Tim Van Geel

Mr. Tim Van Geel

KU Leuven - Department of Chemical Engineering
orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 January 2021 in Membranes
Verified
Journal Article
Open access
PDF file
MBMokgadi Bopape
Mokgadi Bopape
TGTim Van Geel
Tim Van Geel
Abhishek DuttaAbhishek Dutta
Abhishek Dutta
Bart Van der BruggenBart Van der Bruggen
Bart Van der Bruggen
MOmaurice Onyango
maurice Onyango
The increasing adoption of ultra-low pressure (ULP) membrane systems for drinking water treatment in small rural communities is currently hindered by a limited number of studies on module design. Detailed knowledge on both intrinsic membrane transport properties and fluid hydrodynamics within the module is essential in understanding ULP performance prediction, mass transfer analysis for scaling-up between lab-scale and industrial scale research. In comparison to hollow fiber membranes, flat sheet membranes present certain advantages such as simple manufacture, sheet replacement for cleaning, moderate packing density and low to moderate energy usage. In the present case study, a numerical model using computational fluid dynamics (CFD) of a novel custom flat sheet membrane module has been designed in 3D to predict fluid flow conditions. The permeate flux through the membrane decreased with an increase in spacer curviness from 2.81 L/m2h for no (0%) curviness to 2.73 L/m2h for full (100%) curviness. A parametric analysis on configuration variables was carried out to determine the optimum design variables and no significant influence of spacer inflow or outflow thickness on the fluid flow were observed. The numerical model provides the necessary information on the role of geometrical and operating parameters for fabricating a module prototype where access to technical expertise is limited.

24 October 2017 in International Journal of Chemical Reactor Engineering
Verified
Journal Article
Closed access
PDF file
LSL. Shrutee
L. Shrutee
TGTim Van Geel
Tim Van Geel
Eldon  R. ReneEldon R. Rene
Eldon R. Rene
RBRaj Mohan Balakrishnan
Raj Mohan Balakrishnan
Abhishek DuttaAbhishek Dutta
Abhishek Dutta
A newly designed laboratory scale thin film reactor (TFR) was tested for the decarboxylation of anacardic acid in Cashew Nut Shell Liquid (CNSL) and to investigate the fluid flow behaviour under the influence of temperature since the fluid properties like viscosity and density have strong dependence on temperature. The CNSL containing 60–65 % anacardic acid was decarboxylated to produce cardanol and CO 2 at wall temperatures ranging between 393 K and 433 K, respectively. The characteristics of the CNSL, essentially a non-Newtonian fluid, was analysed at different temperatures and its rheological behaviour was studied using the well-known power law model. It was observed that CNSL follows a pseudoplastic behaviour and its viscosity, along with the liquid residence time, was found to decrease till 413 K, while a further increase in temperature resulted in product degradation due to charring, accompanied by an increase in viscosity and residence time. Using measured values for the viscosity, the film thickness was calculated for each wall temperature within the 393–433 K temperature range, showing an increase of the film thickness with temperature and viscosity. Computational Fluid Dynamics (CFD) studies were carried out for the first time for this reactor configuration, using the volume of fluid (VOF) model for the reactive flow. The results obtained from these simulations were in concurrence with the experimental outcomes: velocity profiles along the length of the reactor show its highest values at a wall temperature of 413 K, while lower velocity values were observed when the temperatures were lower or greater than 413 K.