Square-lattice bandedge lasers are realized by room-temperature optical pumping of photonic crystal air-bridge slabs of InGaAsP quantum wells emitting at 1.5 μm. Lasing modes corresponding to the second bandedges near the X and M points are identified from their spectral positions and polarization directions. A low threshold incident pump power of less than 1 mW is achieved for the laser operating at the second bandedge near the X and M points, with only 15×15 lattice points. The measured characteristics of the bandedge lasers closely agree with the result of calculations based on the plane-wave-expansion method and the finite-difference time-domain method.
We optimize photonic crystal cavities for enhancing the sensitivity to environmental changes by finite-difference time-domain method. For the heterostructure cavity created by local modulation of the air hole radius, the resonance shifts due to refractive index change of the background material are investigated. The shifts can be enhanced by reducing the photonic crystal slab thickness or introducing air holes in the cavity. The sensitivity of the thinner slab with central air holes is 310nm/RIU (refractive index unit). The heterostructure created in the slotted waveguide of thin PhC slab shows better sensitivity of 512nm/RIU owing to strong confinement of electric field in the low-index region.
Interest in mechanical compliance has been motivated by the development of flexible electronics and mechanosensors. In particular, studies and characterization of structural deformation at the fundamental scale can offer opportunities to improve the device sensitivity and spatiotemporal response; however, the development of precise measurement tools with the appropriate resolution remains a challenge. Here we report a flexible and stretchable photonic crystal nanolaser whose spectral and modal behaviours are sensitive to nanoscale structural alterations. Reversible spectral tuning of ∼26 nm in lasing wavelength, with a sub-nanometre resolution of less than ∼0.6 nm, is demonstrated in response to applied strain ranging from −10 to 12%. Instantaneous visualization of the sign of the strain is also characterized by exploring the structural and corresponding modal symmetry. Furthermore, our high-resolution strain-gauge nanolaser functions as a stable and deterministic strain-based pH sensor in an opto-fluidic system, which may be useful for further analysis of chemical/biological systems.
We investigate light absorption in metal films, silver and aluminum, with different surface roughness. Measurements using an integrating sphere show that the reflectance in silver decreases significantly with increasing surface roughness whereas the reflectance in aluminum is almost constant. The experimental results agree well with numerical simulations in which the surface roughness of metal is described properly. In particular, the simulations demonstrate that the absorption by surface-plasmon-polaritons excited on a rough silver surface causes the surface-dependent reflectance in silver. This study suggests a convenient and feasible rule to rationally design a backside metal reflector toward high-efficiency light-emitting diodes and photovoltaics.
We discuss coupling of site-selectively induced quantum emitters in exfoliated monolayers of WSe2 to plasmonic nanostructures. Gold nanorods of 20 nm-240 nm size, which are arranged in pitches of a few micrometers on a dielectric surface, act as seeds for the formation of quantum emitters in the atomically thin materials. We observe characteristic narrow-band emission signals from the monolayers, which correspond well with the positions of the metallic nanopillars with and without thin dielectric coating. Single photon emission from the emitters is confirmed by autocorrelation measurements, yielding g2(τ = 0) values as low as 0.17. Moreover, we observe a strong co-polarization of our single photon emitters with the frequency matched plasmonic resonances, as a consequence of light-matter coupling. Our work represents a significant step towards the scalable implementation of coupled quantum emitter-resonator systems for highly integrated quantum photonic and plasmonic applications.