Viatcheslav Alekseevich Makkoev

Mr. Viatcheslav Alekseevich Makkoev

Mining University, St. Petersburg
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 January 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SKSergey Khokhlov
Sergey Khokhlov
ZAZaur Abiev
Zaur Abiev
VMViatcheslav Alekseevich Makkoev
Viatcheslav Alekseevich Makkoev
A review of the existing optoelectron monitoring devices revealed that the design of optoelectron detectors of the mine atmosphere does not sufficiently take into account the factor of external optical interference. This includes any extraneous source of thermal emission: a source of artificial lighting or enterprises. As a consequence, the optoelectron detectors -based safety systems currently installed at mining sites are not able to ensure properly the detection of the ignition source in the presence of optical interference. Thus, it is necessary to determine the working spectral wavelength ranges from methane and coal dust explosions. The article presents the results of experimental research devoted to the methane-air mixture and coal dust explosion spectral analysis by means of the photoelectric method. The ignition of a methane-air mixture of stoichiometric concentration (9.5%) and coal dust of size characterized by the dispersion of 63–94 microns and concentration of 200 g/m3 was carried out in a 20 L spherical chamber with an initial temperature in the setup of 18–22 °C at atmospheric pressure. Then, photometry of the explosion light flux was conducted on a photoelectric unit. Operating spectral wavelength ranges from methane and coal dust explosions were determined. For the methane-air mixture, it is advisable to use the spectral regions at the maximum emission of 390 and 900 nm. The spectrum section at the maximum emission of 620 nm was sufficient for dust-air mixture. It enabled us to select the wavelength ranges for automatic explosion suppression systems’ launching references. This will exclude false triggering of the explosion suppression system from other radiation sources. The research results will help to improve the decision-making credibility of the device in its direct design. The results will be used in further research to design noise-resistant optical flame detection sensors with a high response rate.

14 September 2023 in Mining Science and Technology (Russia)
Verified
Journal Article
Open access
PDF file
SKSergey Khokhlov
Sergey Khokhlov
YVYu. I. Vinogradov
Yu. I. Vinogradov
VMViatcheslav Alekseevich Makkoev
Viatcheslav Alekseevich Makkoev
ZAZ. A. Abiyev
Z. A. Abiyev
At many quarries for the extraction of building stone there is a problem of increased output of fines after all stages of crushing and grinding, which leads to a decrease in the economic performance of mining enterprises. The fine fraction is formed by the crushing / grinding of prefractured rock mass. Reducing the intensity and size of the prefracture zones will lead to a solution to the problem at hand. To determine the effect of explosive detonation properties on the degree of structural weakening of a rock mass, studies were conducted to measure the detonation velocity, stresses generated by a blast in the rock mass, as well as laboratory studies of microfracturing by X-ray computer microtomography. The size of the prefracture zones increases from 33 to 77 charge radii with increasing the detonation velocity from 2 to 5.2 km/s. The dependence of the number of microdefects (microfractures) generated by a blast on the velocity of explosive detonation takes the formof an exponent for the near zone and is linear for the distances far from the blast. According to the data of the experiments conducted at short distances (10R), the density of induced microfracturing N is within ≈5 thousand pcs/cm3, and with increasing the detonation velocity it increases to ≈13.8 thousand pcs/cm3. At medium (40R) and long (70R) distances, N increases from ≈750 to ≈2,400 pcs/cm3 and from 0 to ≈200 pcs/cm3, respectively. Using explosives with a reduced detonation velocity allows reducing the “surplus” impact on a rock mass and thus reducing the intensity of prefracture in the zone of controlled crushing during a blast. The study allowed obtaining quantitative parameters of the intensity and size of the prefracture zones, which compose the supplement to findings of historical studies on qualitative determination of prefracture.