Low-cost β-phase titanium alloys are starting to get a lot of attention and application in aircraft and mechanical engineering. They are effectively hardened by heat treatment and have a strength 10-20% higher than α-alloys. However, during TIG welding of low-cost titanium alloys, difficulties arise due to a change in the structure and the formation of metastable phases in the welded joint. The main criterion for choosing the modes of TIG welding is the optimal interval of the cooling rate in the weld, therefore it is advisable to compare different modes of TIG welding, including the use of pre-heating, by their thermal effect on the weld metal and the heat-affected zone.
In this article, structural features of Ti-TiB and (α+β) Ti alloys in the initial state, in the weld and in the heat-affected zone of electron beam welds were investigated. The influences of welding parameters, such as influence of the electron beam velocity, preheating of the welded alloys and the subsequent annealing of the welded joint on the its microstructure, and the mechanical strength and ductility of the critical elements of the joint were studied by scanning electron microscopy using microprobe Auger spectral and X-ray diffraction analysis and tensile tests. It has been shown that the conditions for rapid crystallization of the material from the melt of the weld contribute to refining of reinforcing fibers of TiB and its hardening in comparison with the starting material Ti-TiB. Besides that, influences of the preferential orientation of TiB reinforcing microfibers (along and across the welded butt joint) on the mechanical properties of the welded joint were investigated bz tensile testing. Using the methods of fractographic analysis, the effect of the boron-containing phase on the fracture character of Ti-TiB welded joints was established. It was shown that, along with the strengthening effect, TiB fibers cause embrittlement of the material.
Using mathematical modeling based on existing parametric regression equations the prediction of microstructure-phase transformations in heat affected zone( HAZ) metal of base material (steel 15Kh2NMFA) of WWER-1000 reactor vessel in arc cladding of protective anti-corrosion layer was carried out as well as performed comparative analysis of modeling results with obtained experimental data of dilatometric and metallographic analysis. The comparison of results ensures formation of bainite-martensite structure in HAZ metal of WWER-1000 reactor vessel, however a value of content of martensite in calculation and experimental determination is different on ~ 40…50%. To clarify the calculated results, a thermokinetic diagram of the decomposition of supercooled austenite was constructed for characteristic cooling rates (3; 4, and 5 °C/s) during the welding/surfacing thermal cycle. As a result, adequate parameters of the microstructure-phase composition in the HAZ of steel 15Kh2NMFA at corrosion-resistant cladding were obtained.