The subject of this paper is improvement in the growth and yield of three different types of legumes and rape in drought conditions by coating seeds with hydrolysed collagen from tanning waste. In addition, the impact of various additives in the seed shell on the growth of the plant was investigated. The encapsulation process of seeds was conducted on a disc granulator. A centrally placed seed was first coated with a layer of fungicides. The next layer was collagen hydrolysate, collagen hydrolysate with latex or a solution of yellow dextrin and polyvinyl alcohol. The outer layer was a mineral additive e.g. dolomite or kaolin. After the end of the encapsulation process on the disk granulator, all of the seeds tested were sown into soils. Seeds without coating were also sown as control seeds. Seedlings were maintained for 29 days with cultivation without irrigation. The length of the seedlings was analysed for all of the seeds sown. Higher seedling growth values were obtained for seeds coated with collagen hydrolysate in comparison with control seeds (without coating). The use of collagen hydrolysate gave slightly better results than in the case of a solution of dextrin with polyvinyl alcohol.

Chrome tanned leather shavings (CTLS) are considered one of the more difficult wastes to manage in the tanning industry. At the same time, this waste is an important source of good quality collagen. The few methods described in the literature for the valorization of these wastes usually require pre-treatment or activation. In this study, an attempt was made to see if raw chrome tanned leather shavings (CTLS) could be modified to obtain secondary raw materials with new physical properties. Glutaraldehyde, glycerol, EDCs, pectin, and tannins were selected for modification of the CTLS. The effectiveness of the processes carried out was confirmed by FTIR analysis of the materials obtained. Changes in the intensity of the characteristic collagen peak (amide I, amide II, and amide III) and changes in the position of the bands in the 1200–1000 cm⁻¹ region were observed in the recorded spectra. The modifications introduced confirmed changes in the physical properties of samples M1–M5, including an increase in bulk density from 0.15 to 0.59 g cm⁻³, and improved tensile strength is some cases. The elemental content results of the samples tested showed the resulting modified CTLS were free of Cd, Hg, Pb, and Cr(VI). It was also confirmed tanning waste contained significant amounts of various valuable elements. The research also included preliminary tests to assess the environmental impact of the modified materials. In a phytotoxicity test conducted on modified CTLS, M1 with pectins showed the highest root stimulation (105%), while samples with glutaraldehyde and unmodified CTLS showed significant root inhibition (75%, 74%). Other samples showed moderate plant toxicity and seed germination was not significantly affected.

Erysiphe alphitoides is a species of powdery mildew responsible for the major foliar disease of oak trees, including Quercus robur. Infection with E. alphitoides leads to a reduction in the growth of the trees and in their ability to survive. This paper reports on the biochemical changes characteristic of defence responses in oak leaves with different infection area sizes, collected in July, August, and September during three growing seasons. The study highlights the effect of E. alphitoides infection on changes in the ascorbate-glutathione cycle, phenolic compound profile, and metal content (mineral distribution). Visible symptoms of pathogen infection appeared gradually in July, but the most intense biochemical plant responses in oak leaves were detected mainly in August and September. These responses included increased ascorbate-glutathione enzyme activities, phenolic compounds, and metal contents. In addition, microscopic analyses revealed a strong fluorescence signal of lignin in the epidermis of pathogen-infected leaves. The involvement of the studied compounds in the basic defence mechanisms of oak against E. alphitoides infection is discussed in the paper.

The aim of this study was to investigate the effects of treating maize (Zea mays L.) seeds with fish collagen hydrolysate (FC) and keratin (KE) derived from animal waste by-products of leather and meat production, as well as poly(hexamethylene biguanide) hydrochloride (P) and bentonite (B). This research is in line with the search for new, environmentally friendly methods to increase yields of industrial crops in a way that is compatible with sustainable development. The effect of the binders used was investigated by analysing the grown maize seedlings by determining changes in parameters of chlorophyll fluorescence, photosynthetic pigments, elemental composition and FTIR analysis on maize shoots. The results indicated a slightly higher fresh weight (FW) of shoots in plants treated with fish collagen, PHMB and bentonite (FC+P+B) and FW of roots in plants treated with keratin, PHMB and bentonite (KE+P+B). Unexpectedly, the FW and dry weight (DW) of both roots and shoots of all bentonite-treated plants were significantly higher than the corresponding non-bentonite-treated groups. In addition, changes in chlorophyll-a fluorescence were observed for the keratin, PHMB and bentonite variants. This study showed that the proposed materials could be promising seed pelleting agents to improve seed growth and yield.