Joel Kimarai

Mr. Joel Kimarai

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2026 in Scientific Reports
Verified
Journal Article
Open access
PDF file
Joel KimaraiJoel Kimarai
Joel Kimarai
NGNaftary Gathimba
Naftary Gathimba
SASilvester Ochieng Abuodha
Silvester Ochieng Abuodha
VOVictoria Okumu
Victoria Okumu
Cotton Waste Fibers (CWF), a non-synthetic industrial by-product, form a type of micro-diameter concrete reinforcing fibrous material. Fiber dispersion and fiber balling reduce the application of CWF in structural concrete due to discontinuous interfacial transition zones (ITZ) in the concrete matrix. In this paper, compressive strength development and flexural toughness of concrete with 0%–1.5% 0.25 mm diameter and 50 mm length CWF fibres, designed using the densified mix design algorithm (DMDA) method, were studied. Two coarse aggregate (CA) grades: S1(10–12.5) mm and S2(5–10) mm; an intermediate aggregate (IA), S3(2.36–5) mm; and Natural River Sand (NRS) of 5 mm maximum aggregate size (MAS) fine aggregate (FA), and CEM II were adopted. An intermediate and coarse aggregate blend ratio of 1:1.33:5.34 in S3:S2:S1, enough to saturate the aggregate-to-aggregate pores, and an overall concrete mix proportion of 1:1.3:2.6, were achieved. A 0.38 water-cement (w/c) ratio and a maximum 0.0703 water-solid (w/s) ratio for 1.5% CWF dosage were used. A total of 84 cubes, 42 cylindrical, and 42 unnotched prisms, and 21 notched beam specimens were cast and cured at ambient temperature to determine the compressive strength, tensile strength, flexural strength, and toughness properties of CWF-HSC, respectively. A 62.71 MPa 28-day compressive strength was achieved in the control specimens, while a 0.37%, 0.88%, and 3.05% improvements in 0.25%, 0.50%, and 0,75% CWF was followed by a strength decline in 1%, 1.25%, and 1.50%, respectively. All CWF-HSC specimens achieved a higher early strength gain from 0.02 MPa/hr. to 0.13 MPa/Hr. in 0.25% and 1.5% CWF dosages, and a 0.08 MPa/Hr. gain rate at optimal 0.75% fiber dosage, compared to the control specimens. At all CWF dosages, an increase in tensile strength from 3.703 MPa up to 26.36% at 0.75% fiber content; while the flexural strength improved from 7.201 MPa in control specimens by 8.75%, 14.05%, and 16.44% in 0.25%, 0.50%, and 0.75% CWF content, followed by a slight decline up to 1.5% dosages. The peak and limit flexural toughness, I5 and I10, in specimens with CWF improved from 1 KJ/m2 to 1.73 KJ/m2 and 4.21 KJ/m2 at 0% and 0.75% CWF dosages, respectively. These experimental results confirm the feasibility of using sorted industrial cotton waste fibers in structural concrete within a DMDA framework for better fiber dispersion to enhance both strength development and flexural toughness properties.

23 March 2023 in Research Square
Verified
Preprint
Open access
PDF file
Joel KimaraiJoel Kimarai
Joel Kimarai
This research aimed at testing the viability of using Sorghum Stalk Ash (SSA) as a partial replacement of lime in the stabilization of red clay soils for road subgrade construction. Red clay soils have been identified as highly expansive soils, which are affected by both climatic conditions and loading patterns. The consideration of both traffic loading patterns and climatic effects on these soils has been taken into account. A penetration test of 2.5mm has been used on both pure red soils and stabilized soils at 10% and 15% partial replacement of lime with SSA and showed an improvement in the CBR of stabilized red clay soils up to 11.6%. Again, the PI of stabilized soils at 15% partial replacement of lime reduced up to 11.2%. The results obtained on both CBR and PI of these red clay soils are within the recommended values for the effective subgrade required for laying both permanent and flexible pavements. As a result, a recommendation of making use of SSA to lower the quantities of lime and its costs used in the stabilization of highly expansive soils have been tested through this research. However, further research on a more percentage partial replacement of lime to improve the PI of these soils to below 10% while keeping the CBR levels within the road construction regulations is welcomed. Therefore, the use of sorghum stalk plant parts in this study complies with international, national, and institutional guidelines regarding the properties of an effective pozzolana material.

23 July 2026 in Construction Materials
Verified
Journal Article
Open access
PDF file
Joel KimaraiJoel Kimarai
Joel Kimarai
NGNaftary Gathimba
Naftary Gathimba
SASilvester Ochieng Abuodha
Silvester Ochieng Abuodha
VOVictoria Okumu
Victoria Okumu
The structural performance of reinforced concrete (RC) deep beams in both ultimate and serviceability limit states (ULSs/SLSs) is influenced by beam size effects and the adopted reinforcement ratios. In this study, the effects of cotton waste fibres (CWFs) and beam depth were studied using a four-point load test on five sets of 400 mm and 500 mm CWF high-strength RC deep beams with a 0.3% web reinforcement ratio. Control unnotched and notched, and notched specimens with 0–0.75% CWF content in each specimen set, were studied. The failure modes, stirrup and strut-and-tie zones’ strains, shear capacity, and load-deflection were analyzed. It was observed that the beam failure evolved from shear-compression in unnotched specimens to the web-splitting failure phenomenon in notched ones, coupled by 27.44% and 0.17% decline in ultimate shear capacity (Vu) in notched 400 mm and 500 mm beam sets, respectively. The notched RC deep beam specimens, mimicking the SLS shear performance parameters, showed a 34.28% and 14.71% Vu increase in 400 mm and 500 mm depth beams, respectively. The crack opening load increased from 13.87 kN to 44.63 k and from 11.88 kN to 35.19 kN in these beam sets, respectively. In a similar analysis, 84.76% and 38.39% stiffness increase, and 49.15% and 39.95% shear ductility index increase in the outer-most stirrup, were observed in the respective specimen sets. The contribution factor of the shear reinforcement to Vu improved from 0.31 to 0.94, and from 0.87 to 0.97 in 400 mm and 500 mm, with 0% and 0.75% CWF, respectively. These experimental results confirm the contribution of beam size effect and fibres to the shear performance properties of RC deep beams. The feasibility of using CWF in structural concrete is confirmed by its improvement of the SLS properties of the studied RC deep beam specimens with light shear reinforcement.