George Oluwole Akintola

Dr. George Oluwole Akintola

Earth Sciences Department, University of Venda, Thohoyandou, Limpopo, South Africa
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2020 in Heliyon
Verified
Journal Article
Open access
GAGeorge Oluwole Akintola
George Oluwole Akintola
FAFrancis Amponsah-Dacosta
Francis Amponsah-Dacosta
Sphiwe Emmanuel MhlongoSphiwe Emmanuel Mhlongo
Sphiwe Emmanuel Mhlongo
Understanding of clayey materials properties continues to elude brick manufacturers, hence unsure of their application for brick making purposes. The raw materials were assessed geochemically, mineralogically, physically and technologically. The geochemical result showed that the fluxing oxides K2O, N2O, CaO, MgO and MnO are generally low in content with average abundance ranging from 0.06% to 1.78%. The Fe2O3 content varies (4.8–25.5%) thus reflects heterogenous stability in tonality. Most of the studied samples have relatively high Al2O3 content which suggest the bauxitic composition from which kaolinite minerals might have resulted from. The XRD analysis revealed the presence of kaolinite and chlorite as the major clay minerals while quartz, feldspar, talc and hornblende were present as non-clay minerals. For DTA, the threshold of new crystallization processes were attained at 1000 °C. The SEM analysis revealed the presence of some stroma in all samples although with sizes >50 nm. These pores were suggested to constitute a capillary system where molten mineral occupy as temperature increases. The Atterberg's limit indicated that the studied materials are inorganic silts with high compressibility and organic clays properties since it plotted below the A-line of plasticity chart. The compressive strength (CS) for brick specimens made from kaolinite-rich material are relatively higher than chlorite-rich specimens. This was attributed to the ineffective pore connection within the kaolinite interstitial particles compared to the chlorite-rich specimen, hence increasing the density. The water absorption (WA) test on twenty brick specimens showed that the pore volume and capillarity for bricks which are chlorite-dominated were comparatively higher, thus absorbing more water molecules. These results revealed that majority of the studied clayey material are not suitable for double storey construction bricks but meet the requirements for single-storey construction when compared with SANS standards.

1 April 2021 in Journal of Degraded and Mining Lands Management
Verified
Journal Article
Open access
PDF file
SMSphiwe Emmanuel Mhlongo
Sphiwe Emmanuel Mhlongo
GAGeorge Oluwole Akintola
George Oluwole Akintola
South Africa has many artisanal and small-scale mining (ASM) activities that some are registered and others informal and illegal. This paper presents an overview of ASM operations in the vicinity of abandoned mine sites found in Giyani and Musina areas, Limpopo Provine of South Africa. It looks at the mining processes, environmental problems, and health and safety risks of ASM in the area. It also provideds a discussion of practical ways of dealing with the problems of artisanal and small-scale mining operations in a harmonized way with the rehabilitation of the abandoned mine sites. The exploitation of waste rock dumps for aggregate production in Musina demonstrated that formalized ASM activities can be the best alternative uses of the abandoned mine sites. However, artisanal gold mining around Giyani revealed the health and safety risks and environmental problems of these operations. The artisanal gold mining activities worsened the health and safety and the environmental problems of the abandoned mine sites. Therefore, this paper recommends that the efforts of coming up with strategies to formalize and regulate artisanal mining in South Africa be deepened for these activities to be accepteble as sustainable as post-mining land-uses in abandoned mines.

19 June 2021 in Minerals
Verified
Journal Article
Open access
PDF file
GAGeorge Oluwole Akintola
George Oluwole Akintola
FAFrancis Amponsah-Dacosta
Francis Amponsah-Dacosta
SRSteven Rupprecht
Steven Rupprecht
NPNithyadharseni Palaniyandy
Nithyadharseni Palaniyandy
Sphiwe Emmanuel MhlongoSphiwe Emmanuel Mhlongo
Sphiwe Emmanuel Mhlongo
JEJoshua Edokpayi
Joshua Edokpayi
Carbonaceous shale is more topical than ever before due to the associated unconventional resources of methane. The use of FTIR, SEM-EDX, and mineralogical analyses has demonstrated a promising approach to assess methanogenesis potentials in a more rapid and reliable manner for preliminary prospecting. Representative core samples from the borehole that penetrated the carbonaceous Mikambeni shale Formations were investigated for methanogenesis potentials. The absorption band stretches from 1650 cm−1 to 1220 cm−1 in wavenumber, corresponding to C-O stretching and OH deformation of acetic and phenolic groups in all studied samples, thereby suggesting biogenic methanogenesis. The CO2 was produced by decarboxylation of organic matter around 2000 cm−1 and 2300 cm−1 and served as a source of the carboxylic acid that dissolved the feldspar. This dissolution process tended to release K+ ions, which facilitated the illitization of the smectite minerals. The SEM-EDX spectroscopy depicted a polyframboidal pyrite structure, which indicated a sulfate reduction of pyrite minerals resulting from microbial activities in an anoxic milieu and causes an increase in alkalinity medium that favors precipitation of dolomite in the presence of Ca and Mg as burial depth increases. The contact diagenesis from the proximity of Sagole geothermal spring via Tshipise fault is suggested to have enhanced the transformation of smectite to chlorite via a mixed layer corrensite in a solid-state gradual replacement reaction pathway. The presence of diagenetic chlorite mineral is characteristic of low-grade metamorphism or high diagenetic zone at a temperature around 200 °C to 230 °C and corresponds to thermal breakdown of kerogen to methane at strong absorption band around 2850 cm−1 and 3000 cm−1, indicating thermal methanogenesis.

17 June 2024 in Scientific Reports
Verified
Journal Article
Open access
PDF file
GAGeorge Oluwole Akintola
George Oluwole Akintola
FAFrancis Amponsah-Dacosta
Francis Amponsah-Dacosta
SMSphiwe Emmanuel Mhlongo
Sphiwe Emmanuel Mhlongo
KMKhensani Eullen Matsiketa
Khensani Eullen Matsiketa
The selection of raw materials to produce quality artisanal bricks is imperative for sustainable building in rural regions. Artisanal brick-making process often employs traditional kiln to fire brick because it is an affordable, and applicable technology in the rural region. However, there are noticeable cracks, increasing among buildings constructed with artisanal bricks from the rural region in South Africa. In response, this study aims to evaluate the soil and artisanal brick specimens to understand the suitability of the raw materials and quality of products in the study area. A total of twenty soil samples and twenty-seven artisanal burnt bricks were collected from three different artisanal brick-making sites designated as Site A, B, and C. In all samples, the geotechnical tests revealed a sandy loam soil type with a predominance of chlorite clay minerals and non-clay minerals. Furthermore, the sand-size particles depict a relatively higher proportion compared to clay-size particles. Besides, Atterberg’s limit test plotted above the A-line of the plasticity chart indicates an inorganic clay of low plasticity with a low to medium compressibility property. Based on the empirical workability and mechanical tests, most of the studied soils are suitable for optimum and acceptable extrusion bricks and suitable for an on-site single-story construction based on SANS 227:2007 standards.

8 March 2021 in Arabian Journal of Geosciences
Verified
Journal Article
Open access
PDF file
GAGeorge Oluwole Akintola
George Oluwole Akintola
PIPhillips Reuben Ikhane
Phillips Reuben Ikhane
FAFrancis Amponsah-Dacosta
Francis Amponsah-Dacosta
AAAyoade Festus Adeagbo
Ayoade Festus Adeagbo
Sphiwe Emmanuel MhlongoSphiwe Emmanuel Mhlongo
Sphiwe Emmanuel Mhlongo
NANiyiola Olaonipekun Adebisi
Niyiola Olaonipekun Adebisi
The rise in demand for natural gas has spurred the need to investigate the inland sedimentary basin for more potential sources. In response, the petrophysical parameters of the carbonaceous shale samples from two deep boreholes of Anambra Basin were evaluated. The gas-prone nature of Nkporo shale showed a thermal evolution of a Type III kerogen with initial HI value between 650 and 800 mgHC/gTOC, S2/S3 < 1, a maximum Tmax value of 488°C and have a low hydrocarbon generation potential ranging from 0.07 to 0.15. However, the average TOC content (2.21 wt%) indicated a good source rocks for hydrocarbon since it exceeds threshold limit of 0.5%. The plot of HI against Tmax shows that the organic matter belongs to the Type-III kerogen which reflects the capability of the Npkoro Formation to generate more natural gas than oil compared to Type-II kerogen. The high values (>3) of pristane/phytane ratio in both wells indicated that the organic matter belongs to terrigenous source deposited under anoxic condition which is typical of non-marine shale. The presence of Oleanane content in the Cretaceous shale sediments indicated the contribution of cell wall and woody plant tissues from the terrestrial higher plant. The low concentrations of extractable organic matter (EOM) present in form of isoprenoid and aliphatic hydrocarbon indicated little or no bitumen extract from the studied shale. Considering the high carbon preference indices (CPI) value greater than 1, the preponderance of vitrinite organic macerals and other favourable aforementioned petrophysical parameters, the non-marine Npkoro Shale Basin has significant potential to generate and expel natural gas apart from the current marine basins.

1 January 2023 in Open Geosciences
Verified
Journal Article
Open access
PDF file
GAGeorge Oluwole Akintola
George Oluwole Akintola
The increasing demand for energy and global commitment to reduce CO2 emissions to mitigate climate change has spurred countries to pursue unconventional hydrocarbon generation for power production. The investigation of the carbonaceous shale from the Permian Mikambeni Formation of the Tuli Basin in South Africa aims to assess the potential for gas generation. The Rock-Eval 6 pyrolysis of the studied samples shows total organic carbon (TOC) content ranging from 10.10 to 37.61 wt%, indicating an excellent source rock quality since it exceeds the threshold limit of 5 wt%. The produced gas that emanated from the thermal breakup of remaining hydrocarbon (S2) ranged from 14.30 to 65.55 mg HC/g rock while the hydrogen index (HI) ranged from 56.55 to 198.22 mg/g TOC. The plot of the HI against T max indicates the predominance of type-III kerogen, prone to gas generation. The thermal maturity parameters, T max (430–466°C), and vitrinite reflectance, VRo (0.6–1.2), showed a matured organic material. The production index value (0.06) of the samples indicates a moderately mature source generating a biogenic gas. The carbon isotopic composition, δ 13C (−20.0 to −23.4‰), indicates a predominant influx of organic matter derived from a vascular higher plant. The studied samples showed relatively depleted values of oxygen isotopic composition δ 16O (14.1–18.8‰), suggesting a brackish water depositional environment. Additionally, the Ba concentration (303.15–331.27 ppm) exceeds the 200 ppm threshold for the marine environment, indicating a non-marine environment characterised by low marine paleo-productivity and high detrital influx. Based on the evaluation, the studied coaly-shale is found with a matured and type-III kerogen that is prone to gas generation in a fluvial, paleo-depositional environment.