Fangzhi Li

Dr. Fangzhi Li


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

25 April 2024 in Nanomaterials
Verified
Journal Article
Open access
PDF file
PWPeng Wu
Peng Wu
JLJianping Liu
Jianping Liu
Fangzhi LiFangzhi Li
Fangzhi Li
XRXiaoyu Ren
Xiaoyu Ren
ATAiqin Tian
Aiqin Tian
HYHui Yang
Hui Yang
The rough morphology at the growth surface results in the non-uniform distribution of indium composition, intentionally or unintentionally doped impurity, and thus impacts the performance of GaN-based optoelectronic and vertical power electronic devices. We observed the morphologies of unintentionally doped GaN homo-epitaxially grown via MOCVD and identified the relations between rough surfaces and the miscut angle and direction of the substrate. The growth kinetics under the effect of the Ehrlich–Schwoebel barrier were studied, and it was found that asymmetric step motions in samples with a large miscut angle or those grown at high temperature were the causes of step-bunching. Meandering steps were believed to be caused by surface free energy minimization for steps with wide terraces or deviating from the [11¯00] m-direction.

20 April 2023 in Optics Express
Verified
Journal Article
Closed access
Fangzhi LiFangzhi Li
Fangzhi Li
JLJianping Liu
Jianping Liu
ATAiqin Tian
Aiqin Tian
XLXuan Li
Xuan Li
FZFan Zhang
Fan Zhang
HYHui Yang
Hui Yang
In InGaN-based LEDs, an InGaN layer underlying active region has been widely used to improve the luminescence efficiency of the quantum wells (QWs). It has been reported recently that the role of InGaN underlayer (UL) is to block the diffusion of point defects or surface defects in n-GaN into QWs. The type and the source of the point defects need further investigations. In this paper, using temperature-dependent photoluminescence (PL) measurements, we observe emission peak related to nitrogen vacancies (VN) in n-GaN. In combination with secondary ion mass spectroscopy (SIMS) measurement and theoretical calculation, it is found that VN concentration in n-GaN is as high as about 3 × 1018 cm-3 in n-GaN grown with low growth V/III ratio and can be suppressed to about 1.5 × 1016 cm-3 by increasing growth V/III ratio. Luminescence efficiency of QWs grown on n-GaN under high V/III ratio is greatly improved. These results indicate high density of nitrogen vacancies are formed in n-GaN layer grown under low V/III ratio and diffuse into quantum wells during epitaxial growth and reduce the luminescence efficiency of the QWs.

25 January 2021
Verified
Conference Paper
Closed access
YGYangyang Gao
Yangyang Gao
HYHaiping Yi
Haiping Yi
Fangzhi LiFangzhi Li
Fangzhi Li
Kai TaoKai Tao
Kai Tao
Jin WuJin Wu
Jin Wu
WYWeizheng Yuan
Weizheng Yuan
Origami, an ancient art of paper folding with a history spanning over 1000 years, can devise ingenious patterns with unique advantages in terms of great flexibility, lightweight, extreme simplicity, and excellent shape adaptability. The poor stability of electret / triboelectric devices in a humid environment is a key challenge faced by researchers worldwide. Inspired from Japanese Muira-origami structures, we propose a "W-tube" shaped triboelectric nanogenerator (WTN) with the two pieces of electret films encapsulated inside to isolate the humid environment. Besides, it's capable of capturing energy from various moving scenes, including horizontal or vertical pressing, and lateral bending. We have tested multiple parameters of WTN in detail, including the influence of the number of generating units, the original height of equipment, the acceleration and the excitation direction on the output performance. This work combines the ancient origami art with energy conversion technology to create a multifunctional waterproof energy harvesting device.

12 February 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
YLY. Q. Li
Y. Q. Li
ATA. Q. Tian
A. Q. Tian
JLJianping Liu
Jianping Liu
XLX. Li
X. Li
Fangzhi LiFangzhi Li
Fangzhi Li
HYH. Yang
H. Yang
For AlGaN-based near ultraviolet laser diodes (UVA LDs) with emission wavelength below 365 nm, there is no such suitable substrate for homoepitaxy to the required AlGaN films. In this study, we proposed a two-step growth (TSG) method of thick Al0.2Ga0.8N layer grown on the sapphire substrate with a sputtered AlN nucleation layer. The influence of growth rate and V/III ratio on the growth mode of an AlGaN layer has been studied in detail. It is found that AlGaN films exhibit larger island size and lower island density with low growth rate and low V/III ratio during the 3D growth stage, which can effectively relax the compressive stress and suppress the dislocation formation of the subsequent thick AlGaN layer. Therefore, a crack-free high-quality 5 μm-thick Al0.2Ga0.8N layer with 85% biaxial relaxation is grown on a sapphire substrate by using the TSG method, revealing the threading dislocation density decreases from 1.2 × 1010 to 6.6 × 108 cm−2. This work paves the way for the realization and improvement of high-performance AlGaN-based UVA emitters.

1 August 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
FZFan Zhang
Fan Zhang
RWRongxin Wang
Rongxin Wang
Fangzhi LiFangzhi Li
Fangzhi Li
ATAiqin Tian
Aiqin Tian
JLJianping Liu
Jianping Liu
HYHui Yang
Hui Yang
In an interconnected high-vacuum illustration system, the surfaces of p-InGaN/GaN heterostructures grown with integrated metalorganic chemical vapor deposition were treated in O2 gas for different times at room temperature and then transferred to another chamber for fabricating ohmic contacts via sputtering Pd/Pt/Au multi-layers. X-ray photoelectron spectroscopy measurements unveil that the proportions of Ga–O of the treated samples significantly increase compared with that of the as-grown sample, indicating that a thin layer of GaOx forms on the p-InGaN/GaN surface after exposing to oxygen or air atmospheres. Meanwhile, the samples exposed to O2 or air were found to have much higher specific contact resistance, i.e., higher by two orders of magnitude than that of the as-grown sample. The specific contact resistance of the as-grown sample was derived as 9.3 × 10−5 Ω cm2 using the circular transmission line measurement. Furthermore, the Schottky barrier height of the samples was determined from the measured I–V curves with the thermionic field emission model and was revealed to be closely related to surface treatments. Despite the fact that the insulating layer of GaOx was as thin as 1.2–1.4 Å for the samples exposed to oxygen at room temperature, it can act as an extra barrier layer causing significant increase in the specific contact resistance via blocking the tunneling of carriers. Therefore, the effective removal of p-InGaN surface oxide plays a vital role in preparing good ohmic contacts.