This paper presents systematic studies of hydrophilic metal oxide nanoparticles (NPs) dispersed in brine intended to reveal their potential to enhance oil recovery (EOR) in various rock wettability systems. The stability in suspension (nanofluid) of the NPs has been identified as a key factor related to their use as an EOR agent. Experimental techniques have been developed for nanofluid stability using three coupled methods: direct visual observation, surface conductivity and particle size measurements. The use of a dispersant has been investigated and has been shown to successfully improve metal oxide nanofluid stability as a function of its concentration. The dispersant alters the nanofluid properties, i.e. surface conductivity, pH and particle size distribution. A two-phase coreflood experiment was conducted by injecting the stable nanofluids as a tertiary process (nano-EOR) through core plugs with various wettabilities ranging from water-wet to oil-wet. The combination of metal oxide nanofluid and dispersant improved the oil recovery to a greater extent than either silica-based nanofluid or dispersant alone in all wettability systems. The contact angle, interfacial tension (IFT) and effluent were also measured. It was observed that metal oxide-based nanofluids altered the quartz plates to become more water-wet, and the results are consistent with those of the coreflood experiment. The particle adsorption during the transport process was identified from effluent analysis. The presence of NPs and dispersant reduced the IFT, but its reduction is sufficient to yield significant additional oil recovery. Hence, wettability alteration plays a dominant role in the oil displacement mechanism using nano-EOR.
1 January 2013 in International Journal of Greenhouse Gas Control
Align with current dynamic technology development, waterflooding techniques have been improved and optimized to have better oil recovery performance. In addition the latest worldwide industries innovation trends are miniaturization and nanotechnology materials such as nanoparticles. Hence one of the ideas is using nanoparticles to assist waterflood performance. However it is crucial to have a clear depiction of some parameters that may influences displacement process. The focus of this study is to investigate the effects of some parameters influencing oil recovery process due to nanoparticles such as particle size, rock permeability, initial rock wettability, injection rate and temperature. This study is part of our ongoing research in developing nanofluids for future or alternative enhanced oil recovery (Nano-EOR) method. Three different sizes of hydrophilic silica nanoparticles with single particle diameter range from 7 to 40 nm were employed and have been characterized under scanning electron microscope (SEM). Nanofluids were synthesized using 0.05 wt.% nanoparticles that dispersed into synthetic brine (NaCl 3 wt.% ~ 30,000 ppm). The contact angle variation due to nanoparticles size was also measured at room condition. Coreflood experiment has been conducted using 26 Berea sandstone cores to evaluate the effect of those parameters above on oil recovery due to Nano-EOR. The cores permeability was in range from 5 to 450 mD. To study the effect of initial rock wettability on oil recovery due to Nano-EOR, original core wettability has been changed with aging process from water-wet to intermediate and oil-wet respectively. Temperature was also studied in range 25-80 °C to fulfill the possibility of applying Nano-EOR at reservoir temperature. The coreflood testing was repeated for each case to have consistency result. The processes and results are outlined and also further detailed in the paper to bring knowledge about nanoparticles flooding as a future promising EOR method.