Hydrogen production through solar-driven water splitting is a promising approach and an alternative to the conventional steam reforming of natural gas and coal gasification. The growing energy demand and environmental degradation through carbon-emitting fossil fuels urge a transition in the usage of non-renewable to renewable sources of energy. The photocathodes in a photoelectrochemical (PEC) water-splitting cell are essential for the direct evolution of hydrogen. Among the known photocathodes, Cu-based p-type semiconducting materials are the most promising photo-absorber materials owing to their low-cost, low toxicity, natural abundance, suitable bandgaps, and favorable band edges for reduction. Moreover, the chemical stability and the rate of recombination significantly limit the longevity, the PEC performance, and practical applicability of Cu-based photocathodes. To overcome these problems, it is critical to have a thorough understanding of the constraints, improvement strategies, and an assessment of current developments in order to construct and design highly stable and efficient photocathodes. Here, in this review we have summarized the development of Cu-based metal oxide and sulfide photocathodes with the significant operational challenges and strategies that have successfully been employed to enhance the PEC performance. Furthermore, the emphasis is placed on recent reports and future perspectives regarding emerging challenges.
The development of efficient and novel p-n heterojunctions for photoelectrochemical (PEC) water splitting is still a challenging problem. We have demonstrated the complementary nature of (p-type) BiSbS3 as a sensitizer when coupled with (n-type) TiO2/CdS to improve the photocatalytic activity and solar to hydrogen conversion efficiency. The as-prepared p-n heterojunction TiO2/CdS/BiSbS3 exhibits good visible light harvesting capacity and high charge separation over the binary heterojunction, which are confirmed by photoluminescence (PL) and electrical impedance spectroscopy (EIS). The ternary heterojunction produces higher H2 than the binary systems TiO2/CdS and TiO2/BiSbS3. This ternary heterojunction system displayed the highest photocurrent density of 5 mA·cm−2 at 1.23 V vs. reversible hydrogen electrode (RHE) in neutral conditions, and STH of 3.8% at 0.52 V vs. RHE is observed. The improved photocatalytic response was due to the favorable energy band positions of CdS and BiSbS3. This study highlights the p-n junction made up of TiO2/CdS/BiSbS3, which promises efficient charge formation, separation, and suppression of charge recombination for improved PEC water splitting efficiency. Further, no appreciable loss of activity was observed for the photoanode over 2500 s. Band alignment and interfaces mechanisms have been studied as well.