This work investigates the performance of a conventional steam power plant retrofitted with a solar-assisted regenerative system using Parabolic Trough Solar Collectors (PTC). The solar collectors were used to compensate for the effect of removing Low-Pressure (LP) turbine extractions without changing other elements of a 300 MW power plant unit during peak load operations. The steam power plant, located in Kuwait, receives high levels of solar irradiation. Modeling of the solar-assisted regenerative system using PTC is simulated for Kuwait’s weather conditions. Results of the system analysis show that removing the LP turbine extractions enhanced the performance of the steam power plant by 9.8 MW, with an optimum PTC aperture area equal to 25,850 m2. A techno-economic analysis was used to estimate the Levelized Cost of Energy (LCOE). Compared to an equivalent photovoltaic solar plant, the optimum aperture area and LCOE for the PTC solar plant were found to be less by 45% and 44%, respectively. When compared to an equivalent conventional steam turbine, the solar-assisted steam power plant decreased cost by 56% over the lifecycle of 25-years.
18 September 2023 in Industrial & Engineering Chemistry Research
Replacing the conventionally used steam reforming of methane (SRM) with a process that has a smaller carbon footprint, such as dry reforming of methane (DRM), has been found to greatly improve the industry’s utilization of greenhouse gases (GHGs). In this study, we numerically modeled a DRM process in lab-scale packed and fluidized beds using the Eulerian–Lagrangian approach. The simulation results agree well with the available experimental data. Based on these validated models, we investigated the effects of temperature, inlet composition, and contact spatial time on DRM in packed beds. The impacts of the side effects on the DRM process were also examined, particularly the role the methane decomposition reaction plays in coke formation at high temperatures. It was found that the coking amount reached thermodynamic equilibrium after 900 K. Additionally, the conversion rate in the fluidized bed was found to be slightly greater than that in the packed bed under the initial fluidization regime, and less coking was observed in the fluidized bed. The simulation results show that the adopted CFD approach was reliable for modeling complex flow and reaction phenomena at different scales and regimes.
In the present study, the dry reforming of methane (DRM) has been simulated in fluidized-bed reactors using the multiphase particle-in-cell model. The model was meticulously built to investigate the effect of a wide range of superficial gas velocities covering particulate, aggregative, and lean-phase flow regimes on bed hydrodynamics, conversion, and yields of product gases. Constant values for catalyst loading, CH4:CO2:N2 ratio (1:1:1.3), and catalyst and gas properties were maintained in all simulations. The simulation results obtained are in good agreement with the experimental data reported in the literature. The results show that under different gas velocities, conversion is relatively indiscernible in the particulate regime. In contrast, for the inhomogeneous phases, the turbulent fluidized bed had the best reactor performance with high CH4 and CO2 conversion rates, good CO + H2 productivity, and high CO/H2 molar ratio. This is due to the vigorous turbulent flow and relatively high gas-solid contact. Due to gas bypassing and backmixing triggered by bubbling, the bubbling fluidized bed generally had the worst performance and below that of the fast-fluidized bed. The present study demonstrates that the performance of DRM reactions in fluidized-bed reactors is strongly related to the hydrodynamics. Moreover, it shows the significance of gas velocity on DRM conversion, yield, and overall reactor performance.