Vanadium dioxide is an intensively studied material that undergoes a temperature-induced metal–insulator phase transition accompanied by a large change in electrical resistivity. Electrical...
We report the fabrication of VO2-based two terminal devices with ∼125-nm gaps between the two electrodes, using a simple, cost-effective method employing optical lithography and shadow evaporation. Current-voltage characteristics of the obtained devices show a main abrupt metal-insulator transition (MIT) in the VO2 film with voltage threshold values of several volts, followed by secondary MIT steps due to the nanostructured morphology of the layer. By applying to the two-terminal device a pulsed voltage over the MIT threshold, the measured switching time was as low as 4.5 ns and its value does not significantly change with device temperature, supporting the evidence of an electronically driven MIT.
Thermomagnetic patterning (TMP) of 4 μm thick high performance NdFeB hard magnetic films deposited on Si substrates has been achieved using single pulsed laser irradiation. Uniaxially magnetised chessboard and stripe patterns with lateral feature sizes in the range 50–100 μm were produced. The depth of reversal was estimated, using both global (vibrating sample magnetometry) and localized (scanning Hall probe) measurements, to be in the range of 1.1–1.2 μm. A simple model provides semiquantitative agreement with the experimental results. A linear Halbach array was fabricated to demonstrate the potential of TMP for the realization of complex multidirectional microflux sources.
17 January 2005 in IEEE Transactions on Microwave Theory and Techniques
This paper presents the development of tunable filters using ohmic contact microelectromechanical system switches. It is shown that this type of switch is very well suited for the fabrication of low-loss high tuning-range microwave filters. Two sets of tunable Ku-band microstrip filters and resonators have been fabricated, with measured tuning ranges of 20% and 44%, and unloaded quality factors better than 75 in all cases. The 2-bit 5.7% fractional bandwidth, tunable bandpass filters exhibit insertion losses lower than 3.2 dB in all states.
The metal-insulator switching characteristics of play a crucial role in the performances of -based devices. In this paper we study high-quality (010)-oriented epitaxial films grown on (001) sapphire substrates by means of electron-beam evaporation and investigate the role of interface defects and thermal strain on the parallel evolution of the metal-insulator transition (MIT) and structural phase transition (SPT) between the monoclinic (insulator) and rutile (metal) phases. It is demonstrated that the highly-mismatched interface promotes a domain-matching epitaxial growth process where the film grows in a strain-relaxed state and the lattice distortions are confined at the interface in regions with limited spatial extent. Upon cooling down from the growth temperature, tensile strain is stored in the films as a consequence of the thermal expansion mismatch between and . The thinnest films exhibit the highest level of tensile strain in the interfacial plane resulting in a shift of both the MIT and the SPT temperatures towards higher values, pointing to a stabilization of the monoclinic/insulating phase. Concomitantly, the electrical switching characteristics are altered (lower resistivity ratio and broader transition) as a result of the presence of structural defects located at the interface. The SPT exhibits a similar evolution with, additionally, a broader hysteresis due to the formation of an intermediate, strain-stabilized phase in the M1-R transition. Films with thickness ranging between 100–300 nm undergo a partial strain relaxation and exhibit the best performances, with a sharp ( temperature range) and narrow (hysteresis ) MIT extending over more than four orders of magnitude in resistivity .
Electrically activated metal-insulator transition (MIT) in vanadium dioxide (VO2) is widely studied from both fundamental and practical points of view. It can give valuable insights on the currently controversial phase transition mechanism in this material and, at the same time, allows the development of original MIT-based electronic devices. Electrically triggered insulator-metal transitions are demonstrated in novel out-of-plane, metal-oxide-metal type devices integrating a VO2 thin film, upon applying moderate threshold voltages. It is shown that the current-voltage characteristics of such devices present clear negative differential resistance effects supporting the onset of continuous, current-driven phase oscillations across the vanadium dioxide material. The frequencies of these self-sustained oscillations are ranging from 90 to 300 kHz and they may be tuned by adjusting the injected current. A phenomenological model of the device and its command circuit is developed, and allows to extract the analytical expressions of the oscillation frequencies and to simulate the electrical oscillatory phenomena developed across the VO2 material. Such out-of-plane devices may further contribute to the general understanding of the driving mechanism in metal-insulator transition materials and devices, a prerequisite to promising applications in high speed/high frequency networks of oscillatory or resistive memories circuits.