In situ bioremediation (ISB) is a widely accepted method for eradicating petroleum hydrocarbons (PHCs) and chlorinated aliphatic hydrocarbons (CAHs) from contaminated aquifers. To achieve full removal of all toxic compounds that originated from microbial degradation, sequential anaerobic/aerobic bioremediation systems are recommended. While several works based on laboratory analyses targeting sequential bioremediation have been documented, examples of sequential ISB are limited. The purpose of this study is to report and analyze the results obtained from the multiscale characterization activities propaedeutic to the construction of Italy’s largest (> 400 m long) sequential ISB system. The rich wealth of information produced during this study provides a useful example that can be followed for the construction of new sequential ISBs. The system was set up to remediate a solute plume containing PHCs and CAHs in an alluvial aquifer in Italy. Microcosm experiments were carried out to determine the biodegradation potential under anaerobic and aerobic conditions. In situ tests were performed by installing two 40-m-long pilot biobarriers for sequential anaerobic and aerobic degradation intercepting part of the contamination plume. These experiments pointed out the need of adding biostimulating compounds to accelerate the biodegradation process, under both aerobic and anaerobic conditions. In situ tests showed removal efficiencies of up to 95 and 99% for total CAHs and PHCs, respectively, proving the feasibility of the full-scale ISB system. Apparent discrepancies between laboratory and in situ tests can be ascribed to scale effects and aquifer heterogeneities.
Stochastic multicomponent reactive transport modeling is a powerful approach to quantify the probability of non-exceedance (PNE) of arsenic (As) critical concentration thresholds in groundwater. The approach is applied to a well-characterized shallow alluvial aquifer near Venice, Italy. Here, As mobility depends primarily on rainfall-controlled redox-dependent precipitation-dissolution of iron hydroxides. A Monte-Carlo analysis based on a calibrated three-dimensional flow and transport model targeted the geochemical initial conditions as the main source of uncertainty of As concentrations in the studied aquifer. It was found that, during 115 simulated days, the fraction of the entire aquifer volume with As > 10 μgL−1 decreased on average from ~43% to ~39% and the average As concentration from ~32 μgL−1 to ~27 μgL−1. Meanwhile, PNE increased from 55% to 60% when 10 μgL−1 was set as target threshold, and from 71% to 78% for 50 μgL−1. The time dependence of As attenuation can be ascribed to the increase of oxidizing conditions during rainfall-dependent aquifer recharge, which causes As sorption on precipitating iron hydroxides. When computing the same statistics for the shallowest 6 m, As attenuation was even more evident. The volume fraction of aquifer with As > 10μgL−1 dropped from 40% to 28% and the average As concentration from 31 μgL−1 to 20 μgL−1, whereas PNE increased from 58% to 70% for As < 10 μgL−1 and from 71% to 86% for As < 50 μgL−1. Thus, the wells screen depth in the aquifer can be a critical aspect when estimating As risk, owing to the depth-dependent relative change in redox conditions during rainfall events.
Compound-specific isotopic analysis (CSIA) and geochemical modeling were applied to evaluate the effectiveness of an 800 m-long sequential in situ bioremediation (ISB) system in Northern Italy. The system was created for the clean-up of a polluted aquifer affected by chloroethenes. A hydraulically upgradient anaerobic (AN)-biobarrier-stimulated reductive dichlorination (RD) of higher chloroethenes (PCE, TCE) and a downgradient aerobic (AE)-biobarrier-stimulated oxidation (OX) of lower chloroethenes (DCE, VC) were proposed. Carbon CSIA and concentration data were collected for PCE, TCE, cis-DCE and VC and interpreted using a reactive transport model that was able to simulate isotopic fractionation. The analysis suggested that the combination of CSIA and modeling was critical to evaluate the efficiency of sequential ISBs for the remediation of chloroethenes. It was found that the sequential ISB could reduce the PCE, TCE and cis-DCE concentrations by >99% and VC concentrations by >84% along the flow path. First-order RD degradation rate constants () increased by 30 times (from = 0.2–0.3 y−1 up to = 6.5 y−1) downgradient of the AN barrier. For cis-DCE and VC, the AE barrier had a fundamental role to enhance OX. First-order OX degradation rate constants () ranged between = 0.7–155 y−1 for cis-DCE and = 1.7–12.6 y−1 for VC.