In this study, we propose a novel piezoresistive micro-electromechanical systems (MEMS) microphone that exploits the piezoresistive effect of a field-effect transistor (PrFET microphone). This study is the first attempt to demonstrate that the piezoresistive effect of FET channels can be applied as a microphone sensing method. The PrFET microphone features a single diaphragm with a FET embedded in its support structure for stress concentration. Therefore, it is relatively free from stiction and particle issues, and the entire process is complementary metal oxide semiconductor (CMOS)-compatible. Unlike other types of microphone in which the sensitivity is fixed by the bias voltage, the sensitivity of the PrFET microphone can be adjusted directly through the gate of the FET. To confirm the adjustable sensitivity, we derived a sensitivity model for the PrFET microphone. Then, CMOS and MEMS processes were used to fabricate the microphone chip. Finally, the voltage output was obtained using a PrFET with a trans-impedance amplifier. The measured sensitivity ranged from -75.82 to -63.79 dB depending on the gate voltage, which was within about 1.1 dB of the calculated results. The PrFET microphone exhibited higher sensitivity compared to conventional piezoresistive microphones, and we anticipate that further improvements in performance can be achieved through optimization and signal-processing techniques.
This study investigates an acoustic sensor that exploits the piezoresistive effect of a field-effect transistor (PrFET) with a sector-shaped cantilever that improves frequency-response characteristics. PrFET energy transduction is capable of detecting acoustic signals by adopting an acoustically responsive sensing structure. However, it has not been investigated whether PrFET acoustic sensors can exhibit signal-response characteristics that differ from those previously reported. To investigate whether the sensor response could be enhanced at a specific frequency, this study adopted a sector-shaped cantilever diaphragm. The sector-shaped cantilever has a free end at the center, allowing for greater stress to be induced in the piezoresistive channel under acoustic excitation. The acousto-mechanical response of the proposed structure was characterized in terms of its displacement under acoustic excitation and the resulting stress induced in the PrFET at the support. A PrFET acoustic sensor incorporating the designed diaphragm was then fabricated, and the sensitivity enhancement and the formation of a specific resonance frequency was experimentally validated.