The mining industry sector is notable for the severe service loads and varied environmental conditions that it imposes on its equipment and mechanical systems. It has become essential to identify the causes of failures and use the information to avoid similar failures and improve projects. In this paper, a study on shaft failure in a speed reduction box was carried out. A section of a fractured shaft made of hardened austempered steel was analyzed to determine the cause of the break. Fractography was performed to characterize the failure mode on the fracture surface. The microstructural analysis and hardness profile revealed that the shaft was inadequately heat treated, resulting in low resistance microstructures and the development of a thin layer of bainite at the shaft edge. Large amounts of inclusions were found in the fracture region, and the tensile tests revealed that the material had an elongation below the specification. The analyses showed that the combination of factors of a large amount of inclusions present in the low resistance banded structure, and the presence of concentrated pores in that same region, acted in a synergistic way to decrease the fatigue resistance and fatigue life of the shaft material.
In countries with continental dimensions like Brazil, railways transport production from inland regions to ports and the international market. It is essential to note that researchers and engineers in the railway sector are constantly striving to reduce operational and maintenance costs associated with wheel-rail contact while maintaining high standards of quality, safety, and operational predictability. In this context, wheels are one of the most costly components in railway acquisition and maintenance, representing a significant factor in transport safety. Additionally, their manufacturing process can involve either forging or casting. Therefore, the manufacturing process can offer the best cost-benefit ratio to meet the diverse demands of the railway sector — longer wear/fatigue life with lower costs. This study aimed to analyze the effects of the manufacturing process of the cast and forged microalloyed railway wheels, with similar microstructure, hardness, and equivalent carbon content, on the metallurgical defects formation and tribological properties. To support material characterization, optical microscopy, scanning electron microscopy, hardness measurements, ASTM E45 standards for evaluating metallurgical defects, twin-disc wear tests, Raman spectroscopy, and statistical analyses were conducted to compare the defects and cracks developed in railway steels.
This study aims to evaluate the wear and rolling contact fatigue performance of two lives of the same railway wheel: one with a bainitic microstructure and the other with a pearlitic microstructure, both tested against the same commercial premium rail. Tests were conducted using a Twin Disc tribometer. The results demonstrated that bainite exhibits superior wear resistance, with a 34% lower mass loss compared to pearlite under identical conditions. Additionally, the bainitic microstructure showed greater resistance to rolling contact fatigue, as surface cracks were smaller in size compared to those observed in the pearlitic microstructure. The counterbody also performed better when tested against the bainitic specimen.
Rail transport is one of the main freight transportation modes in Brazil, responsible for transporting about 92% of all extracted ore to ports via railways. However, it incurs high maintenance costs, exceeding $1.5 billion annually, with most of this amount allocated to rolling stock maintenance. This study investigates the influence of vanadium (V) microalloying on the wear and rolling contact fatigue (RCF) performance of cast Class D railway wheels. Using a twin-disc tribometer simulating wheel-rail contact, a vanadium-microalloyed wheel (CD-V) was compared against a conventional wheel (CD). Key parameters evaluated included mass loss, plastically deformed layer thickness, and crack characteristics. While the CD-V wheel showed slightly lower mass loss, the difference compared to the CD wheel was not statistically significant. However, the slightly increased hardness of the CD-V wheel seems to led to greater wear on the rail counterbody, indicating a trade-off. In contrast, vanadium addition demonstrated significant benefits for RCF resistance. The CD-V wheel exhibited a thinner plastically deformed subsurface layer and superior crack morphology, characterized by shorter surface cracks, lower-angle and shallower subsurface cracks. These RCF improvements suggest that vanadium microalloying in cast wheels could offer advantages in operations where shelling resistance is a primary concern.