In the last decades, low-density steels for forging have increasing interest in the automotive industry, and good mechanical properties are required for their real application. This paper describes the results obtained for a 0.66C11.4Mn9.9Al duplex austenitic low-density steel after applying a set of isothermal treatments at different combinations of time and temperature, aimed to promote kappa carbide precipitation, and improve the mechanical properties obtained with a water quenching treatment. The effects of the different isothermal treatments on the microstructure and on the mechanical properties have been analyzed and compared to those obtained from a quenching heat treatment. We found that isothermal treatments in the range temperature between 550–750 °C promoted the profuse precipitation of coarse kappa carbides at grain boundaries, which dramatically reduced the ductility of the alloy, whereas a traditional quenching treatment resulted in a better combination of ductility and mechanical strength.
5 July 2021 in Materials and Manufacturing Processes
Difficulties found when manufacturing and forging two low density steels in different scales are described in this work. Austenitic and duplex low-density steels have attracted a lot of interest due to their good combination of mechanical properties and density reduction. In this work, the fabrication of 1.3 C30Mn10Al austenitic low-density steel and 0.65 C12Mn10Al duplex low-density steel have been studied. The scaling up of the manufacturing process from 1 Kg to 35 Kg ingots of both materials and the subsequent hot forging of the ingots is described, showing the difficulties encountered during the production and transformation of these steels. Only the small ingots were successfully forged, but not the larger ones, showing the important differences in the forging properties depending on the geometry and dimensions of the final part to be forged, and the homogenization temperatures. The possible causes of this scale dependence are proposed from the experimental results obtained, as well as from the hot axial compression tests and the thermodynamic simulations carried out.