24 October 2017 in ACS Applied Materials & Interfaces
5 April 2018 in ACS Applied Materials & Interfaces
15 December 2020 in Advanced Materials Interfaces
JBJacqueline Marie Börgers
+2
Driven by the interest in fundamental physics and potential applications in novel electronic devices, intense effort is devoted to integration of oxide‐based 2D electron gases (2DEGs) with other functional materials. As a classic model system, LaAlO3/SrTiO3 (LAO/STO) has gained significant attentions. However, due to limitations in synthesis and high demands on the involved thin films, the formation of conductive interfaces between artificially grown STO and LAO thin films is an extreme challenge; oftentimes these interfaces remain insulating or show poor transport properties, which inhibits the development of all‐thin‐film devices. Here, by adopting high temperature growth to achieve step‐flow growth mode and fine‐tuning the laser fluence during pulsed laser deposition, high quality homoepitaxial STO thin films with sufficiently low point‐defect concentration and controllable surface termination are obtained. Fully metallic 2DEGs are then realized at interfaces between STO thin films and both crystalline and amorphous LAO overlayers. The observed slightly reduced mobility in the bilayer LAO/STO/STO structures as compared with single‐layer LAO/STO structures is related to residual defect formation during STO synthesis, yielding a disordered metallic oxide system. The results give prospect of multilayer interfaces potentially accessible in superlattice structures and provide a reliable starting point for back‐gated all‐thin‐film field‐effect devices.
5 April 2019 in ACS Applied Materials & Interfaces
1 December 2021 in Physics of Fluids
The problem of the movement of dense granular media is common in industrial processes. Dense granular media cannot only show solid-like properties when stacked but can also flow like a liquid, exhibiting properties of fluids. Simultaneous modeling and description of these two states remain a challenge. In this study, a new constitutive model describing the motion of dense granular media is established. A linear elastic model is used to describe the solid phase. After reaching the plastic yield criterion, a viscoplastic constitutive model based on rheology is used to describe the liquid phase. The transitional relationship between these two models is deduced in detail, and the elastic–viscoplastic constitutive theory that describes the movement of dense granular media is more in line with physical reality. Smoothed particle hydrodynamic method is used to discretely solve the new model, and the relationship between smoothed particles and actual particles is illustrated. A series of basic calculation tests is used to verify the theoretical model and numerical method. Through a comparison with experiments and other numerical results, it is shown that the theoretical model and numerical method are suitable for the analysis of the movement of dense granular media and have important practical value for the preparation and processing of similar materials, three-dimensional printing, and mineral mining.
10 October 2018 in Journal of Applied Physics
Complex oxide heterointerfaces with the two-dimensional electron gas have drawn a lot of attention due to their emerging properties. However, most of them are prepared using the method with relatively high energy particles, which would inevitably lead to some defects. Here, a key challenge in the quasi-two-dimensional electron gas at spinel-type Al2O3/SrTiO3 heterointerfaces using a spin coating method is addressed. The grown Al2O3 films have the atomic-scale smooth surface and the thickness is about 70 nm. The γ-Al2O3 layer with a thickness of about 3 nm in proximity to SrTiO3 and the amorphous Al2O3 layer on the top of γ-Al2O3 are observed for the heterointerface annealed at 800 °C. The heterointerfaces at annealed temperatures above 750 °C exhibit a metallic behavior, which is attributed to the dominant layer of γ-Al2O3. The sheet carrier density is about 3.1 × 1015 cm−2 and the Hall mobility is 4924.4 cm2 V−1 s−1 at 15 K at the heterointerface annealed at 800 °C. Our work provides a low-cost way for the large-scale and large-area production of two-dimensional electron gas at high-quality oxide interfaces.