Ernee Muhamad

Dr. Ernee Muhamad

Department of Chemistry, Faculty of Science, Universiti Putra Malaysia, 43400, Serdang, Selangor

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 December 2018 in Catalysts
Verified
Journal Article
Open access
PDF file
UNUsman Nda-Umar
Usman Nda-Umar
IRIrmawati Ramli
Irmawati Ramli
Yun Hin Taufiq-YapYun Hin Taufiq-Yap
Yun Hin Taufiq-Yap
EMErnee Muhamad
Ernee Muhamad
The depletion of fossil fuels has heightened research and utilization of renewable energy such as biodiesel. However, this has thrown up another challenge of significant increase in its byproduct, glycerol. In view of the characteristics and potentials of glycerol, efforts are on the increase to convert it to higher-value products, which will in turn improve the overall economics of biodiesel production. These high-value products include biofuels, oxygenated fuel additives, polymer precursors and other industrial bio-based chemicals. This review gives up-to-date research findings in the conversion of glycerol to the above high-value products, with a special focus on the performance of the catalysts used and their challenges. The specific products reviewed in this paper include hydrogen, ethanol, methanol, acetin, glycerol ethers, solketal, acetal, acrolein, glycerol carbonate, 1,3-propanediol, polyglycerol and olefins.

3 June 2017 in Nanomaterials
Verified
Journal Article
Open access
PDF file
NDNoraniza Ahmad Daud
Noraniza Ahmad Daud
BCBuong Woei Chieng
Buong Woei Chieng
NINor Azowa Ibrahim
Nor Azowa Ibrahim
ZTZainal Abidin Talib
Zainal Abidin Talib
EMErnee Muhamad
Ernee Muhamad
ZAZurina Zainal Abidin
Zurina Zainal Abidin
A gamma-ray irradiation technique was used to functionalize graphene oxide (GO) with alkylamines of various alkyl chain lengths. Functionalization of the alkyl chains onto the GO was confirmed by nuclear magnetic resonance (1H NMR), Fourier transform infrared (FTIR), and X-ray diffraction (XRD). FTIR of the functionalized GO showed the appearance of significant peaks around 2960–2850 cm−1 (–CH2) which came from long alkyl chains, together with a peak around 1560–1450 cm−1, indicating the formation of C–NH–C. XRD showed an additional diffraction peak at a lower 2θ angle, indicating that the intercalation of the alkylamine was successful. The effects on the morphological and thermal properties of GO functionalized with alkyl chains of various lengths were investigated. Scanning electron microscopy (SEM) analysis showed an increase in surface roughness when the alkyl chain length was increased. The addition of alkyl chains on GO surfaces significantly improved the thermal stability of the GO, suggesting that these surfaces have great potential for use as a hydrophobic material in industry.

23 December 2022 in Optical Materials
Verified
Journal Article
Closed access
YIYusuf Ibrahim
Yusuf Ibrahim
AAAbdul Halim Abdullah
Abdul Halim Abdullah
SRSuraya Abdul Rashid
Suraya Abdul Rashid
EMErnee Muhamad
Ernee Muhamad

10 November 2020 in Molecules
Verified
Journal Article
Open access
PDF file
UNUsman Nda-Umar
Usman Nda-Umar
IRIrmawati Ramli
Irmawati Ramli
EMErnee Muhamad
Ernee Muhamad
NANorsahida Azri
Norsahida Azri
Yun Hin Taufiq-YapYun Hin Taufiq-Yap
Yun Hin Taufiq-Yap
In this study, an optimized mesoporous sulfonated carbon (OMSC) catalyst derived from palm kernel shell biomass was developed using template carbonization and subsequent sulfonation under different temperatures and time conditions. The OMSC catalyst was characterized using acid-base titration, elemental analysis, XRD, Raman, FTIR, XPS, TPD-NH3, TGA-DTA, SEM, and N2 adsorption–desorption analysis to reveal its properties. Results proved that the OMSC catalyst is mesoporous and amorphous in structure with improved textural, acidic, and thermal properties. Both FTIR and XPS confirmed the presence of -SO3H, -OH, and -COOH functional groups on the surface of the catalyst. The OMSC catalyst was found to be efficient in catalyzing glycerol conversion to acetin via an acetylation reaction with acetic acid within a short period of 3 h. Response surface methodology (RSM), based on a two-level, three-factor, face-centered central composite design, was used to optimize the reaction conditions. The results showed that the optimized temperature, glycerol-to-acetic acid mole ratio, and catalyst load were 126 °C, 1:10.4, and 0.45 g, respectively. Under these optimum conditions, 97% glycerol conversion (GC) and selectivities of 4.9, 27.8, and 66.5% monoacetin (MA), diacetin (DA), and triacetin (TA), respectively, were achieved and found to be close to the predicted values. Statistical analysis showed that the regression model, as well as the model terms, were significant with the predicted R2 in reasonable agreement with the adjusted R2 (<0.2). The OMSC catalyst maintained excellent performance in GC for the five reaction cycles. The selectivity to TA, the most valuable product, was not stable until the fourth cycle, attributable to the leaching of the acid sites.

14 October 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
UNUsman Nda-Umar
Usman Nda-Umar
IRIrmawati Ramli
Irmawati Ramli
EMErnee Muhamad
Ernee Muhamad
NANorsahida Azri
Norsahida Azri
UAUCHENNA FIDELIS AMADI
UCHENNA FIDELIS AMADI
Yun Hin Taufiq-YapYun Hin Taufiq-Yap
Yun Hin Taufiq-Yap
Glycerol, a polyhydric alcohol, is currently receiving greater attention worldwide in view of its glut in the market occasioned by the recent upsurge in biodiesel production. The acetylation of glycerol to acetin (acetyl glycerol) is one of the many pathways of upgrading glycerol to fine chemicals. Acetin, which could be mono, di, and or triacetin, has versatile applications in the cosmetics, medicines, food, polymer, and fuel industries as a humectant, emulsifier, plasticizer, and fuel additive and so it is of high economic value. Given the critical role of catalysts in green chemistry, this paper reports the influence of the different heterogeneous catalysts used in glycerol acetylation. It also reviewed the influence of catalyst load, temperature, molar ratio, and the time on the reaction.

1 April 2021 in Catalysts
Verified
Journal Article
Open access
PDF file
NONur Syazwani Osman
Nur Syazwani Osman
SSSiti Norhasimah Sulaiman
Siti Norhasimah Sulaiman
EMErnee Muhamad
Ernee Muhamad
HMHayati Mukhair
Hayati Mukhair
STSin Tee Tan
Sin Tee Tan
AAAbdul Halim Abdullah
Abdul Halim Abdullah
In this work, the photocatalytic performance of Ag3PO4, Nb2O5 and Ag3PO4/Nb2O5 hybrid photocatalysts to degrade methyl orange dye, MO, in an aqueous solution under visible light irradiation was evaluated. The Ag3PO4 and Ag3PO4/Nb2O5 photocatalysts, with various Ag to Nb molar ratios, were prepared using a facile precipitation method. The photocatalysts were characterized by X-ray diffraction, UV–Visible, X-ray Photoelectron, and Photoluminescence spectroscopies. Upon the addition of Ag3PO4, the band gap energy of Nb2O5 decreased from 3.0 eV to 2.7 eV, indicating the possible use of the Ag3PO4/Nb2O5 hybrid photocatalysts under visible light irradiation. All of the prepared Ag3PO4/Nb2O5 catalysts exhibited higher photocatalytic performance than Ag3PO4 in degrading methyl orange dye under 23-watt visible light irradiation. The Ag3PO4/Nb2O5 catalyst, with a mole ratio of 2:1, exhibited the fastest MO degradation rate of 7.3 × 10−2 min−1, which is twice faster than that of Ag3PO4. The catalyst also shows better stability, as it is reusable for up to six experimental cycles while maintaining its photocatalytic activity above 60%.