A new topology for a current-mode multi-phase sinusoidal oscillator (MSO) is introduced. It is designed using current-differencing cascaded transconductance amplifiers (CDCTAs) and operational transconductance amplifiers (OTA). Both designs realize odd and even numbers of phase oscillators. The MSO is implemented by cascading first-order all-pass filter stages that are designed with CDCTAs or OTAs and show the same transfer function. The MSO includes n grounded resistors and n grounded capacitors to generate n phases. We highlight the advantage of using OTAs because the resulting MSO circuitry is greatly reduced compared to using CDCTAs, while in both designs the high output impedances facilitate easy driving an external load without additional current buffers. The condition of oscillation and the frequency of oscillation are orthogonal and can be adjusted by varying a bias current. Finally, SPICE simulation results using integrated circuit technology of 0.35 µm show that the designed MSO provides odd/even phase signals that are equally spaced in phase and with equal amplitude.
This paper presents the high-output-impedance current-mode multiphase sinusoidal oscillators (MSO) using voltage differencing current conveyor (VDCC)-based lossy integrators, which consist of one VDCC, one grounded capacitor, and two grounded resistors. The proposed oscillator can provide an odd-phase and even-phase system without the use of an additional amplifier. The frequency of oscillation (FO) is electronically tuned via the bias current without affecting the condition of oscillation (CO). The proposed oscillator is designed to obtain three-phase sinusoidal waveforms (n = 3). The effect of non-idealities of VDCC on the lossy integrator section is also investigated. The validity of the proposed circuit is demonstrated by PSPICE simulation using 0.18 µm TSMC CMOS process parameters with ±0.9V power supply. The frequency of oscillation obtained from the simulation is 1.43 MHz. The total harmonic distortions of the sinusoidal output currents IO1, IO2, and IO2 are 1.22%, 1.18%, and 0.57%. The IO1–IO2 and IO2–IO3 phase differences are approximately 121 and 119 degrees, respectively. The feasibility of the proposed MSO is also verified with experimental results using the VDCC constructed from the commercially available ICs (LT1288 and AD844) with ±5 V power supply. The results of PSPICE simulations and experiments are closely consistent with the theoretical expectation.
1 December 2024 in Bulletin of Electrical Engineering and Informatics
In late Q1/2023, DTAC and TRUE officially completed their merger. Consequently, this study was initiated to ascertain whether their respective fifth-generation (5G) networks had been seamlessly integrated several months following the merger. The investigation involved conducting drive tests along two predefined routes within the urban areas of Bangkok, employing the G-NetTrack pro tool for testing and data collection. Additionally, stationary tests were conducted in two crowded places using an application called Speedtest. Subsequently, an array of quality of service (QoS) metrics, including reference signal received power (RSRP), reference signal received quality (RSRQ), signal to noise ratio (SNR), download (DL), upload (UL) speeds and latency, were meticulously analyzed and presented. The findings of this study unveiled that, despite the successful completion of the DTAC and TRUE merger from a business standpoint, the technical integration of their respective 5G networks had not been finalized, although there were no significant differences between DTAC and TRUE for DL (p-value=0.542) and UL (p-value=0.090). Notably, significant differences were found between DTAC and TRUE for four metrics, including RSRP, RSRQ, SNR and latency (p-values0.05). Remarkably, roaming functionalities were still operational between the two networks.
1 August 2024 in Bulletin of Electrical Engineering and Informatics
This article compares two of the leading mobile network operators (MNOs) in Thailand’s telecom market in terms of the service quality of Thailand’s fifth generation (5G) networks. The following three factors: download speed, upload speed, and latency, which are frequently considered to be indicators of the quality of Internet networks, were examined. The researchers employed the test results to determine the quality of service (QoS) that was achieved by comparing newly collected data to data that had previously been examined utilizing the same format and application in the middle of May 2021. The average download speed decreased from 196.4 Mbps in 2021 to 140.4 Mbps in 2023, while the average upload speed dropped from 62.6 Mbps in 2021 to 52.0 Mbps in 2023. Furthermore, the average latency increased from 14.9 ms in 2021 to 23.3 ms in 2023. These results show a considerably enhanced service although the test region in this study only comprised BTS stations. Furthermore, this was the case even though the test area in this study only encompassed a small percentage of the total population.
1 February 2025 in Bulletin of Electrical Engineering and Informatics
Since the launch of fifth generation (5G) services in Thailand in 2020, there have been continuous improvements in 5G coverage. Currently, 5G coverage extends to most areas throughout the country. However, coverage issues persist not only in rural areas but also in high-rise buildings in urban areas. Consequently, a study was conducted within such buildings. This paper assesses the performance of 5G at different altitude test points. The chosen location for the field tests was a high-rise building within a crowded public hospital, which receives numerous patients every weekday, in the major urban area of Bangkok. Two smartphones from the same manufacturer, both supporting 5G technology and equipped with the Speedtest application, were employed as tools for this study. Tests were carried out on the third and twenty-fourth floors of the high-rise building for data collection. The primary finding of this study reveals that download speeds exhibited a significant decrease with increasing altitude of the test points, as evidenced by statistical analysis (p-values0.001). This implies an issue with altitude-induced variations, indicating a need for the improvement of indoor 5G coverage in high-rise buildings.
1 April 2026 in Bulletin of Electrical Engineering and Informatics
This study provides a comprehensive synthesis of artificial intelligence (AI), especially machine learning (ML) and deep learning (DL) in ransomware defense. Using a “review of reviews” methodology based on the PRISMA, this paper gathers insights on how AI is transforming ransomware detection, prevention, and mitigation strategies in the past five years (2020-2024). The findings highlight the effectiveness of hybrid models, which combine multiple analysis techniques such as code inspection (static analysis) and behavior monitoring during execution (dynamic analysis). The study also explores anomaly detection and early warning mechanisms before encryption that tackle ransomware’s growing complexity. It also examines key challenges in ransomware defense, such as techniques designed to deceive AI driven detection, and the lack of strong and diverse datasets. It highlights AI’s role in early detection and real-time response systems, enhancing scalability and resilience. With the systematic review of reviews approach, the contributions of this study are systematically consolidating research insights from multiple review articles, identifying effective AI models, and bridging theory with practice to foster collaboration among academia, industry, and policymakers. Future research directions are anticipated and practical recommendations for cybersecurity practitioners are provided. Finally, it presents a roadmap for advancing AI-driven countermeasures, for the protection of key systems and infrastructures against evolving ransomware threats.