Rubens Nunes de Junior

Prof. Rubens Nunes de Junior

Nuclear and Energy Research Institute, Sao Paulo, 05508-000, Brazil
orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 June 2021 in Magnetochemistry
Verified
Journal Article
Open access
PDF file
Elio PerigoElio Perigo
Elio Perigo
RJRubens Nunes de Junior
Rubens Nunes de Junior
The implementation of artificial intelligence into the research and development of (currently) the most economically relevant classes of engineering hard and soft magnetic materials is addressed. Machine learning is nowadays the key approach utilized in the discovery of new compounds, physical–chemical properties prediction, microstructural/magnetic characterization, and applicability of permanent magnets and crystalline/amorphous soft magnetic alloys. Future opportunities are envisioned on at least two fronts: (a) ultra-low losses materials, as well as processes that enable their manufacturing, unlocking the next step for higher efficiency electrification, power conversion, and distribution; (b) additively manufactured magnetic materials by predicting and developing novel powdered materials properties, generative design concepts, and optimal processing conditions.

1 March 2008 in Materials Research
Verified
Journal Article
Open access
PDF file
LZLia Maria Carlotti Zarpelon
Lia Maria Carlotti Zarpelon
EGEguiberto Galego
Eguiberto Galego
HTHidetoshi Takiishi
Hidetoshi Takiishi
RJRubens Nunes de Junior
Rubens Nunes de Junior

11 September 2015 in Batteries
Verified
Journal Article
Open access
PDF file
JCJulio Cesar Serafim Casini
Julio Cesar Serafim Casini
Zaiping GuoZaiping Guo
Zaiping Guo
HLHua Liu
Hua Liu
RJRubens Nunes de Junior
Rubens Nunes de Junior
HTHidetoshi Takiishi
Hidetoshi Takiishi
The effects of substitution of Cu for Sn on the electrochemical discharge capacity performance of La0.7Mg0.3Al0.3Mn0.4Sn0.5−xCuxNi3.8 (x = 0.0, 0.1, 0.2, 0.3, and 0.5) negative electrode alloys were investigated. Results indicate that increasing Cu content enhanced electrochemical behavior by increasing the maximum discharge capacity from 239.8 mA·h/g (x = 0) to 305.2 mA·h/g (x = 0.5), the discharge capacity retention at the 100th cycle from 78.0% (x = 0) to 81.8% (x = 0.5), and the high rate dischargeability (HRD) from 25.7% (x = 0) to 80.6% (x = 0.5).

4 December 2025 in Journal of Power Sources
Verified
Journal Article
Closed access
FJFernando Gabriel Benitez Jara
Fernando Gabriel Benitez Jara
JLJorge David Barrios Lémus
Jorge David Barrios Lémus
JEJan Peter Embs
Jan Peter Embs
Heloisa BordalloHeloisa Bordallo
Heloisa Bordallo
RJRubens Nunes de Junior
Rubens Nunes de Junior

31 December 2014 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
LZLia Maria Carlotti Zarpelon
Lia Maria Carlotti Zarpelon
RJRubens Nunes de Junior
Rubens Nunes de Junior
The effect of the substitution of La with Pr on the microstructure and some electrochemical properties of La0.7-xPrxMg0.3Al0.3Mn0.4Co0.5Ni3.8 (x=0.0, 0.1, 0.3, 0.5, and 0.7) ingot alloys as powder electrode was studied in this paper. XDR and SEM (+EDX) analyses revealed that the as-cast alloys consist mainly of similar LaNi5 and (La,Pr)Mg2Ni9 phases. With the increase in Pr content, both the relative abundance of the phases and microstructure changed. The electrochemical studies showed that the maximum discharge capacity decreased with the increase in Pr content. For the alloy without Pr, the self-discharge studies revealed a major stability of the hydride until the first 984 hours (41 days) of the charge/discharge cycles. The high-rate dischargeability of this alloy electrode showed the best result HRD=88% at a discharge current density of Id=250 mA/g.

17 October 2023 in Physica Scripta
Verified
Journal Article
Closed access
AFAntonio Paulo Rodrigues Fernandez
Antonio Paulo Rodrigues Fernandez
EPElio Alberto Perigo
Elio Alberto Perigo
RJRubens Nunes de Junior
Rubens Nunes de Junior
Expressions to simulate the intrinsic demagnetizing curve of permanent magnets are derived from the classical electrical analogy of a 2RLC circuit as an equivalent to a magnet under demagnetization in a closed magnetic circuit. Comparisons between experimental and theoretical intrinsic M x H curves were carried out for hard magnetic materials, and the possibility of using this analogous circuit with two components has also been investigated. The demagnetization curves of permanent sintered magnets have been simulated with time domain analytical expressions obtained using an electric equivalent circuit analogous to a closed magnetic circuit. This has been carried out for magnets measured at room temperature and at 373 K. Equivalent electric parameters influenced the various regions of the demagnetization curve. It has also been shown that it was possible to simulate the demagnetization curve of rare earth magnets and also other types of permanent magnets. The Stoner-Wohlfarth model theoretical curves have also been used as a comparison. At last, the electrical analogous parameters have been systematically varied in order to correlate them to the magnetic properties.