Julijana Bojadjieva

Prof. Dr. Julijana Bojadjieva

Unuversity Ss Cyril and Methodius, Skopje, North Macedonia
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 October 2017 in Landslides
Verified
Journal Article
Closed access
PDF file
JBJulijana Bojadjieva
Julijana Bojadjieva
VSVlatko Sheshov
Vlatko Sheshov
CBChristophe Bonnard
Christophe Bonnard

25 March 2025 in Landslides
Verified
Journal Article
Closed access
PDF file
JBJulijana Bojadjieva
Julijana Bojadjieva
SFStavroula Fotopoulou
Stavroula Fotopoulou
FBFrancesca Bozzoni
Francesca Bozzoni
VSVlatko Sheshov
Vlatko Sheshov
KEKemal Edip
Kemal Edip
BBBarbara Borzi
Barbara Borzi

31 July 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JBJordan Bojadjiev
Jordan Bojadjiev
RARoberta Apostolska
Roberta Apostolska
GCGolubka Necevska Cvetanovska
Golubka Necevska Cvetanovska
Damir VarevacDamir Varevac
Damir Varevac
JBJulijana Bojadjieva
Julijana Bojadjieva
For the past few decades, during each disastrous earthquake, severe damage and poor seismic performance of masonry infilled RC frames, including many newly designed ones, have been reported extensively. Inherent problems related to analysis and design methods for tight-fit infilled frame structures have not yet been solved and are recognized as being far from satisfactory in terms of completeness and reliability. The primary objective of this research was to propose and test an innovative method that can effectively mitigate undesirable interaction damage to masonry infilled RC frame structures. This proposed technical solution consists of connection of the infill panel to the bounding columns with steel reinforcement connections deployed in mortar layers and anchored to the columns. This is practical, cheap and easy to implement without any specific technology, which is especially important for developing countries. A three story, two bay RC building model with the proposed connection implemented on the infill walls was designed and tested on the shake table at IZIIS in Skopje, N. Macedonia. The test results and design guidelines/recommendations from the proposed research are also expected to benefit the infrastructural development in other countries threatened by earthquakes, preferably in the Balkan and the Mediterranean region.


29 September 2022 in Geosciences
Verified
Journal Article
Open access
PDF file
JBJulijana Bojadjieva
Julijana Bojadjieva
VSVlatko Sheshov
Vlatko Sheshov
Kemal EdipKemal Edip
Kemal Edip
TKToni Kitanovski
Toni Kitanovski
Within the presented research, model tests were performed in 1-g conditions to investigate the liquefaction potential of Skopje sand as a representative soil from the Vardar River’s terraces in N. Macedonia. A series of shaking table tests were performed on a fully saturated, homogeneous model of Skopje sand in the newly designed and constructed laminar container in the Institute of Earthquake Engineering and Engineering Seismology (IZIIS), Skopje, N. Macedonia. The liquefaction depth in each shaking test was estimated based on the measured acceleration and pore water pressure as well as the frame movements of the laminar container. The surface settlement measurements indicated that the relative density increased by ~12% after each test. The observations from the tests confirmed that liquefaction was initiated along the depth at approximately the same time. The number of cycles required for liquefaction increased as the relative density increased. As the pore water pressure rose and reached the value of the effective stresses, the acceleration decreased, thus the period of the soil started to elongate. The results showed that the investigated Skopje sand was highly sensitive to void parameters and, under specific stress conditions, the liquefaction that occurred could be associated with large deformations. The presented experimental setup and soil material represent a well-proven example of a facility for continuous and sustainable research in earthquake geotechnical engineering.

24 December 2025 in Buildings
Verified
Journal Article
Open access
PDF file
Antonio FormisanoAntonio Formisano
Antonio Formisano
Aleksandra BogdanovicAleksandra Bogdanovic
Aleksandra Bogdanovic
ASAntonio Shoklarovski
Antonio Shoklarovski
Marco DomaneschiMarco Domaneschi
Marco Domaneschi
Emilia MeglioEmilia Meglio
Emilia Meglio
Giuseppe Carlo MaranoGiuseppe Carlo Marano
Giuseppe Carlo Marano
This paper presents the outcomes of an extensive experimental investigation on the seismic performance of an innovative exoskeleton retrofitting system, developed as part of the ERIES-RESUME project. The proposed system integrates laminated timber and aluminium components to enhance the structural resilience of existing reinforced concrete (RC) buildings, while also offering the potential for thermal upgrading. Two identical 1:3 scale RC models, representing typical non-ductile structures, were tested on a shaking table at the IZIIS Laboratory of the Institute of Earthquake Engineering and Engineering Seismology in Skopje. The first model, initially unstrengthened, was subjected to seismic loads until significant structural and infill-wall damage was reached. Following appropriate repairs, the exoskeleton was applied, and the model was retested. The second model was equipped with an exoskeleton from the outset. Test results demonstrate significant improvements in seismic performance, including increased stiffness, reduced interstory drifts, reduced acceleration amplification, and reduced infill wall damage. The study confirms the feasibility and effectiveness of the proposed exoskeleton system as a practical solution for retrofitting vulnerable reinforced concrete buildings.