Meghdad Bagheri

Dr. Meghdad Bagheri

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2020 in Canadian Geotechnical Journal
Verified
Journal Article
Closed access
MRMohammad Rezania
Mohammad Rezania
MBMeghdad Bagheri
Meghdad Bagheri
MNMohaddeseh Mousavi Nezhad
Mohaddeseh Mousavi Nezhad
In this paper, the one-dimensional (1D) time-dependent behaviour of natural and reconstituted London Clay samples under saturated and unsaturated conditions is studied. For this purpose, a set of 1D consolidation tests including multi-staged loading (MSL) oedometer tests and single-staged loading (SSL) long-term oedometer creep tests were carried out on saturated and unsaturated specimens. Conventional oedometer cells were used for tests on saturated specimens, whereas a newly designed unsaturated oedometer cell, equipped with two high-capacity tensiometers (HCTs) for suction measurements, was used for unsaturated tests. The tests results revealed stress dependency and suction dependency of primary and secondary consolidation responses of the soil samples. Furthermore, counter to formerly acknowledged suggestions of independency of the slope of normal consolidation line to suction changes, it was observed that an increase in suction results in a decrease of the slope of compression curve (Cc) and the creep index (Cαe) values and an increase in yield vertical net stress (σp). Moreover, the Cαe/Cc ratio for London Clay was found to be stress- and suction-dependent, unlike the previously suggested hypotheses.

1 December 2019 in International Journal of Geomechanics
Verified
Journal Article
Closed access
MBMeghdad Bagheri
Meghdad Bagheri
MRMohammad Rezania
Mohammad Rezania
MNMohaddeseh Mousavi Nezhad
Mohaddeseh Mousavi Nezhad
This paper presents the experimental program conducted for evaluation of the rate-dependent and stress-relaxation behavior of unsaturated reconstituted London clay. A series of drained constant rate of strain (CRS) compression-relaxation tests with single-staged (SS-CRS) and multistaged (MS-CRS) loading modes was performed in an innovative CRS oedometer cell where soil suction evolutions were monitored using two high-capacity tensiometers (HCTs). Specimens were tested at two strain rates of 4.8×10−7 and 2.4×10−6  s−1 and over a suction range of 0–1,905 kPa. The coupled and independent effects of strain rate and soil suction on one-dimensional stress–strain and stress-relaxation responses, including the effects of prerelaxation strain, stress, and strain rate under both saturated and unsaturated conditions, were evaluated. An increase in suction and strain rate resulted in an increase of the yield vertical net stress (σp ). Furthermore, it was observed that the rate and magnitude of the relaxed stresses increased with increases in prerelaxation strain, stress, and strain rate, and decreased with an increase in soil suction. At constant suction, an increase in the prerelaxation strain rate by a factor of five resulted in an increase of the relaxed stresses by a factor of 2.2–3.6. Moreover, the coefficient of relaxation (Rα ) was found to be suction dependent, falling within a range of 0.011–0.019 and 0.017–0.029, respectively, for slow and fast strain rates during MS-CRS tests. Comparing these results with the Cα/Cc ratio obtained from conventional multistage loading (MSL) oedometer test results revealed the validity of Rα=Cα/Cc correlation for unsaturated reconstituted specimens.

1 October 2017 in Geotextiles and Geomembranes
Verified
Journal Article
Open access
MRMohammad Rezania
Mohammad Rezania
MBMeghdad Bagheri
Meghdad Bagheri
Mohaddeseh Mousavi Mousavi NezhadMohaddeseh Mousavi Mousavi Nezhad
Mohaddeseh Mousavi Mousavi Nezhad
NSNallathamby Sivasithamparam
Nallathamby Sivasithamparam
In this paper, an anisotropic creep constitutive model, namely Creep-SCLAY1S is employed 10 to study the installation effects of prefabricated vertical drains (PVDs) on the behavior of a full\ud 11 scale test embankment, namely Haarajoki embankment in Finland. The embankment was 12 constructed on a natural soft soil with PVD installed to improve the drainage under one half of 13 it. The Creep constitutive model used in this study, incorporates the effects of fabric\ud 14 anisotropy, structure and time within a critical state based framework. For comparison, the 15 isotropic modified Cam clay (MCC) model and the rate-independent anisotropic S-CLAY1S 16 model are also used for the analyses. The numerical predictions are compared with field 17 measurements and the results indicate that the creep model provides an improved 18 approximation of field settlements, and excess pore pressure build-up and dissipations. In 19 addition, the application of two commonly used permeability matching techniques for two 20 dimensional (2D) plane-strain analysis of the PVD problem is studied and the results are 21 discussed highlighting their limitations and advantages

21 February 2019 in Geotechnical Testing Journal
Verified
Journal Article
Closed access
MBMeghdad Bagheri
Meghdad Bagheri
MNMohaddeseh Mousavi Nezhad
Mohaddeseh Mousavi Nezhad
MRMohammad Rezania
Mohammad Rezania
Research into the thermo-hydromechanical (THM) behavior of unsaturated soils and the effect of strain rate on their mechanical responses requires the employment of advanced laboratory testing systems and procedures as well as protocols of correcting the measured data in order to account for errors associated with complex test conditions and apparatus calibrations. This article presents the design and calibration of an innovative constant rate of strain oedometer cell for the characterization of the THM behavior of soils under combined non-isothermal and unsaturated conditions. The advanced oedometer cell enables the simultaneous control of temperature, suction, and stress state within the soil specimens. Temperatures of 20°C to 200°C are applied through a tubular heating element placed at the base of the soil specimen. Suction is controlled using the axis-translation technique and measured using both axis-translation and two high-capacity tensiometers accommodated on the periphery of the specimen. The performance of the new cell is assessed based on a set of tests performed on clay specimens, and its merits and advantages are discussed in detail.

1 June 2018 in Geotechnical Research
Verified
Journal Article
Open access
MBMeghdad Bagheri
Meghdad Bagheri
MRMohammad Rezania
Mohammad Rezania
Mohaddeseh Mousavi Mousavi NezhadMohaddeseh Mousavi Mousavi Nezhad
Mohaddeseh Mousavi Mousavi Nezhad
High-capacity tensiometers (HCTs) are sensors made to measure negative pore water pressure (suction) directly. In this paper, a new approach is proposed to expand the range and duration of suction measurements for a newly designed HCT. A new technique is employed to reduce significantly the roughness of the diaphragm’s surface on the water reservoir side in order to minimise the possibility of gas nuclei development and the subsequent early cavitation at the water–diaphragm interface. The procedures employed for the design, fabrication, saturation and calibration of the new tensiometers are explained in detail. Furthermore, the performance of the developed HCTs is examined based on a series of experiments carried out on a number of unsaturated clay specimens. An improvement in maximum sustainable suction in the range of 120–150% of their nominal capacity was obtained from different surface treatment methods. Moreover, the results show an improvement of up to 177% for the long-term stability of measurements, compared to the developed ordinary HCTs with untreated diaphragms.

1 March 2022 in International Journal of Geomechanics
Verified
Journal Article
Closed access
PDF file
MBMeghdad Bagheri
Meghdad Bagheri
MRMohammad Rezania
Mohammad Rezania
This paper investigates the effect of the soil moisture evaporation rate on the soil water retention curve (SWRC) of clays obtained using the high-capacity tensiometer (HCT) technique and following the continuous drying (dynamic) method. SWRC measurements, with and without soil moisture evaporation rate control, were carried out on reconstituted London clay specimens using 12 performance-improved HCTs recently developed at the University of Warwick. Furthermore, the HCTs' performance in terms of the maximum attainable suction (smax) and maximum measurement duration (tmax) was evaluated. Moreover, the suitability of a curve-fitting-based model, available in the literature, for attaining the entire retention curve (beyond the capacity of HCTs) was evaluated. The SWRCs for the tests with a controlled evaporation rate were found to generally exhibit higher suction at a given water content, hence inducing air-entry values that were on average 16% higher than those obtained from tests without evaporation rate control. It was also found that for suction in excess of 2 MPa, the curve-fitting-based model predictions of data obtained from tests with a controlled evaporation rate exhibited significantly lower suction at a given water content than those without evaporation rate control, suggesting that such curve fitting correlations should be used with caution.