In the current study, a novel arrangement of acoustic paths with an on-off technique upon ultrasonic waves is proposed to enhance the accuracy and reduce the frequency of calibration of the ultrasonic flowmeter (USFM). In addition, a web of chord probes on the velocity profile with a novel rotating method is also proposed. Twenty velocity profiles, including 19 selected Salami asymmetric velocity profiles and a centrosymmetric developed velocity profile, are combined with the proposed chord-probe mesh to build a novel velocity database. The built database includes 2241 900 sets of 12 mean velocities, ranging from 0.1 m s −1 to 25 m s −1 . Furthermore, the principal component analysis algorithm is employed and trained by the developed database to predict the flow patterns in a practically flowing measurement. The predictive ability of the developed algorithm is examined in 10 different scenarios. In all cases in this study, it is found that the proposed USFM can not only measure the volumetric flow rate of the asymmetric flows with extremely high accuracy, but can also eliminate the influences of flow regimes and the effects of the installed location.
In this study, the heat and mass transfers in the fabric drying process of a single-cylinder dryer are numerically examined in detail by using MATLAB codes and illustrating 3D velocity and temperature profiles obtained by a CFD-ACE+ software package. Seven different drying materials including Polyethylene terephthalate (PET), Polyethylene, Polypropylene, Cotton, Wool, Rayon, and Nylon are employed as drying materials. Influences of the drying-material thickness, contacting percentage, cylinder temperature, feeding velocity, and cylinder diameter are examined in detail. For all cases in this study, it is found that the maximum temperature of the drying material in the drying process is strongly dependent on the thermal diffusivity of the drying material. The higher the thermal diffusivity of the drying material, the greater the peak temperature achieved. The peak temperature of the drying material increases with the increase in the contacting percentage. The higher feeding velocity leads to a faster increase in the temperature of the drying material; however, the peak temperature of the slower feeding velocity is higher than that of the faster one. The heat transfer between the central layer of the drying material and to ambient environment is limited by the thermal diffusivity of the drying material.
1 January 2024 in Journal of Enhanced Heat Transfer
The present study numerically examines the effects of tube diameter (12 to 35 mm), arrangement, pitch-to-diameter ratio (1.25 to 2.5), length (300 to 1500 mm), and passage number (1−4 passes) on the thermofluidic characteristics of cross-flow tube bundles. Especially, five new cam-shaped tubes are proposed in comparison with the conventional round tube. The air temperatures at the cold and hot side inlets are kept constant at 25°C and 600°C, respectively. The numerical method is verified by the existing experimental results. The findings show that a cam-shaped tube with an equal diameter (Cam_1818) is a promising tube for tube bundles, which apply in waste heat recovery. Indeed, it can offer the same minimum gap as that of the round tube; however, it improves the total thermal resistance up to about 28% and enhances the heat-transfer rate up to an average of 42.3% compared to that of the round tubes at the same pumping power.