Plasma-assisted dry reforming of methane (DRM) is considered as a potential way to convert natural gas into fuels and chemicals under near ambient temperature and pressure; particularly for distributed processes based on renewable energy. Both catalytic and photocatalytic technologies have been applied for DRM to investigate the CH4 conversion and the energy efficiency of the process. For conventional catalysis; metaldoped Ni-based catalysts are proposed as a leading vector for further development. However; coke deposition leads to fast deactivation of catalysts which limits the catalyst lifetime. Photocatalysis in combination with non-thermal plasma (NTP), on the other hand; is an enabling technology to convert CH4 to more reactive intermediates. Placing the catalyst directly in the plasma zone or using post-plasma photocatalysis could generate a synergistic effect to increase the formation of the desired products. In this review; the recent progress in the area of NTP-(photo)catalysis applications for DRM has been described; with an in-depth discussion of novel plasma reactor types and operational conditions including employment of ferroelectric materials and nanosecond-pulse discharges. Finally, recent developments in the area of optical diagnostic tools for NTP, such as optical emission spectroscopy (OES), in-situ FTIR, and tunable diode laser absorption spectroscopy (TDLAS), are reviewed.
A mathematical model for the gas-liquid slug flow in a capillary is developed. The velocity profiles in the bubble, film, and interbubble liquid are calculated. The calculated results are in good agreement with the experimental data of other researchers. The experimentally found bifurcational behavior of the slip velocity of bubbles relative to the two-phase mixture reported in the literature is described and supported by the theory. The reasons for which the bubble can stop in a small-diameter dead-end capillary are discussed.
The vertically upward Taylor flow in a small square channel (side length 2 mm) is one of the guiding measures within the priority program “Transport Processes at Fluidic Interfaces” (SPP 1506) of the German Research Foundation (DFG). This paper presents the results of coordinated experiments and three-dimensional numerical simulations (with three different academic computer codes) for typical local flow parameters (bubble shape, thickness of the liquid film, and velocity profiles) in different cutting planes (lateral and diagonal) for a specific co-current Taylor flow. For most quantities, the differences between the three simulation results and also between the numerical and experimental results are below a few percent. The experimental and computational results consistently show interesting three-dimensional flow effects in the rear part of the liquid film. There, a local back flow of liquid occurs in the fixed frame of reference which leads to a temporary reversal of the direction of the wall shear stress during the passage of a Taylor bubble. Notably, the axial positions of the region with local backflow and those of the minimum vertical velocity differ in the lateral and the diagonal liquid films. By a thorough analysis of the fully resolved simulation results, this previously unknown phenomenon is explained in detail and, moreover, approximate criteria for its occurrence in practical applications are given. It is the different magnitude of the velocity in the lateral film and in the corner region which leads to azimuthal pressure differences in the lateral and diagonal liquid films and causes a slight deviation of the bubble from the rotational symmetry. This deviation is opposite in the front and rear parts of the bubble and has the mentioned significant effects on the local flow field in the rear part of the liquid film.