Plant height is a morphological characteristic of plant growth that is a useful indicator of plant stress resulting from water and nutrient deficit. While height is a relatively simple trait, it can be difficult to measure accurately, especially in crops with complex canopy architectures like cotton. This paper describes the deployment of four nadir view ultrasonic transducers (UTs), two light detection and ranging (LiDAR) systems, and an unmanned aerial system (UAS) with a digital color camera to characterize plant height in an upland cotton breeding trial. The comparison of the UTs with manual measurements demonstrated that the Honeywell and Pepperl+Fuchs sensors provided more precise estimates of plant height than the MaxSonar and db3 Pulsar sensors. Performance of the multi-angle view LiDAR and UAS technologies demonstrated that the UAS derived 3-D point clouds had stronger correlations (0.980) with the UTs than the proximal LiDAR sensors. As manual measurements require increased time and labor in large breeding trials and are prone to human error reducing repeatability, UT and UAS technologies are an efficient and effective means of characterizing cotton plant height.

Photosynthetica covers wide range of photosynthesis research or research including photosynthetic parameters of both experimental and theoretical nature.

Remote-sensing using normalized difference vegetation index (NDVI) has the potential of rapidly detecting the effect of water stress on field crops. However, this detection has typically been accomplished only after the stress effect led to significant changes in crop green biomass, leaf area index, angle and position, and few studies have attempted to estimate the uncertainties of the regression models. These have limited the informed interpretation of NDVI data in agricultural applications. We built a ground-based sensing cart and used it to calibrate the relationships between NDVI and leaf water potential (LWP) for wheat, corn, and cotton growing under field conditions. Both the methods of ordinary least-squares (OLS) and weighted least-squares (WLS) were employed in data analysis, and measurement errors in both LWP and NDVI were considered. We also used statistical resampling to test the effect of measurement errors of LWP on the uncertainties of model coefficients. Our data showed that obtaining a high value of the coefficient of determination did not guarantee a high prediction precision in the obtained regression models. Large prediction uncertainties were estimated for all three crops, and the regressions obtained were not always significant. The best models were obtained for cotton with a prediction uncertainty of 27%. We found that considering measurement errors for both LWP and NDVI led to reduced uncertainties in model coefficients. Also, reducing the sample size of LWP measurement led to significantly increased uncertainties in the coefficients of the linear models describing the LWP-NDVI relationship. Finally, potential strategies for reducing the uncertainty relative to the range of NDVI measurement are discussed.

Field-based high-throughput plant phenotyping (FB-HTPP) has been a primary focus for crop improvement to meet the demands of a growing population in a changing environment. Over the years, breeders, geneticists, physiologists, and agronomists have been able to improve the understanding between complex dynamic traits and plant response to changing environmental conditions using FB-HTPP. However, the volume, velocity, and variety of data captured by FB-HTPP can be problematic, requiring large data stores, databases, and computationally intensive data processing pipelines. To be fully effective, FB-HTTP data workflows including applications for database implementation, data processing, and data interpretation must be developed and optimized. At the US Arid Land Agricultural Center in Maricopa Arizona, USA a data workflow was developed for a terrestrial FB-HTPP platform that utilized a custom Python application and a PostgreSQL database. The workflow developed for the HTPP platform enables users to capture and organize data and verify data quality before statistical analysis. The data from this platform and workflow were used to identify plant lodging and heat tolerance, enhancing genetic gain by improving selection accuracy in an upland cotton breeding program. An advantage of this platform and workflow was the increased amount of data collected throughout the season, while a main limitation was the start-up cost.

The development of management plans which lead to water efficient landscapes is a growing need in the turfgrass community. While deficit irrigation as a scheduling method can improve water conservation, more information is desired on how to best leverage other management practices, such as mowing height when deficit irrigation is imposed. The objectives of this study were to characterize actual evapotranspiration (ET_a), turfgrass visual quality, clipping production, and root development of ‘TifTuf’ bermudagrass (Cynodon dactylon × C. transvaalensis Burt Davy) when irrigated at full (1.0 × ET_a) and deficit levels (0.65 and 0.30 × ET_a), and cut at four separate mowing heights (2.5, 5.0, 7.5, and 10.0 cm) over two 8-week experimental runs. An elevated ET_a was observed at the 7.5 cm and 10.0 cm mowing heights compared to the 2.5 cm mowing height in both runs, and the 5.0 cm mowing height in one run. The visual quality decreased throughout both study periods and mostly for the deficit irrigation treatments, with visual quality falling below minimum acceptable levels at the lowest irrigation level (0.30 × ET_a) 5 weeks into run A, and 8 weeks into run B. Despite an elevated ET_a and a higher root dry weight at higher mowing heights (7.5 and 10.0 cm), clipping production and visual quality was generally higher at lower mowing heights (2.5 and 5.0 cm) for both full and deficit irrigation levels. These results demonstrate that mowing height can significantly influence bermudagrass water use, as well as responses to deficit irrigation. When maintaining ‘TifTuf’ bermudagrass at heights above 2.5 cm, the results from this study indicate a lower water use and improved response to deficit irrigation at mowing heights ≤ 5 cm.

Efficient and affordable plant phenotyping methods are an essential response to global climatic pressures. This study demonstrates the continued potential of consumer-grade photography to capture plant phenotypic traits in turfgrass and derive new calculations. Yet the effects of image corrections on individual calculations are often unreported. Turfgrass lysimeters were photographed over 8 weeks using a custom lightbox and consumer-grade camera. Subsequent imagery was analyzed for area of cover, color metrics, and sensitivity to image corrections. Findings were compared to active spectral reflectance data and previously reported measurements of visual quality, productivity, and water use. Results confirm that Red–Green–Blue imagery effectively measures plant treatment effects. Notable correlations were observed for corrected imagery, including between yellow fractional area with human visual quality ratings (r = −0.89), dark green color index with clipping productivity (r = 0.61), and an index combination term with water use (r = −0.60). The calculation of green fractional area correlated with Normalized Difference Vegetation Index (r = 0.91), and its RED reflectance spectra (r = −0.87). A new chromatic ratio correlated with Normalized Difference Red-Edge index (r = 0.90) and its Red-Edge reflectance spectra (r = −0.74), while a new calculation correlated strongest to Near-Infrared (r = 0.90). Additionally, the combined index term significantly differentiated between the treatment effects of date, mowing height, deficit irrigation, and their interactions (p < 0.001). Sensitivity and statistical analyses of typical image file formats and corrections that included JPEG, TIFF, geometric lens distortion correction, and color correction were conducted. Findings highlight the need for more standardization in image corrections and to determine the biological relevance of the new image data calculations.