Photovoltaic (PV) modules suffer from a reduction of electric conversion due to the high operating temperatures of the PV cells. Hybrid photovoltaic/thermal (PV/T) technology represents an effective solution for cooling the PV cells. This paper discusses a theoretical study on a novel bi-fluid PV/T collector. One dimensional steady-state numerical model is developed, and computer simulations are performed using MATLAB. This numerical model is based on a pilot PV/T plant, installed in the Campus of the University of Catania, and was experimentally validated. The design of the proposed bi-fluid PV/T is based on a commercial WISC PV/T collector, to which are added an air channel, an aluminum absorber with fins, and a layer of thermal insulation. The analysis of the thermal behavior of the proposed collector is carried out as a function of the flow rate of the two heat transfer fluids (air and water). Finally, the comparative analysis between the conventional water-based PV/T collector, namely PV/T, and the bi-fluid (water/air-based) WISC PVT, namely PV/Tb, is presented for both winter and summer days. For the investigated winter day, the numerical results show an overall improvement of the performance of the bi-fluid PV/T module, with an increase of thermal energy transferred to the liquid side of 20%, and of 15.3% for the overall energy yield in comparison to the conventional PV/T collector. Instead, a loss of 0.2% of electricity is observed. No performance improvements were observed during the summer day.
24 August 2024 in Case Studies in Thermal Engineering
The objective of the present work is the performance assessments of a bi-fluid photovoltaic/thermal solar collector (PV/T). Based on energy-balance equations, a mathematical model of PV/T hybrid collector has been developed and simulated using Matlab Software. This model takes into account the effect of the three modes of fluid operation under the same PV/T system, namely: the air mode, the water mode, and the simultaneous mode of water and air. The results show that the lowest PV module temperature is observed in the simultaneous mode (air & water) compared to others modes. It's maximum value achieved is around 62°C in the bi-fluid mode against 80°C and 73°C respectively in the air mode and the water mode. The maximum efficiencies of 66.97 % (thermal efficiency) and 10.1% (electrical efficiency) are also observed, when both fluids are operated simultaneously compared to others modes. Finally, the working in simultaneous mode is beneficial to transmit more heat, produce more thermal energy and consequently improve the electrical and thermal performances of the PV/T hybrid collector. Moreover, the theoretical model developed is validated, evidencing a good fit between simulation results and the experimental data available in literature. The PV/T collector designed in this study has a variety of applications, as solar drying in agriculture, air conditioning, space heating and hot water supply for domestic applications.