Sonalika Agarwal

Dr. Sonalika Agarwal

Graduate School of Advanced Science and Engineering, Hiroshima University, Higashi-Hiroshima, Hiroshima, Japan
orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2019 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
SASonalika Agarwal
Sonalika Agarwal
PRPrabhakar Rai
Prabhakar Rai
ENEric Navarrete
Eric Navarrete
Eduard LlobetEduard Llobet
Eduard Llobet
FGFrank Güell
Frank Güell
KAKamlendra Awasthi
Kamlendra Awasthi

1 November 2021 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
SASonalika Agarwal
Sonalika Agarwal
SKSanjay Kumar
Sanjay Kumar
HAHimanshu Agrawal
Himanshu Agrawal
MMMohamad G. Moinuddin
Mohamad G. Moinuddin
MKManoj Kumar
Manoj Kumar
KAKamlendra Awasthi
Kamlendra Awasthi

24 July 2019 in Applied Physics A
Verified
Journal Article
Closed access
PDF file
SASonalika Agarwal
Sonalika Agarwal
LJLokesh K. Jangir
Lokesh K. Jangir
KRKuldeep S. Rathore
Kuldeep S. Rathore
MKManoj Kumar
Manoj Kumar
KAKamlendra Awasthi
Kamlendra Awasthi

25 May 2011 in Phase Transitions
Verified
Journal Article
Closed access
SASonalika Agarwal
Sonalika Agarwal
DPDinesh Patidar
Dinesh Patidar
NSN.S. Saxena
N.S. Saxena
In this article, ZnS nanoparticles were prepared by wet chemical precipitation method using zinc sulphate (ZnSO4), sodium sulphide (Na2S) and thio-glycerol. These nanoparticles were characterized through X-ray diffraction (XRD) and transmission electron microscope (TEM) measurements. The solution-based processing was used to prepare Poly methyl methacrylate (PMMA) nanocomposites with different weight percents (0, 2, 4, 6 and 8) of ZnS nanoparticles. The obtained ZnS/PMMA nanocomposites were characterized through XRD, scanning electron microscope and TEM measurements. The dynamic mechanical analyzer was used to obtain the storage modulus and glass transition temperature (T g) of the nanocomposites. The apparent activation energy of the glass transition region was also determined using the Vogel–Fulcher–Tammann equation. The results indicated that the thermal stability of ZnS/PMMA nanocomposites was higher than PMMA and 6 wt. % of ZnS nanoparticles in PMMA matrix showed the maximum activation energy, which indicated that this nanocomposite had higher thermal stability than other composites.

9 October 2014 in Applied Nanoscience
Verified
Journal Article
Open access
PDF file
SASonalika Agarwal
Sonalika Agarwal
NSNarendra Sahai Saxena
Narendra Sahai Saxena
VKVipin Kumar
Vipin Kumar
Zinc sulphide/poly(methyl methacrylate) (ZnS/PMMA) nanocomposites with different (0, 2, 4, 6 and 8) wt% of ZnS nanoparticles have been prepared by solution casting method. The obtained ZnS/PMMA nanocomposites have been characterized through X-ray diffraction (XRD) and transmission electron microscopy (TEM) measurements. Transient plane source (TPS) technique was used to determine the effective thermal conductivity of ZnS/PMMA nanocomposites over the temperature range from room (30° C) to 120° C. The results indicated that the effective thermal conductivity shows increasing behavior up to glass transition temperature beyond which, it becomes constant due to the straightening of chains and vacant site scattering of phonons, respectively. It is also observed that effective thermal conductivity of ZnS/PMMA nanocomposites increases with the increase of concentration of ZnS nanoparticles up to 6 wt% and decreases at 8 wt%. This increase and decrease of thermal conductivity of these nanocomposites are explained on the basis of their structure.

24 August 2011 in Journal of Applied Polymer Science
Verified
Journal Article
Closed access
PDF file
SASonalika Agarwal
Sonalika Agarwal
DPDinesh Patidar
Dinesh Patidar
NSN.S. Saxena
N.S. Saxena