In this work, crop leaf nitrogen concentration (LNC) is predicted by leaf impedance measurements made by electrical impedance spectroscopy (EIS). This method uses portable equipment and is noninvasive, as are other available nondestructive methods, such as hyperspectral imaging, near-infrared spectroscopy, and soil-plant analyses development (SPAD). An EVAL-AD5933EBZ evaluation board is used to measure the impedances of four different crop leaves, i.e., canola, wheat, soybeans, and corn, in the frequency range of 5 to 15 kHz. Multiple linear regression using the least square method is employed to obtain a correlation between leaf nitrogen concentrations and leaf impedances. A strong correlation is found between nitrogen concentrations and measured impedances for multiple features using EIS. The results are obtained by PrimaXL Data Analysis ToolPak and validated by analysis of variance (ANOVA) tests. Optimized regression models are determined by selecting features using the backward elimination method. After a comparative analysis among the four different crops, the best multiple regression results are found for canola with an overall correlation coefficient (R) of 0.99, a coefficient of determination (R²) of 0.98, and root mean square (RMSE) of 0.54% in the frequency range of 8.7–12 kHz. The performance of EIS is also compared with an available SPAD reading which is moderately correlated with LNC. A high correlation coefficient of 0.94, a coefficient of determination of 0.89, and RMSE of 1.12% are obtained using EIS, whereas a maximum correlation coefficient of 0.72, a coefficient of determination of 0.53, and RMSE of 1.52% are obtained using SPAD for the same number of combined observations. The proposed multiple linear regression models based on EIS measurements sensitive to LNC can be used on a very local scale to develop a simple, rapid, inexpensive, and effective instrument for determining the leaf nitrogen concentrations in crops.

Crop water stress is a deficiency in plants in water supply when the transpiration rate becomes higher than the water absorption capacity. The stress may be detected by a reduction in soil water content, or by the change in physiological properties of the crop. The leaf water content (LWC) is commonly used to assess the water status of plants, which is one of the indicators of crop water stress. In this work, the leaf relative water contents of four different crops: canola, wheat, soybeans, and corn—all in vegetative growth stage—were determined by a noninvasive tool called, electrical impedance spectroscopy (EIS). Using a frequency range of 5–15 kHz, a strong correlation between leaf water contents and leaf impedances was obtained using multiple linear regression. The trained dataset was validated by analysis of variance tests. Regression results were obtained using the least square method. The optimized regression model coefficients for different crops were proposed by selecting features using the wrapper backward elimination method. Multi-collinearity among the features was considered and individual T-tests were made in the feature selection. A maximum correlation coefficient (R) of 0.99 was obtained for canola compared to the other crops; the corresponding coefficient of determination (R²) of 0.98, an adjusted R² of 0.93, and root mean square error (rmse) of 0.30% were obtained for 36 features. Therefore, the results show that the proposed technique using EIS can be used to develop a low-cost and effective tool for determining the leaf water contents rapidly and efficiently in multiple crops.

Algae are a significant component of a biological monitoring program in an aquatic ecosystem. They are ideally suited for water quality assessments because of their nutrient requirements, rapid reproduction rate, and very short life cycle. Algae composition and temporal variation in abundances are important in determining the trophic level of lakes, and those can be estimated by the Chlorophyll-a (Chl-a) concentration of the species. In this work, a non-destructive method was employed to estimate the Chlorophyll-a concentration of multiple algae species using electrical impedance spectroscopy (EIS). The proposed EIS method is rapid, cheaper, and suitable for in situ measurements compared with the other available non-destructive methods, such as spectrophotometry and hyperspectral or multispectral imaging. The electrical impedances in different frequencies ranging from 1 to 100 kHz were observed using an impedance converter system. Significant observations were identified within 3.5 kHz for multiple algae species and therefore reported in the results. A positive correlation was found between the Chlorophyll-a and the measured impedance of algae species at different frequencies. Later, EIS models were developed for the species in 1–3.5 kHz. A correlation of 90% was found by employing a least squares method and multiple linear regression. The corresponding coefficients of determination were obtained as 0.9, 0.885, and 0.915, respectively for 49 samples of Spirulina, 41 samples of Chlorella, and 26 samples of mixed algae species. The models were later validated using a new and separate set of samples of algae species.

Plant phenotyping plays an important role for the thorough assessment of plant traits such as growth, development, and physiological processes with the target of achieving higher crop yields by the proper crop management. The assessment can be done by utilizing two- and three-dimensional image reconstructions of the inhomogeneities. The quality of the reconstructed image is required to maintain a high accuracy and a good resolution, and it is desirable to reconstruct the images with the lowest possible noise. In this work, an electrical impedance tomography (EIT) data acquisition system is developed for the reconstruction and evaluation of the inhomogeneities by utilizing a non-destructive method. A high-precision EIT system is developed by designing an electrode array sensor using a cylindrical domain for the measurements in different planes. Different edible plant slices along with multiple plant roots are taken in the EIT domain to assess and calibrate the system, and their reconstructed results are evaluated by utilizing an impedance imaging technique. A non-invasive imaging is carried out in multiple frequencies by utilizing a difference method of reconstruction. The performance and accuracy of the EIT system are evaluated by measuring impedances between 1 and 100 kHz using a low-cost and rapid electrical impedance spectroscopy (EIS) tool connected to the sensor. A finite element method (FEM) modeling is utilized for image reconstruction, which is carried out using electrical impedance and diffuse optical tomography reconstruction software (EIDORS). The reconstruction is made successfully with the optimized results obtained using Gauss–Newton (GN) algorithms.

Root biomass is one of the most relevant root parameters for studies of plant response to environmental change. In this work, a dynamic and adjustable electrode array sensor system is designed for developing a cost-effective, high-speed data acquisition system based on electrical impedance tomography (EIT). The developed EIT system is found to be suitable for in situ measurements and capable of monitoring the changes in root growth and development with three-dimensional imaging by measuring impedances in multiple frequencies with the help of an EIT sensor. The designed EIT sensor system is assessed and calibrated by the inhomogeneities in both water and soil media. The impedances are measured for multiple tap roots using an electrical impedance spectroscopy (EIS) tool connected to the sensor at frequencies ranging from 1 kHz to 100 kHz. The changes in conductivity are calculated by obtaining the boundary voltages from the measured impedances for a given stimulation current. A non-invasive imaging method is utilized, and the spectral changes are observed accordingly to evaluate the growth of the roots. A further root analysis helps us estimate the root biomass non-destructively in real-time. The root size (such as, weight, length) is correlated with the measured impedances. A regression analysis is performed using the least square method, and more than 97% correlation is found for the biomass estimation of carrot roots with an RMSE of 4.516. The obtained models are later validated using a new and separate set of carrot root samples and the accuracy of the predicted models is found to be 93% or above. A complete electrode model is utilized, and the reconstruction analysis is performed and optimized by utilizing the impedance imaging technique in difference method. The tomography of the root is reconstructed with finite element method (FEM) modeling considering one-step Gauss–Newton (GN) algorithm which is carried out using an open source software known as electrical impedance and diffuse optical tomography reconstruction software (EIDORS).