Luminita Marmurmureanu

Dr. Luminita Marmurmureanu

National Institute for Earth Physics, Măgurele, Ilfov, Romania
orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 May 2019 in Aerosol Science and Technology
Verified
Journal Article
Open access
Evelyn FreneyEvelyn Freney
Evelyn Freney
YZYunjiang Zhang
Yunjiang Zhang
PCPhilip Croteau
Philip Croteau
TATanguy Amodeo
Tanguy Amodeo
LWLeah Williams
Leah Williams
OFOlivier Favez
Olivier Favez
This work describes results obtained from the 2016 Aerosol Chemical Speciation Monitor (ACSM) intercomparison exercise performed at the Aerosol Chemical Monitor Calibration Center (ACMCC, France). Fifteen quadrupole ACSMs (Q_ACSM) from the European Research Infrastructure for the observation of Aerosols, Clouds and Trace gases (ACTRIS) network were calibrated using a new procedure that acquires calibration data under the same operating conditions as those used during sampling and hence gets information representative of instrument performance. The new calibration procedure notably resulted in a decrease in the spread of the measured sulfate mass concentrations, improving the reproducibility of inorganic species measurements between ACSMs as well as the consistency with co-located independent instruments. Tested calibration procedures also allowed for the investigation of artifacts in individual instruments, such as the overestimation of m/z 44 from organic aerosol. This effect was quantified by the m/z (mass-to-charge) 44 to nitrate ratio measured during ammonium nitrate calibrations, with values ranging from 0.03 to 0.26, showing that it can be significant for some instruments. The fragmentation table correction previously proposed to account for this artifact was applied to the measurements acquired during this study. For some instruments (those with high artifacts), this fragmentation table adjustment led to an “overcorrection” of the f44 (m/z 44/Org) signal. This correction based on measurements made with pure NH4NO3, assumes that the magnitude of the artifact is independent of chemical composition. Using data acquired at different NH4NO3 mixing ratios (from solutions of NH4NO3 and (NH4)2SO4) we observe that the magnitude of the artifact varies as a function of composition. Here we applied an updated correction, dependent on the ambient NO3 mass fraction, which resulted in an improved agreement in organic signal among instruments. This work illustrates the benefits of integrating new calibration procedures and artifact corrections, but also highlights the benefits of these intercomparison exercises to continue to improve our knowledge of how these instruments operate, and assist us in interpreting atmospheric chemistry.

23 December 2020 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
AHAndrás Hoffer
András Hoffer
BJBeatrix Jancsek-Turóczi
Beatrix Jancsek-Turóczi
ÁTÁdám Tóth
Ádám Tóth
GKGyula Kiss
Gyula Kiss
Anca BeczeAnca Becze
Anca Becze
AGAndrás Gelencsér
András Gelencsér
It is a common practice in developing countries and in some regions of Europe that solid wastes generated in households (e.g. plastic beverage packaging and other plastic wastes, textile wastes, fibreboards, furniture, tyres, and coloured-paper waste) are burned in wood- or coal-fired stoves during the winter months. In Europe, the types and volume of municipal waste burned in households is virtually unknown because these activities are illegal and not recorded, with the exception of a few media reports or court cases. Even though particulate emissions from illegal waste burning pose a significant hazard to human health due to the combination of excessive emission factors (EFs) and uncontrolled chemical composition, there is scarce information on the specific EFs for PM10 and polycyclic aromatic hydrocarbons (PAHs) in the scientific literature. In this work, controlled combustion tests were performed with 12 different types of municipal solid waste, and particulate emissions were measured and collected for chemical analysis. Absolute EFs for PM10 and PAHs as well as the benzo(a)pyrene (BaP) toxicity equivalent of the latter are reported for the first time for the indoor combustion of 12 common types of municipal solid waste that are frequently burned in households worldwide. It was found that the PM10 emission factors from the combustion of wood-based waste samples were about twice that of firewood, whereas EFs in the range of 11–82 mg g−1 (a factor of 5–40 times higher than that of dry firewood under the same conditions) were obtained for different types of plastic waste. The latter were also found to emit exceptionally high quantities of PAHs, by a factor of 50–750 more than upon the combustion of dry firewood under the same conditions. Since the more toxic 4–6 ring PAHs were predominant in the particulate emission from plastic waste burning, BaP equivalent toxicity was up to 4100 times higher than that from wood combustion.

12 February 2021 in International Journal of Climatology
Verified
Journal Article
Open access
PDF file
Bogdan AntonescuBogdan Antonescu
Bogdan Antonescu
Luminita MarmurmureanuLuminita Marmurmureanu
Luminita Marmurmureanu
Jeni VasilescuJeni Vasilescu
Jeni Vasilescu
CMCristina Antonia Marin
Cristina Antonia Marin
SASimona Andrei
Simona Andrei
AŢAlexandru Ţilea
Alexandru Ţilea
The bioclimatology of thermal stress over Europe between 1979 and 2019 was analysed using the Universal Thermal Climate Index (UTCI) derived from ERA5‐HEAT reanalysis. The bioclimatology of different European regions was assessed using Köppen–Geiger climate classification. The annual number of hours with heat stress (UTCI > 32°C) increased significantly during the study period for all the analysed Köppen–Geiger climate subclasses, showing also a clear increase towards southern Europe. The highest percentage of hours (20% of all hours) with cold stress (UTCI < −13°C) occur over northern Europe. A significant increasing trend (>0.05 hr·year−1) in the number of hours with heat stress was observed for 23 out of 32 analysed European cities representative for the Köppen–Geiger climate subclasses. For these cities not only the number of hours with heat stress has increased but also the heat stress is more persistent, while the number of cases and the persistence of the periods with cold stress have decreased over the last four decades. The UTCI values showed a statistically significant increase between 0.6 and 3.2°C for all the analysed cities over the study period reflecting the rising of global mean temperatures.

23 October 2019 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Luminita MarmurmureanuLuminita Marmurmureanu
Luminita Marmurmureanu
CMCristina Antonia Marin
Cristina Antonia Marin
SASimona Andrei
Simona Andrei
Bogdan AntonescuBogdan Antonescu
Bogdan Antonescu
DEDragos Ene
Dragos Ene
Erika LeveiErika Levei
Erika Levei
On the morning of 23 March 2018, an unusual phenomenon was observed over Romania where the southeastern part of the country was covered in a fresh-layer of orange snow. The event was extensively reported in mass-media and social-media and raised questions about the origin and the possible impact of the orange snow. Even if this type of events, intrusions of Saharan dust, have been reported before in Romania, and in Europe in general, their occurrence during negative temperature conditions is very rare. Saharan dust intrusion occurs over Europe mainly during spring and, in general, is not accompanied by snow at low altitudes. In this article, for the first time, the synoptic-scale conditions leading to the Saharan dust intrusion over Romania and the chemical and physical properties of the deposited dust particles in a snow layer were analyzed. The Saharan dust event affected a permanent atmospheric measurement research infrastructure located southwest of Bucharest, the capital city of Romania. In-situ and remote sensing measurements conducted at this research infrastructure allowed the identification of the dust source as the north Sahara. The source was confirmed by the elemental ratios of the main components (e.g., Al, Ca, Mg, Fe, K). For example, the (Ca+Mg)/Fe ratio of 1.39 was characteristic for the north Sahara. The dust morphology and the minerals were analyzed by scanning electron microscopy with energy disperse X-ray spectrometry (SEM/EDX). The size distribution of the particle geometric diameter showed that they are centred on 1 μ m, but larger particles up to 40 μ m are also present. To visualize the minerals, an approach was developed which emphasized the presence of the calcite, quartz or clay minerals. The optical parameters of dust were measured by re-suspending the particles. Values of the optical parameters (i.e., asymmetry parameter at 550 nm was 0.604, single scattering albedo was 0.84–0.89) were similar to those measured for Saharan dust intrusions over the Iberian Peninsula. Also, the non-refractory particles found in the dust-contaminated snow layer were analyzed, indicating the presence of HULIS-like compounds, most probably advected from the Mediterranean sea.

7 December 2021 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
AHAndrás Hoffer
András Hoffer
ÁTÁdám Tóth
Ádám Tóth
BJBeatrix Jancsek-Turóczi
Beatrix Jancsek-Turóczi
AMAttila Machon
Attila Machon
AMAida Meiramova
Aida Meiramova
AGAndrás Gelencsér
András Gelencsér
The production and use of plastics is increasing rapidly as they are widely used in packaging, construction materials, furniture, foils, etc. As a consequence of their widespread use and often disposable nature, vast streams of plastic waste are continuously generated, a considerable fraction of which are combusted in households worldwide. In this paper, various types of commonly used plastics (PE, PET, PP, PU, PVC, PS, ABS) as well as treated wood samples (LDF, low-density fibreboard) and firewood were combusted separately in a test stove under controlled conditions. The particulates emitted during the combustion test were collected on filters, potential tracers for each waste type were identified by GC-MS, and their relative abundances were determined. The emission factor of 1,3,5-triphenylbenzene was found to be higher for polymers containing aromatic rings in their structure. The application of terphenyls and quaterphenyls as tracer compounds has also been investigated. The trimer of styrene was found to be a potential tracer for the combustion of polystyrene and/or styrene-containing copolymers. Novel tracers were proposed for the burning of PET and furniture plates (LDF), which are among the most widely used waste types burned in households.

14 April 2020 in Atmosphere
Verified
Journal Article
Open access
PDF file
Luminita MarmurmureanuLuminita Marmurmureanu
Luminita Marmurmureanu
Jeni VasilescuJeni Vasilescu
Jeni Vasilescu
JSJay Slowik
Jay Slowik
APAndré S. H. Prévôt
André S. H. Prévôt
CMCristina Antonia Marin
Cristina Antonia Marin
SSSönke Szidat
Sönke Szidat
Aerosols and organic source apportionment were characterized using data collected during two measurement campaigns. These campaigns were conducted during the summer and winter seasons at Măgurele, a site located southwest of Bucharest, the capital of Romania and one of the largest cities in southeastern Europe (raking seven in Europe based on population). The summer campaign was conducted between 7 June–18 July 2012, and the winter campaign from 14 January–6 February 2013. Approximately 50% of the organic fraction contribution to the total submicron particulate matter sampled by aerosol mass spectrometer was evidenced during both seasons. Submicronic organic aerosol sources were quantified using the positive matrix factorization approach. For warm (summer) and cold (winter) seasons, more than 50% from total organics was represented by oxidized factors. For the summer season, separate analyses were conducted on data influenced by urban and non-urban sources. The influence of pollution from Bucharest on the measurement site was observed in aerosol concentration and composition. The primary organic aerosols have different contribution percentage during summer, depending on their main origin. The influence of Bucharest, during summer, included cooking contribution of 13%. The periods with more regional influence were characterized by lower contribution from traffic and biomass burning in a total proportion of 28%. In winter, the influence of local non-traffic sources was dominant. For more than 99% of the measurements, the biomass burning indicator, f 60 , exceeded the background value, with residential heating being an important source in this area. Fossil fuel contribution was confirmed for one week during the winter campaign, when 14 C analysis of total and elemental carbon revealed the presence of 17% fossil contributions to total carbon. Mass spectrometry, 14 C and absorption data suggest biomass burning as the predominant primary source of organic aerosols for the winter season.