Renston Jake Fernandes

Dr. Renston Jake Fernandes

Clean Energy Research Platform, King Abdullah University of Science and Technology, Jeddah, Makkah al Mukarramah, Saudi Arabia
orcid
Doctoral Research Candidate | Engineer | Proficient in Proce...

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 February 2025 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
DNDucduy Nguyen
Ducduy Nguyen
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
JTJames W.G. Turner
James W.G. Turner
DEDavid Robert Emberson
David Robert Emberson

9 April 2024 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
DNDucduy Nguyen
Ducduy Nguyen
MSMohammad Raghib Shakeel
Mohammad Raghib Shakeel
JTJames W.G. Turner
James W.G. Turner
Amid escalating concerns over climate change and emissions, this study presents a novel approach to develop sustainable fuels, leveraging advanced process modeling that uses waste CO2 streams from the biological ethanol fermentation process to produce e-methanol. Using Aspen Plus software, this research focuses on the conversion of biomass such as sugar cane and sugar beet to reduce reliance on fossil fuels and fortify energy resilience in a sustainable manner. In the first phase, bagasse, a byproduct of sugar production that is rich in carbon is used as a precursor for gasification and as a fuel to generate high-pressure steam. Oxygen obtained from electrolysis of water using renewable energy is used to preheat the biological exothermic fermentation phase. The CO2 captured during the fermentation phase is mixed with hydrogen obtained from the electrolysis process to synthesize e-methanol. Lignin, a byproduct of second-generation bioethanol, and surplus bagasse are identified and converted into ethanol and e-methanol, respectively, optimizing the use of CO2 from fermentation and O2 from electrolysis. Lastly, gasification of the carbon-rich bagasse serves to further enhance methanol production, culminating in the generation of enriched e-methanol. This results in enhanced bioenergy, bio-carbon recovery and consequently reduced fossil CO2 emissions, offering a holistic CO2 and biomass management solution. This research introduces a groundbreaking approach to sustainable fuel production, significantly advancing over traditional methods by implementing a closed carbon cycle that fully utilizes every carbon atom from biomass feedstock. This contrasts sharply with conventional practices where carbon dioxide is often released as a byproduct, aggravating greenhouse gas emissions. A key innovation is the waste-to-value conversion, where byproducts like bagasse and lignin are transformed into valuable fuel sources, adding a new dimension of resource optimization absent in traditional fuel production. The environmental impact is profound, with a potential substantial reduction in greenhouse gas emissions, particularly in the transport sector, positioning this method as a sustainable alternative aligned with global environmental goals. Economically, it promises enhanced viability through improved resource utilization and efficiency, presenting a holistic solution that addresses both energy needs and environmental concerns, a significant leap forward from the limitations of traditional fossil fuel-based methods.

17 July 2025 in Procedia CIRP
Verified
Journal Article
Open access
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
DNDucduy Nguyen
Ducduy Nguyen
MSMohammad Raghib Shakeel
Mohammad Raghib Shakeel
JTJames W.G. Turner
James W.G. Turner
The environmental and health impact of sustainable e-methanol production from biomass feedstock varies significantly due to the differences in agricultural practices, land usage, infrastructure, and local regulations. A thorough assessment of health and environmental impacts of e-methanol production requires using the Global Guidance for Life Cycle Impact Assessment Indicators and Methods (GLAM) to create a framework for Life Cycle Impact Assessment (LCIA). This study’s novelty lies in its comprehensive regional analysis, integrating local information on biomass availability, agricultural practices, and emissions. The LCIA model will be calculated with GLAM’s characterization factors for impact categories such as Global Warming Potential in CO 2 -equivalents and Human Health impacts in Disability-Adjusted Life Years (DALYs). Analysis reveals regional disparities: intensive agricultural regions may show higher Global Warming Potential and Finite Particulate Matter Formation, while urban centers with e-methanol production facilities may demonstrate elevated DALY rates due to degraded air quality. This approach provides policymakers with a robust platform for regionally appropriate-strategies aligned with global sustainability goals in renewable fuel production.

28 August 2023 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
DNDucduy Nguyen
Ducduy Nguyen
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
JTJames W.G. Turner
James W.G. Turner
Hydrogen-fueled homogeneous charge compression ignition (HCCI) engines have shown the ability to provide a cleaner and more efficient alternative to conventional fossil fuels. The use of hydrogen as a fuel has the potential to reduce greenhouse gas and promote sustainability. In this study, a modified single-cylinder Cooperative Fuel Research (CFR) engine was utilised to operate on hydrogen in a HCCI combustion mode under various compression ratio (CR) conditions. In the experiments, the amount of hydrogen injected was adjusted at each CR to maintain the crank angle at 50% mass fraction burned (CA50) combustion phasing at 3±1 crank angle degrees after top dead center or as lean as possible. The engine speed was fixed at 600 rpm, and the impact of different intake air temperatures was also investigated. The results indicated that as the compression ratio increases, the air-fuel ratio needs to be increased to maintain the desired CA50 value, i.e., the engine needs to operate leaner. The net indicated mean effective pressure of the engine reached a value of 2.9 bar at a compression ratio of 14 and an intake air temperature of 150OC. The effects of CR and intake temperature on engine performance metrics, such as power output and the rate of heat release, were also investigated. The experimental data showed that the intake air temperature did not have a significant effect on engine performance and power output. At a compression ratio of 16:1 and 600 rpm, the engine's indicated thermal efficiency was found to be approximately 33% across the range of intake temperatures investigated. Furthermore, the fact that the engine effectively produced zero NOx emissions under the various CR conditions tested further highlights the potential for hydrogen HCCI engines to be adopted as a cleaner and more efficient alternative to internal combustion engines using conventional fuels, provided the available range of operation is acceptable and can be made large enough for practical applications.

5 October 2025 in Energy
Verified
Journal Article
Closed access
SGSreenivasa Rao Gubba
Sreenivasa Rao Gubba
RKRaghu Vamsi Kodaboina
Raghu Vamsi Kodaboina
KKKesty Y. Kenkoh
Kesty Y. Kenkoh
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
JTJames W.G. Turner
James W.G. Turner

16 June 2025 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
Renston Jake FernandesRenston Jake Fernandes
Renston Jake Fernandes
MSMohammad Raghib Shakeel
Mohammad Raghib Shakeel
DNDucduy Nguyen
Ducduy Nguyen
HIHong G. Im
Hong G. Im
JTJames W.G. Turner
James W.G. Turner
This study presents a comprehensive techno-economic assessment (TEA) of an integrated e-methanol production system building upon previously published foundational research utilizing Aspen Plus modeling for e-methanol production from sugar cane and sugar beet biomass. The established integrated system converts biomass into ethanol through fermentation and synthesizes e-methanol using both captured CO2 and syngas derived from biomass residue gasification. This approach maximizes CO2 and biomass utilization, promoting a circular carbon economy. The TEA quantifies capital expenditures (CAPEX), operational expenditures (OPEX), and levelized costs of Methanol (LCOM), providing a detailed economic analysis of the potential for commercializing e-methanol. A sensitivity analysis evaluates the impact of feedstock prices and Technology Readiness Levels (TRL), identifying key leverage points affecting financial viability. The study aims to explore the potential of utilizing existing agricultural infrastructure for sugar cane and sugar beet to minimize setup costs and expedite market readiness. The system’s capacity to reduce carbon emissions significantly aligns with global sustainability goals. This study provides strategic recommendations for scaling e-methanol production and improving its economic viability in the renewable energy sector. The sensitivity analysis particularly aids in developing robust strategies to mitigate risks associated with economic and market fluctuations.