A salicylidene derivative, N,N′-bis(salicylidene)-(2-(3′,4′-diaminophenyl)benzothiazole) (BTS), reactive in the Excited State Intramolecular Proton Transfer (ESIPT) process, was synthesized and its photophysical properties were evaluated, presenting an emission covering the entire range of the visible spectrum. Due to its broad emission band, BTS was successfully tested as an active layer in solution-processed organic light-emitting diodes with white-light emission. These diodes were prepared using solution-based protocols with the dye solubilized in a poly(9-vinylcarbazole) matrix. Different guest : host (polymer : BTS) molar ratios were used to optimize the diode performance. The optimized architecture rendered the best so far all-solution-processed ESIPT OLED with a luminance of 34 cd m−2 at 13.5 V with CIE coordinates 0.31, 0.40.
1 February 2005 in Journal of the Brazilian Chemical Society
Here we systematically studied the excitation and the fluorescence steady-state spectroscopy of poly(2-methoxy-5(2'-ethylhexyloxy)-1,4-phenylenevinylene) (MEH-PPV) with three molecular weights, Mn= 51 kg mol-1, Mn= 86 kg mol-1 and Mn= 125 kg mol-1, in two equally good solvents and several concentrations, from dilute solutions to solid-state films produced by casting. The appropriateness of the two solvents was established by comparing their solubility parameters and the solubility parameter of the MEH-PPV estimated using the Small, the Van Krevelen and the Hoy models. Thus, chloroform and toluene were chosen. Fluorescence spectra were recorded for solutions in several concentrations (10-8 mol L-1 to 10-4 mol L-1) and films produced by casting, showing that chloroform and toluene solvate the polymer chain differently. Diluted solutions (10-8 mol L-1) in chloroform exhibit broader fluorescence spectra. A red-shift of the fluorescence spectra was observed for concentrations higher than 10-6 mol L-1 that can be explained using Kasha's rule for the sandwich anti-parallel orientation of the transition moments of the two chromophores. The conformations observed in solutions are partially retained in the solid films in addition to the broader red-shift spectra attributed to aggregated forms of the macromolecular segments. Annealing of the polymer films at the glass transition temperature eliminates the more stressed conformations, erases the memory and leads to sharper fluorescence spectra.
A two‐step protocol allowing the C−H amination of cyclic ethers with iminoiodinanes, followed by the reduction of the resulting intermediate has been developed for the preparation of amino alcohols. The initial C−H functionalization is accelerated by visible light, improving the reactivity compared to the thermal process performed in the dark. The effect of different substituents on the photochemical reactivity of iminoiodinanes has been studied both experimentally and computationally. Photophysical measurements and DFT calculations were performed to better understand the observed reactivities and corroborate the proposed mechanistic proposal. magnified image