Melt quenching-the method of quenching from the liquid state-provides new opportunities for producing advanced materials with a unique combination of properties. In the process of melt quenching, attainment of critical cooling rates can produce specific structural states of the material. Nanocrystalline materials produced by melt quenching are clas
The interaction of shear bands with crystalline nanoparticles in amorphous-nanocrystalline Fe-Ni-B alloys is analyzed theoretically and experimentally. The following five interaction mechanisms are revealed: absorption, bypassing, cutting, retardation, and accommodation. The nanocrystal size is shown to be the key factor of this interaction. The experimental results obtained are satisfactorily described by the proposed theoretical models.
This article presents systematic studies of the preparation method and the specific features of the changes in the structure and properties of amorphous-nanocrystalline composites formed from melt-quenched ribbons of iron- and cobalt-based amorphous alloys and the Cu-Nb crystalline nanolaminates by severe plastic deformation by torsion in the Bridgeman chamber at high quasi-hydrostatic pressure.
The effect of heat treatment on the structure and mechanical properties of Co-Fe-Cr-Si-B/Fe-Cr-B/Fe-Ni-B amorphous alloys has been studied systematically. Melt-quenching (spinning method) was used for production of investigated amorphous alloys. The transmission electron microscopy (TEM) was used to study the structure transformations. The effect of temperature on deformation behavior (plasticity, microhardness, crack resistance, and the density and average length of shear bands) of the amorphous alloys was studied by bending and microindentation. It is shown that the ductile–brittle transition, which occurs at the stage of structure relaxation in amorphous alloys, is caused by two factors: a decrease in the susceptibility of the amorphous matrix to plastic flow and an abrupt decrease in the resistance to the development of quasibrittle cracks. It is established that the transition to a two-phase amorphous–nanocrystalline state upon annealing leads to substantial strengthening of the alloys and a partial recovery of their plasticity. It is proved that the strengthening of amorphous alloys at the initial stages of crystallization can be initiated by the difference in the elastic moduli of the amorphous matrix and the precipitated nanocrystals, as well as by the specific features of the interaction between nanocrystalline phase particles and shear bands propagating under external actions. It is established that the phenomenon of plasticization in amorphous alloys (the crack resistance can increase after annealing in a certain temperature range) is due to the effective retardation of cracks on nanoparticles.
Evolution of surface structure of metallic glass subjected to etching was investigated. The changes of surface structure of metallic glass 82K3XCP after chemical etching and different modes of annealing were studied. Samples of metallic glass were etched in solutions of sulphurous acid with different concentration. Corrosion-resistance was determined. The dependence of corrosion rate on acid concentration was found. Characteristic concentric circumferences on the etching surface were investigated. Their formation mechanism is discussed. Crystallization on surface stimulated by both acid and annealing was examined. The formation of first dendrites on surface of annealed metallic glass and their evolution were investigated.
1 December 2007 in Bulletin of the Russian Academy of Sciences: Physics
Patterns of plastic deformation of amorphous nanocrystalline composites, caused by the local action of an indenter on a thin electron microscopy foil, have been experimentally investigated for the first time in structural analysis. Classification of the observed types of interaction of shear bands with crystalline nanoparticles is performed. This classification is in good agreement with the theoretically predicted interaction mechanisms.