Enyioma Chimaijem Okpara

Dr. Enyioma Chimaijem Okpara

MaSIM
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 September 2020 in Materials
Verified
Journal Article
Open access
PDF file
EOEnyioma Chimaijem Okpara
Enyioma Chimaijem Okpara
OFOmolola ESTHER Fayemi
Omolola ESTHER Fayemi
El-Sayed M. SherifEl-Sayed M. Sherif
El-Sayed M. Sherif
HJHarri Junaedi
Harri Junaedi
Eno EbensoEno Ebenso
Eno Ebenso
Zinc Oxide (ZnO) nanoparticles were prepared using a simple green synthesis approach in an alkaline medium, from three different extracts of citrus peels waste. The synthesized nano-crystalline materials were characterized by using ultraviolet-visible spectroscopy (UV-vis), x-ray powder diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), energy-dispersive x-ray spectroscopy (EDS), environmental scanning electron microscopy (ESEM), and transmission electron microscopy (TEM). UV-vis analysis of the nanoparticles showed broad peaks around 360 nm for the ZnO NPs (Zinc oxide nanoparticles) from three citrus peels’ extracts. ZnO NPs exhibited Zn–O band close to 553 cm−1, which further verified the formation of the ZnO NPs. A bandgap of 3.26 eV, 3.20 eV and 3.30 eV was calculated for the ZnO NPs from grape (ZnO NPs/GPE), lemon (ZnO NPs/LPE), and orange (ZnO NPs/OPE) peels extract, respectively. The average grain sizes of the ZnO nanoparticles were evaluated to be 30.28 nm, 21.98 nm, and 18.49 nm for grape (ZnO NPs/GPE), lemon (ZnO NPs/LPE), and orange (ZnO NPs/OPE) peel extract, respectively. The surface morphology and sizes of the nanoparticle were confirmed by ESEM and TEM analysis, respectively. Furthermore, the zeta potential of the as-prepared ZnO NPs from OPE, LPE, and GPE was −34.2 mV, −38.8 mV, and −42.9 mV, respectively, indicating the high stability of the nanoparticles. Cyclic voltammetric properties of the synthesized nanoparticles were investigated across extracts, and the results showed that the citrus peels extracts (CPE) mediated ZnO NPs modified screen plate carbon (SPC/ ZnO NPs/CPE) electrodes exhibited enhanced catalytic properties when compared with the bare SPCE. The electroactive areas computed from the enhancement of the bare SPCE was approximately three times for SPCE/ ZnO NPs/LPE, and SPCE/ZnO NPs/GPE, and two times for SPCE/ZnO NPs/OPE, higher than that of the bare SPCE. Comparison across the extracts suggested that the catalytic properties of the nanoparticles were unique in ZnO NPs from GPE.

14 May 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
EOEnyioma Chimaijem Okpara
Enyioma Chimaijem Okpara
NCNde Samuel Che
Nde Samuel Che
OFOmolola ESTHER Fayemi
Omolola ESTHER Fayemi
Eno EbensoEno Ebenso
Eno Ebenso
The need for constant assessment of river water qualities for both aquatic and other biological survival has emerged a top priority, due to increasing exposure to industrial pollutants. A disposable screen print carbon electrode was modified with a conductive polymer (PANI) and Zn and/or Cu oxides NPs, obtained through bioreduction in citrus peel extracts (lemon and orange), for ultra-sensitive detection of PB2+, in the Crocodile River water sample. The synthesized materials were characterized with Fourier-transform infra-red spectroscopy (FTIR), ultra-violet visible spectroscopy (UV-Vis), and scanning electron microscopy (SEM). The SPC-modified electrodes designated as SPCE/LPE/BiONPs/PANI and SPCE/OPE/BiONPs/PANI were characterized using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) and eventually deployed in the electrochemical detection of PB2+ in water using square wave voltammetry (SWV) technique. The electrochemical responses of the modified electrodes for both CV and EIS in 0.1 M HCl demonstrated enhanced performance relative to the bare SPCE. A detection and quantification limit of 0.494 ppb and 1.647 were obtained at SPCE/LPE/BiONPs/PANI, respectively, while a detection and quantification limit of 2.79 ppb and 8.91 ppb, respectively, were derived from SPCE/OPE/BiONPs/PANI. The relative standard deviations (RSD) for SPC electrode at a 6.04 µM PB2+ analyte concentration was 4.76% and 0.98% at SPCE/LPE/BiONPs/PANI and SPCE/LPE/BiONPs/PANI, respectively. The effect of copper, zinc, iron, cobalt, nickel, and magnesium on the stripping peaks of PB2+ at SPCE/OPE/BiONPs/PANI, showed no significant change except for cobalt, with about 17.67% peak current drop. The sensors were assessed for possible determination of PB2+ in spiked river water samples. The average percentage recovery and RSD calculated were 94.25% and 3.74% (n = 3) at SPCE/LPE/BiONPs/PANI and, 96.70% and 3.71% (n = 3) at SPCE/OPE/BiONPs/PANI, respectively. Therefore, the fabricated sensor material could be used for environmental assessment of this highly toxic heavy metal in the aquatic system

13 January 2024 in Applied Materials Today
Verified
Journal Article
Open access
EOEnyioma Chimaijem Okpara
Enyioma Chimaijem Okpara
OWOlanrewaju B. Wojuola
Olanrewaju B. Wojuola
TQTaiwo W. Quadri
Taiwo W. Quadri
Craig BanksCraig Banks
Craig Banks

1 October 2022 in Environmental Research Communications
Verified
Journal Article
Open access
EOEnyioma Chimaijem Okpara
Enyioma Chimaijem Okpara
BSBoikanyo E Sehularo
Boikanyo E Sehularo
OWOlanrewaju B Wojuola
Olanrewaju B Wojuola
There is an increasing dependence on freshwater sources for various human activities because of population growth and rising industrialization across the globe. Meanwhile, the safety of available freshwater is threatened by the massive generation of waste from increasing domestic and industrial activities. The need for continuous assessment of the quality of the environmental water available has become a crucial research concern. The conventional techniques commonly used are not sufficient to meet the expanding demand for real-time, rapid, low-cost, reliable, and sensitive water quality monitoring (WQM). The use of wireless sensor networks (WSN) has been proposed by various researchers as a sustainable substitute for the traditional processes of monitoring water quality. In this work, an array of the literature on the practical applications of the networks in the assessment of vital water quality parameters such as pH, turbidity, temperature, dissolved oxygen (DO), chlorine content, etc., were surveyed and analyzed. Various technologies such as machine learning, blockchain, internet of things (IoT), deep reconstruction model, etc., were incorporated with WSN for real-time monitoring of water quality, data acquisition, and reporting for a broad range of water bodies. The survey shows that the networks are comparatively affordable and allow remote, real-time, and sensitive measurement of these parameters with minimal human involvement. The use of a low-power wide area network (LPWAN) was also introduced to solve a major problem of power supply often associated with the use of WSN. Recent developments also showed the capacity of WSN to assess simultaneously multiple water quality parameters from several locations using unmanned aerial vehicles (UAV). However, the networks rely on established parameters to indicate a compromise in water quality, but in most cases, fail to identify which pollutant species are responsible.

1 March 2023 in Materials Research Express
Verified
Journal Article
Open access
EOEnyioma Chimaijem Okpara
Enyioma Chimaijem Okpara
SAStephen A Akinola
Stephen A Akinola
OFOmolola ESTHER Fayemi
Omolola ESTHER Fayemi
This study described the antimicrobial activities of waste biomass-mediated Cu2O/ZnO bi-oxide (BiO) nanocomposites; The Orange peels extract (OPE), and lemon peels extract (LPE), were used to synthesize the bioxide nanoparticles (NPs) designated as OPE/BiONPs, and LPE/BiONPs respectively, and characterized with x-ray diffraction (XRD), and zeta potential (ZP); The average crystalline sizes computed were 11.57 nm and 13.36 nm for OPE/BiONPs and LPE/BiONPs respectively; The zeta potentials values were −36.8 mV, and −35.5 mV for OPE/BiONPs, and LPE/BiONPs respectively; Polyacrylonitrile (PAN) polymer and the BiONPs blends were electrospun into nanofibers to get unblended PAN nanofiber (NF), OPE/BiO NF, and LPE/BiO NF; Scanning electron microscopic (SEM) analysis was used to determine the morphology of the electrospun nanocomposites; The NF, the OPE/BiO NF, and LPE/BiO NF possessed average diameters of 833 ± 125, 282.86 ± 29, and 558.76 ± 81 nm respectively; The nanofibers were examined for their antimicrobial activities against five (5) pathogens of public health significance comprising Gram-positive (Bacillus cereus and Enterococcus faecalis) and Gram-negative (Salmonella enteritidis, Escherichia coli, and Vibrio cholerae) bacteria, using the standard dilution microplate-method; The synthesized nanomaterials showed various levels of inhibitory activities against the target pathogens. The LPE/BiO NPs exhibited 98% inhibition to the growth of Enterococcus faecalis at a concentration of 810 μg ml−1, while OPE/BiO NPs showed 71% inhibition to the Escherichia coli at a concentration of 243 μg ml−1. The LPE/BiONF had 72% inhibition of S. enteritidis at MIC of 2.7 mg ml−1. The antimicrobial activities of CPE/BiONPs, LPE/BiONF and their NFCs could have a comparative advantage against commercial antibiotics and hence could be used in the control of waterborne pathogens.