A tremendous amount of fossil fuel is utilized to meet the rising trend in the world’s energy demand, leading to the rising level of CO2 in the atmosphere and ultimately contributing to the greenhouse effect. Numerous CO2 mitigation strategies have been used to reverse this upward trend since large-scale decarbonization is still impractical. For multiple reasons, one of the optimal and available solutions is the usage of old depleted oil and gas reservoirs as objects for prospective CO2 utilization. The methods used in CO2 underground storage are similar to those used in oil exploration and production. However, the process of CO2 storage requires detailed studies conducted experimentally and numerically. The main goal of this paper is to present an overview of the existing laboratory studies, engineering and modeling practices, and sample case studies related to the CCS in oil and gas reservoirs. The paper covers geological CO2 storage technologies and discusses knowledge gaps and potential problems. We attempt to define the key control parameters and propose best practices in published experimental and numerical studies. Analysis of laboratory experiments shows the applicability of the selected reservoirs focusing on trapping mechanisms specific to oil and gas reservoirs only. The current work reports risk control and existing approaches to numerical modeling of CO2 storage. We also provide updates on completed and ongoing CCS in oil and gas reservoir field projects and pilots worldwide.
17 November 2022 in Journal of Petroleum Science and Engineering
Hydrogen can be generated in situ within reservoirs containing hydrocarbons through chemical reactions. This technology could be a possible solution for low-emission hydrogen production due to of simultaneous CO2 storage. In gas fields, it is possible to carry out the catalytic methane conversion (CMC) if sufficient amounts of steam, catalyst, and heat are ensured in the reservoir. There is no confirmation of the CMC’s feasibility at relatively low temperatures in the presence of core (reservoir rock) material. This study introduces the experimental results of the first part of the research on in situ hydrogen generation in the Promyslovskoye gas field. A set of static experiments in the autoclave reactor were performed to study the possibility of hydrogen generation under reservoir conditions. It was shown that CMC can be realized in the presence of core and ex situ prepared Ni-based catalyst, under high pressure up to 207 atm, but at temperatures not lower than 450 °C. It can be concluded that the crushed core model improves the catalytic effect but releases carbon dioxide and light hydrocarbons, which interfere with the hydrogen generation. The maximum methane conversion rate to hydrogen achieved at 450 °C is 5.8%.
The current study was performed for the experimental modeling of cyclic steam-air injection in a heavy oil reservoir model of dual porosity in the presence of a nickel-based catalyst for in situ oil upgrading enhanced by simultaneous hydrogen generation. The research was realized in the combustion tube setup with a sandpack core model under reservoir conditions due to the consistent injection of air followed by oil in situ combustion (ISC) and steam (water) injection. As a result, the original oil was upgraded regarding fractional composition and oil properties. In addition, simulated reservoir heterogeneity and cyclic stimulation intensified the hydrogen synthesis, which, in turn, could also contribute to oil upgrading.