was performed. The visual comparison showed that the LED bulb was better to render colors despite a low color rendering index (CRI). Furthermore, the LED bulb was tested in a photolithography room and there was no exposure to the photoresist even after 168 hours illumination.

Alzheimer’s disease (AD) not only takes an emotional toll on the individual with the disease, their families, relatives, and caretakers, it also has immense socioeconomic consequences on the health care system and society. Moreover, the socioeconomic consequences are expected to increase significantly, thus reducing the social and economic cost of AD is of high importance. Recently, exposure to 40 Hz stroboscopic light therapy, for one hour a day, resulted in slowing the progression of AD in mice and has a considerable potential for treatment in humans. However, exposure to such stroboscopic light carries its own consequences being that it is difficult to implement in a patient’s daily routine, irksome to use, and can cause visual discomfort which may result in a lack of patient adherence. Here, we demonstrate a novel technology based on controlling multiple single-color LEDs to produce white light where its spectral composition alternates at a given modulation frequency without visible flicker. We coin this technique as Invisible Spectral Flicker (ISF). We present 40 Hz invisible spectral flicker light as a potential alternative in reducing discomfort compared to 40 Hz stroboscopic light, whilst still entraining oscillations in various areas of the brain. Furthermore, we demonstrate a distinct way to generate a 40 Hz metameric light source with the presented color mixing scheme, and validate that the CIE 1931 (x, y) coordinates match for two different spectral power distributions. Finally, we illustrate the light characteristics of seven 40 Hz color fusion light sources and two 40 Hz stroboscopic light sources. The technology presented here will lead to new, and hopefully improved, designs of light therapy systems for the treatment of Alzheimer’s and dementia.