The as-extruded (EX) Mg-Gd-Y alloy studied here exhibited a bimodal structure, composed of fine dynamic recrystallized (DRXed) grains with random orientations and longitudinal coarse hot-worked grains. The slip analysis showed the DRXed grains exhibited mainly basal slips, while the hot-worked grains exhibited mainly prismatic slips during the tensile deformation. The distribution of geometrically necessary dislocations (GNDs) showed that there was strain partitioning between the fine and coarse grain regions. The hetero-deformation induced (HDI) hardening occurred between the two domains. It improves the strength and strain hardening capability of the alloy, leading to good strength-ductility synergy. Microcracks tended to nucleate at the DRXed grain boundaries, as well as at the interface between the two domains. The calculation of geometric compatibility parameter (m’) indicated that strain incompatibility between the adjacent grains induced the crack nucleation. The toughening effect of the fine DRXed grains hindered the crack propagation. However, the major crack formed at the interface between the two domains propagated unstably, due to the high stress concentration and the large crack size, causing the final failure.
The deformation behaviors of a gradient-structured (GS) Mg-Gd-Y-Zr alloy, prepared via surface mechanical attrition treatment (SMAT), were systematically investigated in comparison with those of a uniform coarse-grained (CG) counterpart by high-temperature tensile tests at high strain rates (≤400 °C and ≥0.01 s−1). The results indicated that the uniform CG samples exhibited high flow stresses and low elongations (43.9% at 400 °C and 0.01 s−1). Their fraction of dynamic recrystallization (DRX) during the hot deformation was very low, and the dislocations accumulated inside the deformed grains formed high residual stresses. Moreover, the solely operated prismatic slips in the coarse grains implied insufficient deformation coordination. These resulted in their low deformability. By contrast, the GS samples formed by SMAT exhibited more stable flow behaviors, showing lower flow stresses and higher elongations (71.9% at 400 °C and 0.01 s−1). The high dislocation density in the severely deformed (SD) layer provided sufficient driving force for DRX, promoting remarkable softening effect during the hot deformation. The grain boundary slip mechanism facilitated by DRX in the SD layer played a significant role in the hot deformation, enhancing the overall plasticity of the GS samples, although the deformed coarse-grained (DCG) layer deformed in a manner resembling that of the CG samples.