On-site, instrument free quantitative analysis of pesticides is of significant importance for food safety control. However, it is still a great challenge for pesticide detection in food via the current visual detection methods due to the presence of interferents in a complex matrix. In this study, a complex tea matrix had a strong effect on a gold nanoparticles (Au NPs) based colorimetric sensor for the detection of pesticides. Here, a porous chitosan/partially reduced graphene oxide/diatomite (CS/prGO/DM) composite was successfully synthesized via a facile hydrothermal treatment. It could act as an efficient adsorbent for removing different types of tea interferents. A colorimetric sensing platform for the quantitative detection of pesticides in a complex matrix was successfully established. The color changes of the aggregation of Au NPs induced by pesticides were captured using the camera of a smartphone and the images were processed with average RGB (red, green, and blue) values obtained using self-developed software. The G/R values and A700/525 values obtained from UV-vis spectra could be used for quantitative analysis of pesticides. The limits of detection of phosalone and thiram in tea were 90 nM and 13.8 nM, respectively. It is expected that graphene-based materials are attractive for wide application of on-site colorimetric quantitative detection in a variety of fields like environmental protection, food safety and bioanalysis.
26 April 2024 in Science China Technological Sciences
This article presents a binocular visuotactile sensor (BVTS) and its model for reconstructing the 3-D deformation due to mechanical contact on its elastomer surface. The model explicitly accounts for the refraction effects of the elastomer on the depth map reconstructed from the imaged markers. To help gain physical insights into the refraction effects on the depth map reconstruction and experimentally analyze the effectiveness of the model-based BVTS, a prototype BVTS has been developed for experimental investigation. The refractive indexes of the elastomer, the acrylics, and their combination are experimentally determined from the model-based reconstruction and verified with that measured by a spectroscopic ellipsometer; the differences are within 3%. As a basis for evaluation, the reconstructed depth maps are compared with that of the two other commonly used practices, stereovision (SV) calibration without considering refraction and integration camera model that lumps the refraction effects with the SV parameters during calibration. By explicitly modeling the refraction physics using ray tracing, the model-based BVTS faithfully reconstructs the points on the actual height and is capable of dynamically tracking small torsional displacements with balls of different radii (3–15 mm) with a depth error below 4%.
30 April 2020 in IEEE/ASME Transactions on Mechatronics
In metal cutting, a good understanding of both the elastic-plastic deformation and the mechanical behavior of the workpiece material in the primary shear band (PSB) is essential to optimize machining process and ensure product quality, particularly when machining hard-to-cut materials (such as Titanium alloys) with a low thermal conductivity that gives rise to thermal stress localization near the tool-chip interface. This paper presents an extended digital image correlation (DIC) method to obtain the highly intensive and localized elastic-plastic strain and stress fields in the PSB during cutting, the reconstruction of which requires the deformation history of each material point and an appropriate material constitutive model. Unlike existing DIC methods that infer elastic strains from two sequential images, the extended DIC not only reconstructs the displacement field but more importantly also captures the elastoplastic evolution of the material during the dynamic orthogonal cutting process, from which the plastic strain/stress fields in the PSB are determined experimentally. The effectiveness of the extended DIC method was evaluated numerically and experimentally for orthogonal cutting of Ti-6Al-4V alloys.