Zeolites can be obtained in the process of the alkali-activation of aluminosilicate precursors. Such zeolite–geopolymer hybrid bulk materials merge the advantageous properties of both zeolites and geopolymers. In the present study, the effect of the type and concentration of an activator on the structure and properties of alkali-activated metakaolin, and metahalloysite was assessed. These two different kaolinite clays were obtained by the calcination of kaolin and halloysite, and then activated with sodium hydroxide and water glass. The phase compositions were assessed by X-ray diffraction, the microstructure was observed via scanning electron microscope, and the structural studies were conducted on the basis of the infrared spectra. The structure and properties of the obtained alkali-activated materials depend on both the type of a precursor and the type of an activator. The formation of zeolite phases was observed when the activation was carried out with sodium hydroxide alone, or with a small addition of water glass, regardless of the starting material used. The higher proportion of silicon in the activator solution does not give crystalline phases, but only an amorphous phase. Geopolymers based on metahalloysite have better compressive strength as the result of the better reactivity of metahalloysite compared to metakaolin.
19 June 2024 in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
Carbon fiber reinforced polymer composites are a dynamically developing group of lightweight composites for applications in the automotive, wind energy, aerospace, and sports sectors. Interfacial connection is the weakest place in these materials. In this study, an attempt was made to improve adhesion between carbon fiber and epoxy resin. For this purpose, nanoparticles of graphene oxide were added to a polymer matrix. The results of the three-point bend test showed that the strength of samples with added graphene oxide increased. Improvement of adhesion between components, reduction of the pull-out effect and change in the method of crack propagation were observed. An attempt was made to explain this effect using spectroscopic methods, both IR and Raman. On the basis of the obtained results, chemical bonds between the individual components of the composites were identified.
Boroaluminosilicate geopolymers were used for the immobilization of heavy metals. Then, their mechanical properties, phase composition, structure, and microstructure were investigated. The addition of borax and boric acid did not induce the formation of any crystalline phases. Boron was incorporated into the geopolymeric network and caused the formation of N–B–A–S–H (hydrated sodium boroaluminosilicate) gel. In the range of a B/Al molar ratio of 0.015–0.075, the compressive strength slightly increased (from 16.1 to 18.7 MPa), while at a ratio of 0.150, the compressive strength decreased (to 12 MPa). Heavy metals (lead and nickel) were added as nitrate salts. The loss of the strength of the geopolymers induced by heavy metals was limited by the presence of boron. However, it caused an increase in heavy metal leaching. Despite this, heavy metals were almost entirely immobilized (with immobilization rates of >99.8% in the case of lead and >99.99% in the case of nickel). The lower immobilization rate of lead was due to the formation of macroscopic crystalline inclusions of PbO·xH2O, which was vulnerable to leaching.