Institute on Laser and Information Technologies of Russian Academy of Sciences — Branch of Federal Scientific Research Center “Crystallography and Photonics” of Russian Academy of Sciences
Dr. Liubov Parshina
Institute on Laser and Information Technologies of Russian Academy of Sciences — Branch of Federal Scientific Research Center “Crystallography and Photonics” of Russian Academy of Sciences
This paper describes research on the optics of functional materials, which can change their dielectric properties according to their function. Vanadium dioxide is a good example of such a material where the insulator-to-metal phase transition offers the possibility to control dielectric properties and to use them as a triggering element for photonic applications in the wide spectral range from optical to terahertz frequencies. We observed emission of terahertz (THz) radiation from films in insulating and conductive phase states under femtosecond pulse irradiation. We found that the efficiency of THz emission increases up to 30 times after the insulator-to-metal phase transition. This process occurs in thin films while it is fundamentally forbidden in the bulk material, and polarization analysis of the emitted radiation reveals the crucial importance of interface contributions. The properties of the THz radiation emitted by are determined by displacement photocurrents at the –air and –substrate interfaces induced by the incident laser light. In each phase state the contributions of the two boundaries are different. Properties of the effective dielectric susceptibility tensor for the insulating phase were defined. In demonstrating the conversion of optical into THz radiation in films, we found that fundamental symmetry restrictions are not applicable to problems of nonlinear optics of thin films.
SnO2:Sb thin films are grown by pulsed laser deposition with high-speed particle separation on quartz-glass substrates without post-deposition annealing under different deposition conditions in the range of the energy densities on the target from 3.4 to 6.8 J/cm2. Their optical, structural, and electrical properties are studied. It is found that the energy density on the target affects the SnO2:Sb film conductivity and transmittance. The optimum conditions of film growth by the droplet-free pulsed laser deposition method are determined. A resistivity minimum of 1.2 × 10–3 Ω cm is observed at an energy density on the target of 4.6 J/cm2, a substrate temperature of 300°C, and an oxygen pressure of 20 mTorr in the vacuum chamber during deposition.