Jacinto Maria Jiménez-Martínez

Dr. Jacinto Maria Jiménez-Martínez

Polytechnic University of Cartagena, Cartagena, Murcia, Spain
orcid

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 August 2005 in IEEE Transactions on Education
Verified
Journal Article
Closed access
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
FSFulgencio Soto-Valles
Fulgencio Soto-Valles
EJEsther de Jódar
Esther de Jódar
JVJose Antonio Villarejo
Jose Antonio Villarejo
JRJ. Roca-Dorda
J. Roca-Dorda
This paper presents a new methodological approach to teaching power electronics converter experiments. This approach is based on a reconfigurable hardware-software platform for use in converter experiments in a basic power electronics course. This course is an optional subject, and, therefore, the experiments need to motivate the students. The platform is controlled by software (made in a LabVIEW environment) run on a PC. The student can control the fundamental parameters of the selected converter topology through the user interface and, with a little work, can compare the results with a real circuit. An example of use of the methodology in an inverter experiment is included.

16 November 2012 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
EJEsther de Jódar
Esther de Jódar
JVJose Antonio Villarejo
Jose Antonio Villarejo
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
The active clamp boost converter (ACBC) has been analyzed, and a complete model has been obtained. It has been checked that it behaves as a voltage source with high input impedance. Because of this feature, this topology is suitable for multiphase design, where different stages share the load in a passive way, without any extra mechanism or components. The design of multiphase converters is simplified, particularly for a big number of phases, as no extra information must be processed. Steady-state current sharing has been studied as well as how component tolerances affect the current distribution. A simple design guide to select different components has been detailed, and, moreover, the conditions to achieve soft switching have been revised. To test passive current sharing, a two-phase ACBC has been built. It has been tested in open loop to prove that without any control loop or extra components, the load sharing is achieved.

27 April 2022 in Energies
Verified
Journal Article
Open access
PDF file
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
EJEsther de Jódar
Esther de Jódar
JVJose Antonio Villarejo
Jose Antonio Villarejo
Different mechanisms for balancing power between parallel connected modules have been presented in recent years. They have been broadly classified into active and passive methods. The high output impedance of topologies, including active clamp networks, suggests that they can achieve output current sharing passively when they are connected in parallel. However, some parasitic elements, such as stray capacitances and leakage inductances, have not been considered in the theoretical analyses. Moreover, these need to be taken into account when a high step-up ratio is required because they modify the behavior and output impedance of a module, which changes the current balance. This paper presents a detailed analysis of the influence of parasitic capacitances on active clamp flyback converters that were parallel connected, using the output impedance as a current self-balance method. The proposed solution to alleviate the negative effects on current balance was also studied and validated as a successful method that did not increase the complexity of the controller. Finally, the results that were obtained using an experimental prototype with two 100W modules helped to verify the theoretical results.

7 March 2012 in IET Power Electronics
Verified
Journal Article
Closed access
EJEsther de Jódar
Esther de Jódar
JVJose Antonio Villarejo
Jose Antonio Villarejo
MMM. Moreno
M. Moreno
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
The zero-voltage transition (ZVT) boost converter has been analysed and a complete model has been obtained. It has been checked it behaves as a voltage source with high impedance and, because of this property, it is a valid topology for multiphase design, where different stages will share load in a passive way, without any extra mechanism or components to achieve load sharing. The design of multiphase converters is simplified, especially for a big number of phases, as no extra information must be processed. Steady-state current sharing has been studied and how components tolerances will affect to current distribution. A simple design guide to select different components has been detailed. To test passive current sharing a two-phase 600 W prototype has been built and it has been tested in open loop. This has been done to prove that without control loop or extra components there is load sharing when ZVT converters are connected in parallel.

1 December 2013
Verified
Conference Paper
Closed access
AMAntonio Mateo-Aroca
Antonio Mateo-Aroca
JVJose Antonio Villarejo
Jose Antonio Villarejo
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
EJE. de Jodar
E. de Jodar
An electronic equipment reliably that allow to control the generated electric power to be below of the electric power consumption and is able to compensate the electric energy injection into the company distribution grid, complying with the legislation and that is likely to be accepted as a valid system for electricity distribution companies is proposed. This make changes in the output power of the inverters and introducing variable loads to avoid energy injection both in time intervals which inverter power output changes as in the case of power generation over consumption. Thus the electric energy power generation system is used effectively, even when restrictions for energy injection improper exists.

1 September 2017
Verified
Conference Paper
Closed access
JJJacinto Maria Jiménez-Martínez
Jacinto Maria Jiménez-Martínez
EBEsther De Jodar Bonilla
Esther De Jodar Bonilla
AAAntonio Mateo Aroca
Antonio Mateo Aroca
JMJose A. Villarejo Manas
Jose A. Villarejo Manas