Majid Gholipour

Mr. Majid Gholipour


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
Majid GholipourMajid Gholipour
Majid Gholipour
Samad NarimaniSamad Narimani
Samad Narimani
Seyed Morteza DavarpanahSeyed Morteza Davarpanah
Seyed Morteza Davarpanah
Balazs VasarhelyiBalazs Vasarhelyi
Balazs Vasarhelyi
Tunneling in loose soil and urban areas presents numerous challenges. One effective solution is the use of Earth Pressure Balance Shields (EPBSs). Maintaining the correct balance of pressure at the tunnel face is critical, as applying too little pressure can cause a collapse, while excessive pressure may result in a blow-out. Therefore, a key aspect of using EPBSs in urban environments is determining the optimal pressure required to stabilize the tunnel face, taking into account the existing soil in the excavation chamber and controlling the screw conveyor’s rotation rate. This study focuses on a section of the second line of the Tabriz subway to evaluate the minimum pressure needed for tunnel face stability using empirical, analytical, and numerical approaches. The analytical methods involve evaluating the limit equilibrium of forces and considering soil buckling due to overburden, while the numerical methods employ 3D finite element analysis. Additionally, a sensitivity analysis of the parameters affecting the required pressure was conducted and compared across the three approaches. The results revealed that the formation of a pressure arch mitigates the full impact of overburden pressure on the tunnel face. For soil cohesion values below 20 kPa, the numerical results aligned well with the empirical and analytical findings. For a tunnel depth of 22.5 m and a water table 2 m below the surface, the estimated minimum pressure ranged from 150 to 180 kPa. Moreover, the analytical methods were deemed more suitable for determining the required support pressure at the tunnel face. These methods considered wedge and semi-circular mechanisms as the most probable failure modes. Also, for cohesive ground, the pressure from the finite element analysis was found to be almost always equal to or greater than the values obtained with the analytical solutions.