Solvent engineering is one of the most widely applied preparation methods for the high- quality perovskite films. In this method, the choice of anti-solvent plays a very important role to improve the perovskite crystal quality. Here, we report a facile way to regulate the crystal quality of perovskite film by adjusting the ratio of toluene and diethyl ether in the mixed anti-solvent. Through the combination of characterization and measurements including scanning electron microscopy, the atomic force microscopy, X-ray diffraction, and the steady-state photoluminescence spectra, it reveals that the quality of perovskite films is obviously improved when the volume ratio of toluene to diethyl ether in the mixed anti-solvent is 1:1. The optimal device obtains power conversion efficiency of 16.96% with a short-circuit current density of 20.60 mA/cm2, an open-circuit voltage of 1.03 V, and a fill factor of 79.96%. At the same time, the device shows negligible current–voltage hysteresis and steady power output. Moreover, the stability of PSCs is significantly enhanced due to the perovskite film quality improvement by adopting 50% toluene mixed anti-solvent.
Although the certified power conversion efficiency of organic-inorganic perovskite solar cells (PSCs) has reached 25.7%, their thermal and long-term stability is a major challenge due to volatile organic components. This problem has been a major obstacle to their large-scale commercialization. In the last few years, carbon-based all-inorganic perovskite solar cells (C−IPSCs) have exhibited high stability and low-cost advantages by adopting the all-inorganic component with cesium lead halide (CsPbI3−xBrx, x = 0 ~ 3) and eliminating the hole-transporting layer by using cheap carbon paste as the back electrode. So far, many astonishing developments have been achieved in the field of C−IPSCs. In particular, the unencapsulated CsPbBr3 C-IPSCs exhibit excellent stability over thousands of hours in an ambient environment. In addition, the power conversion efficiencies of CsPbI3 and CsPbI2Br C-IPSCs have exceeded 15%, which is close to that of commercial multicrystalline solar cells. Obtaining high-quality cesium lead halide-based perovskite films is the most important aspect in the preparation of high-performance C-IPSCs. In this review, the main challenges in the high-quality film fabrication process for high performance C-IPSCs are summarized and the film fabrication process strategies for CsPbBr3, CsPbIBr2, CsPbI2Br, and CsPbI3 are systematically discussed, respectively. In addition, the prospects for future film fabrication processes for C-IPSCs are proposed.
A well-dispersed SiO2@Layered hydroxide cupric benzoate (SiO2@Cu-LBMS) with a hierarchical structure have been synthesized by a facile method. The layered hydroxide cupric benzoate with a structure of layered basic metal salt (Cu-LBMS) was directly deposited on the surface of silica spheres without any blinder. The morphology of the SiO2@Cu-LBMS nano-microsphere was observed by SEM, and the reaction conditions was also discussed. In addition, the XRD patterns and FTIR spectra provide consistent evidence to the formation of SiO2@Cu-LBMS nano-microspheres. The release behavior and drug loading capability of SiO2@Cu-LBMS microspheres were also investigated by using ibuprofen, aspirin and salicylic acid as model drugs. The results indicated that the drug loading capability of SiO2@Cu-LBMS nano-microspheres was much larger than layered hydroxide cupric benzoate, and the releasing time was significantly prolonged than layered hydroxide cupric benzoate and their physical mixture.