Microplastics (MPs) are an emerging environmental issue that might endanger the health of agricultural soil. Even though several research on the particular toxicity of MPs to species have been carried out, there is little information on MPs’ impacts on soil physicochemical properties and heavy metals (HMs) availability of HMs contaminated and without contaminated soils. This study examined the changes in soil characteristics for both HMs contaminated and without contaminated soils by five distinct MPs, including Polyethylene (PE), Polyethylene terephthalate (PET), Polystyrene Foam (PS), Polyamide (PA), and a combination of these four types of MPs (Mixed MPs), at two different concentrations (0.2% and 1%; w/w), where soil incubation experiments were setup for this studies and the standard analytical techniques employed to measure soil characteristics and toxic metal availability. After the ending of soil incubation studies (90 days), significant changes have been observed for physicochemical properties [bulk density, porosity, water holding capacity, pH, electrical conductivity (EC), organic carbon (OC), and organic matter (OM)]. The soil nutrients change in descending order was found as NH₄⁺ -N> PO₄³⁺ > Na > Ca > NO₃^- > Mg for lower concentrations of MPs compared to higher concentrations. The HMs availability is reducing with increasing MPs concentration and the descending order for metal availability was as follows Pb > Zn > Cd > Cr > Cu > Ni. Based on MP type, the following descending order of MPs PS > Mix (MPs) > PA > PET > PE, respectively act as a soil properties influencer. Usually, effects were reliant on MPs’ category and concentrations. Finally, this study concludes that MPs may modify metal movements, and soil quality; consequently, a possible threat will be created for soil health.

Rapid urbanization and industrial development have prompted potentially toxic elements (PTEs) in urban soil in Bangladesh, which is a great concern for ecological and public health matters. The present study explored the receptor-based sources, probable human health and ecological risks of PTEs (As, Cd, Pb, Cr, Ni, and Cu) in the urban soil of the Jashore district, Bangladesh. The USEPA modified method 3050B and atomic absorption spectrophotometers were used to digest and evaluate the PTEs concentration in 71 soil samples collected from eleven different land use areas, respectively. The concentration ranges of As, Cd, Pb, Cr, Ni, and Cu in the studied soils were 1.8-18.09, 0.1-3.58, 0.4-113.26, 0.9-72.09, 2.1-68.23, and 3.82-212.57 mg/kg, respectively. The contamination factor (CF), pollution load index (PLI), and enrichment factor (EF) were applied to evaluate the ecological risk posed by PTEs in soils. Soil quality evaluation indices showed that Cd was a great contributor to soil pollution. The PLI values range was 0.48-2.82, indicating base levels to continuous soil degradation. The positive matrix factorization (PMF) model showed that As (50.3 %), Cd (38.8 %), Cu (64.7 %), Pb (81.8 %) and Ni (47.2 %) were derived from industrial sources and mixed anthropogenic sources, while Cr (78.1 %) from natural sources. The highest contamination was found in the metal workshop, followed by the industrial area, and brick filed site. Soil from all land use types revealed moderate to high ecological risk after evaluating probable ecological risks, and the descending order of single metal potential ecological risk was Cd > As > Pb > Cu > Ni > Cr. Ingestion was the primary route of exposure to potentially toxic elements for both adults and children from the study area soil. The overall non-cancer risk to human health is caused by PTEs for children (HI=0.65 ± 0.1) and adults (HI=0.09 ± 0.03) under USEPA safe limit (HI>1), while the cancer risks from exclusively ingesting As through soil were 2.10E-03 and 2.74E-04 for children and adults, respectively, exceeding the USEPA acceptable standard (>1E-04).