We made comparison of titanium dioxide powders obtained from three syntheses including sol‐gel and precipitation methods as well as using layered (tetramethyl)ammonium titanate as a source of TiO2. The obtained precursors were subjected to step annealing at elevated temperatures to transform into rutile form. The transformation was determined by Raman measurements in each case. The resulting products were characterised using Raman spectroscopy and dynamic light scattering. The main goal of the studies performed was to compare the temperature of the transformation in three titania precursors obtained by different methods of soft chemistry routes and to evaluate dielectric properties of rutile products by means of broadband dielectric spectroscopy. Different factors affecting the electrical properties of calcinated products were discussed. It was found that sol‐gel synthesis provided rutile form after annealing at 850°C with the smallest particles size about 20 nm, the highest value of dielectric permittivity equal to 63.7, and loss tangent equal to 0.051 at MHz frequencies. The other powders transformed to rutile at higher temperature, that is, 900°C, exhibit lower value of dielectric permittivity and had a higher value of particles size. The correlation between the anatase‐rutile transformation temperature and the size of annealed particles was proposed.
In this study, nanocrystalline (18–28 nm) perovskite-like bismuth ferrite rare earth-doped powders (Bi0.9RE0.1FeO3, where RE = La (BLaFO), Eu (BEuFO), and Er (BErFO)) were obtained by microwave-assisted modification of solution combustion synthesis (SCS). The influence of high load La3+, Eu3+, and Er3+ doping on structural, optical, and electrical properties of BiFeO3 was investigated. It was found that rare earth doping along with fast phase formation and quenching significantly distorts the crystal cells of the obtained materials, which results in the formation of mixed rhombohedral- (R3c-) orthorhombic (Pbnm) crystal structures with decreased lengths of Bi-O and Fe-O bonds along with a decreasing radius size of doping ions. This promotes reduction of the optical band gap energy and suppression of ionic polarization at high frequencies and results in enhanced dielectric permittivity of the materials at 1 MHz.
We present soft x-ray spectroscopy measurements and electronic structure calculations of ZnTiO, a ternary oxide that is related to wurtzite ZnO and rutile TiO. The electronic structure of ZnTiO was calculated using a variety of exchange-correlation functionals, and we compare the predicted band gaps of this material obtained from each functional with estimates from our experimental data and optical gaps quoted from the literature. We find that the main hybridizations in the electronic structure of ZnTiO can be predicted from the electronic structures of the two binary oxides. We further find that ZnTiO has weaker O 2p-Zn 3d repulsion than in ZnO, resulting in a relatively lower valence band maximum and consequently a larger band gap. Although we find a significant core hole shift in the measured O XAS of ZnTiO, we provide a simple empirical scheme for estimating the band gap that may prove to be applicable for any - ternary oxide, and could be useful in finding a ternary oxide with a band gap tailored to a specific energy.