This study deals with the investigation of boundary layer flow of a fourth grade fluid and heat transfer over an exponential stretching sheet. For analyzing two heating processes, namely, (i) prescribed surface temperature (PST), and (ii) prescribed heat flux (PHF), the temperature distribution in a fluid has been considered. The suitable transformations associated with the velocity components and temperature, have been employed for reducing the nonlinear model equation to a system of ordinary differential equations. The flow and temperature fields are revealed by solving these reduced nonlinear equations through an effective analytical method. The important findings in this analysis are to observe the effects of viscoelastic, cross-viscous, third grade fluid, and fourth grade fluid parameters on the constructed analytical expression for velocity profile. Likewise, the heat transfer properties are studied for Prandtl and Eckert numbers.
The extension of Transmission network is highly important because of the power transfer capability impingement of transmission lines on power market business but at present moment the new extension of the transmission network is confined because of the substantial contemplation, financial issues and potential health trappings of the electromagnetic field. This consistently growing need for electric power has formed it necessary to employ the accessible transmission network assets. The implementation of flexible AC transmission system (FACTS) might be fruitful choice to enhance power flow capacity (PFC) in existing transmission network. FACTS devices diverse the tracks of exchanged power over transmission lines through changing bus voltage angle, the reactance of transmission lines. In this work, a miniature of Unified Power Flow Controller is modified with Fuzzy Logic (FL) based shunt and serial controllers to increase the power network stability. Fuzzy control is employed in the control scheme of UPFC and Pulse width modulation. A critical case of 3 phase fault occurrence in a power system has been studied. The results are compared with the presence and absence of UPFC. Simulations have been accomplished on MATLAB/Simulink software. To present the effectiveness of purposed controller, the obtained outcomes have been also compared with PID controller. It reveals that the Fuzzy Logic based UPFC has the best performance over PID Controller.
With increasing demand of energy, air pollution is on rising. To mitigate this issue, combined production of cooling, heat and power (CCHP) system getting worldwide attention due to its effectiveness. A case study recommends that CCHP system should be run under the optimal scheme. This paper focuses on the optimal scheduling and analysis of CCHP system in comparison to the separate production of cooling, heat and power (SPCHP) system. In this article, two different model designs are proposed to ensure electric, cooling and heating loads in summer and winter to maximize the energy saving by reducing the total cost and carbon dioxide emission. An interior point (IP) based algorithm is designed in Matlab for optimal energy flow. The IP is a fascinating method because of its convergence time, robustness, ease of handling the inequality constraints and few numbers of iterations to the optimum power flow problems. Furthermore, the analysis is performed in order to exhibit how the economic, energetic and environmental behavior of CCHP system changes under different conditions as compared to separate production of cooling, heat, and power (SPCHP) system. Finally, results show that overall performance of CCHP system is better than SPCHP systems.