Due to environmental issues and rising costs of construction materials, there is an increasing desire to use reclaimed asphalt pavement (RAP) material in road construction. However, using too much of this material may lead to impairment of fundamental properties of asphalt mix. Glass fibre material is a well-known modifier and could be used to compensate possible downgrade of properties. Research articles and theoretical material have shown that adding too much fibre glass reinforcement could cause damage to asphalt mixture. Therefore, in this research, reference mixture has been compared to three projected AC 11 surface mixtures with different amount of fibre glass. The same has been done to HMAC mixtures, but in this case, there is crumb rubber used as mixture modifier. Experimental part has shown that using fibre glass in asphalt mixtures for both construction layers may have positive influence on fundamental parameters of HMAC and AC asphalt mixes, which can be a good solvation for using waste glass fibre in road construction.
This study examines the influence of virgin polyethylene (vPE), recycled polyethylene (rPE), and Aerosil (A) on the performance of bitumen binders modified with partially devulcanized rubber (DVR). The experimental program included morphology analysis, determination of devulcanization degree, dynamic viscosity measurements, shear stress–shear rate analysis, load–displacement (F–Δl) testing, storage-stability evaluation, ring and ball softening point (R&B), penetration (P), and elastic recovery (ER) testing. The results show that DVR-rPE-modified bitumen binders exhibit 20–35% higher viscosity and up to 25% greater elongation at the break compared to DVR-vPE-modified bitumen systems, indicating more effective interaction with the bitumen matrix. The incorporation of Aerosil increased viscosity ca. 1.5–2 times for DVR-rPE and DVR-vPE-modified systems, respectively. Meanwhile, top and bottom differences in R&B decreased by a factor of 1.6–5 for DVR-rPE and DVR-vPE-containing composites, respectively, demonstrating significant enhancement in structural stability during storage. Mechanical testing further revealed that DVR-rPE + A binders absorbed 10–20% more deformation energy and consistently maintained ER values above 70–80%, corresponding to a higher elastic recovery grade at 25 °C. Overall, the DVR-rPE + A system provided the most balanced improvements in rheological, mechanical, and thermal properties, confirming its potential for use in high-performance, thermally stable, and environmentally sustainable bituminous materials for pavement applications.
The accumulation of end-of-life tires and post-consumer polyolefin waste is a growing environmental burden, and their reuse as bitumen modifiers offers a sustainable, large-volume outlet in road construction. This study investigated paving-grade bitumen modified with four pre-compounded, partially devulcanized rubber (DVR)-recycled-polymer composites, differing in polymer type and, for two of the systems, in styrene–butadiene–styrene (SBS) chain architecture (linear or radial), added at 9–15 wt.%. The modified binders were characterized by penetration, softening point, elastic recovery, force ductility, low-temperature brittleness, and dynamic shear rheometry (DSR), together with FTIR, TGA, and fluorescence microscopy. All four composites improved binder stiffness, elasticity, and high-temperature rheology relative to the unmodified bitumen, with the two SBS-containing systems performing best overall. At the highest modifier content, the best-performing composite roughly halved the penetration and raised both the softening point and the higher critical temperature or rutting parameter by approximately 28–30 °C, while also markedly improving elastic recovery and low-temperature flexibility relative to the base bitumen. These findings indicate that SBS-containing devulcanized-rubber/recycled-polymer composites are promising sustainable modifiers for producing high-performance bituminous binders from waste-derived materials.
About Me
Mg.sc. Transportation engineering
Ph.D. Student at RigaTechnical univesrity
Science assistant
Mg.sc. Transportation engineering
Ph.D. Student at RigaTechnical univesrity
Science assistant